充电装置

More suitable than DZ-50 relay. Additionally, If we keep the time constant term the same, it is more reliable to choose a bigger condenser match up with a smaller charge resister, also parallel two condenser to instead of a same capacity condenser to instead of a same capacity condenser is more reliable and easy for manufacture.

同时，认定在保持电容器一定充电时间常数的条件下，以选择电容量较大的电容器配较小的电阻值的充电电阻器，以及用两只电容器并联代替一只相同电容量的电容器时，使装置性能更加稳定，提高装置动作的可靠性，并便于生产。

It includes high power high voltage constant-current-charging system, capacitors bank, discharge control system, power supply of preignition for Xe-flashlamps, general control and diagnostic system. The power conditioning system drives flashlamps that pump the SSHCL. Flashlamps are driven by high voltage Silicon Controlled Rectifiers switched, resonant charged, discharge pulse forming network. The system uses microchip and digital circle which is based on CAN-bus for control and diagnostics. Energy diagnosis and thermal management are controlled by computers.

其中大功率高压恒流充电装置采用了L-C串联谐振电路，充电功率大，效率较高；储能装置采用了多节脉冲成形网络，可产生波形良好的强电流放电脉冲；放电控制装置采用高压大功率晶闸管，开关速度快，工作稳定；预燃与触发装置采用了开关电源电路，效率高、功耗小；总控与测量装置采用基于CAN总线的数字电路和单片机技术，控制冷却系统在激光器出光时对脉冲氙灯进行水冷，并对全系统进行控制和状态检测，同时具有过压、过流、过热等保护功能。

Charge and discharge operation test for battery and charge equipment.

蓄电池和充电装置的充放电试验。

Based on hardwired connection of specified intellectual charging device, the main task of it is to configurate system control software aiming at the requirement for charging characteristic curve of quasi constant voltage.

该设计的主要任务是以特定的智能充电装置的硬件电路为基础，针对准恒压式充电特性曲线的要求，为系统配置系统控制软件。

Presented in this paper is the process of design a fast pulse-charger for lead-acid battery. The charger is mainly designed for nonspillable lead-acid assembled batteries that used in automobiles, proposed working envirments are home and outdoors,main requirements are short charging time, high charging efficiency, smart control methods, reliable work,efficiently increase the life of batteries.

本文介绍了一个铅酸蓄电池脉冲快速充电装置的研制过程，这一装置以汽车用密封铅酸蓄电池作为主要充电对象，以家用及室外环境卫主要工作环境，主要设计要求为充电时间短，充电效率高，控制智能化，运转安全可靠，能够有效延长蓄电池寿命。

Check precharge: if low, recharge it or install a new one.

检查预充电装置：如果电压低的话，再冲电或安装一个新的

By enhancing the charging current,the pulsant problem for repetitive charging with constant current charging device was solved,and then,repetitive operation experiments were carried out.

在利用恒流充电装置充电的重频实验过程中，通过采用提高充电电流的方法，解决了发生器恒流充电时的充电脉动问题，进而开展了重复频率运行实验研究。

Focuses on the structure of the temporary emergency power distribution system, charge-discharge control method, charging circuit devices, the regional distribution system of the structure and power distribution board control circuitry.

着重介绍临时应急配电系统的结构、充放电控制方式、充电装置电路、区域配电系统的结构和配电板控制电路。

The safety belts are fit ted with force limiters and tensioners: these possess an electronically controlled pyrotechnic charge and, once triggered, the tensioner tightens seatbelts in a fraction of a second for greater restraint.

安全带具有强力抗拉性能，这些具有电控的火花充电装置，一旦被启动，张紧器马上在瞬间拉紧安全带。

That includes a stylish "Nah" box made of real china that actually contains a 1.5TB hard drive, a bamboo sheet that supposedly acts as a laptop cooling pad, a pair of vase-shaped speakers, various mice decorated with Chinese opera masks and, of course, no shortage of eye-catching USB drives.

充电座可以容纳的对象，从手机/相机/摄影机的锂电池、AA / AAA 充电电池、USB 装置（5V 输出）皆可以；不过因为没有内置的电池，所以一旦带到户外去，则要靠 AA / AAA 电池、锂电池当作电力来源；另外充电部份，最多可以一次帮五种装置/电池充电，也支持单键电池激活、快速充电等；跳转后有其它角度照片以及细节介绍。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。