充分考虑的

However, the present available methods of applying LSI to text classification are not satisfying, since they do not take full account of classification information.

但目前文本分类中使用LSI方法的效果并不理想，这是因为没有充分考虑分类信息。

In the traditional GSM network planning, the revised Hata model serves as the prototype, and the coefficient in the model formula is tuned according to the data obtained in the radio propagation feature test specific to local actual radio environment, so as to obtain the propagation model for practical prediction. A common digital map only contains the clutter information and the digital terrain model information. So the building designers cannot fully allow for the influence of radio propagation, and can only estimate the influence on the building roughly from a traditional perspective, e.g., consider the influence of different clutters through certain clutter offset.

在传统的GSM网络规划中，一般都以修正的Hata模型为原型，再利用规划软件通过导入针对当地的实际无线环境做无线传播特性测试所得的数据对模型公式中的系数进行修正而得到实际预测用的传播模型，一般使用的数字地图仅包括地物信息和高程信息，因此建筑物对无线传播的影响无法充分考虑，只能从统计意义上对建筑物的影响进行粗略的估计，如通过一定的地物偏移来考虑不同地物的影响。

On the basis of stability analysis, the author takes the K27+825 slope from the type of slope which has lest stability as an example. According to its basic feature, the design ueses the choosed best reinforce and control scheme: lattice beam, anchor wire, grouting and abstraction of water. In the course of design, the author takes into account not only reasonable optimize of whole control plan but also local measure such as whether the unstable block will shear from vnlnerable sections when control plan is laid out concretely, in order to reach the goal of reasonable design and effective control.

在稳定性分析的基础上，以边坡稳定性最差的一类中的K27+825边坡为例，结合其自身的特点，用优选出的加固防治方案：框架梁+锚索斗灌浆+排水进行设计，设计中既考虑总体防治方案的合理优化，又充分考虑了加固工程的具体布置时是否存在不稳定体从锚索或框架梁的薄弱部位剪出的可能性等一些细部措施，以达到合理设计，有效及经济治理的目的。

However, most of these investigations focused on the rotating beams or plates undergoing a prescribed large overall motion, where the effect of large overall motion of the reference frame on elastic deformation was considered but at the same time the beam's elastic deformation couldn't influence the large overall motion of the reference frame because the large overall motion is known a priori. In fact, this kind of problem on the dynamic stiffening is a structural dynamics problem in a non-inertial frame.

值得指出，上述这些研究工作都局限于大范围运动为已知情况下的非惯性系下柔性体的动力学性质，实质上是一个非惯性系下的结构动力学问题，只考虑了大范围运动对变形运动的影响，而没有充分考虑到大范围运动和变形运动之间的相互耦合作用，这种耦合作用是单向的。

Under the condition of the following factors concerning the optimization models:the investment cost, operating cost, unfair cost, payment evade cost, drivers' extra cost and environmental pollution cost, this paper raises the optimized models of multi-modes payment of toll collection system and its algorithm is proposed by SAGA hybrid optimization strategy, which can simultaneously optimize the following results: the optimum locations of toll stations, numbers of toll stations, the numbers of different tolling modes' tollgates of every toll station, ETC users' discount rate, and can estimate the installation rate of TAG of every toll station, the actual traffic flow capacity of different tollgate, can obtain the best toll collection system under the different simulated decision conditions.

本文充分考虑了驾驶员缴费技术选择与缴费车道选择的特性，提出了驾驶员缴费方式随机选择模型；在考虑了收费系统的投资成本、营运成本、不公平成本、漏收成本、驾驶员的额外成本和环境污染成本等因素的基础上，提出了多收费方式收费系统的优化模型，提出采用模拟退火遗传算法进行收费系统寻优的算法，可同时优化出一个收费系统的收费站位置与数量、不同收费站不同收费方式的收费车道数和ETC用户的折扣率等参数，可估算不同收费站TAG的安装率、不同收费车道实际使用量，可模拟不同决策情境下的最佳系统资源配置方案。

Based on the research, founded on existing production conditions, production capability and technical natures of KISC, especially its own development requirements, linked with the development trend of the iron and steel industry, fully considering the continuity of equipment upgrade and technical optimization of KISC, guided under principles of validity and benefit, the writer analyses and argues that in current conditions. KISC shall not adopt the hot metal pretreatment of desiliconization, dephosphorization and desulphurization, but the end-point converter process to improve the dephosphorization effect. But according to the development plan of KISC, with its scale development, upgradeof equipment and technical conditions and implementation of a plan to use high-phosphorus ironstone, its more suitable to adopt the converter-shaped pretreatment of desiliconization, dephosphorization and desulphurization.

在此研究基础上，立足昆钢当前生产条件、生产能力和工艺特点，特别是昆钢自身发展需要，结合钢铁工业发展趋势，充分考虑昆钢现行装备改造和工艺优化的延续性，以有效性和经济性原则为指导，分析讨论了在昆钢当前条件下，不适宜采用铁水&三脱&预处理工艺，而宜考虑采用转炉复吹技术以达到改善转炉吹炼过程脱磷效果的目的；而根据昆钢的发展规划，随着昆钢的规模化发展，生产装备及工艺条件的更新改善及利用高磷铁矿计划的实施，则适宜采用转炉型&三脱&预处理技术。

Finally, our analysis can be extended in several directions, they may be: to build a model to incorporate a learning process; to introduce asymmetric predecision information for connecting decision-making with low-lowered incentives; most importantly, to examine the relation between various managerial accounting issues and low-powered incentives.

关于前者，我们认为，在管理控制会计系统的设计中，必须考虑不同的信息对不同层级人员业绩计量与评价的影响；系统设计的核心是建立一个有效的业绩计量与评价制度；对员工的激励制度的设计必须充分考虑柔性信息的作用。

Under the condition of the following- factors concerning the optimization models:the investment cost, operating cost, unfair cost, payment evade cost, drivers" extra cost and environmental pollution cost.this paper raises the optimized models of multi-modes payment of teH collection system and its algorithm is proposed by SAGA -hybrid optimization strategy, which can simultaneously optimize the following results: the optimum locations of toll stations, numbers of toll stations, the numbers of different tolling, modes" tailgates of every toll station, ETC users discount rate.and can estimate the installation rate of TAG of every toll station.the actual traffic flow capadty of different toiigate, can obtain the best toll collection system under the different simulated decision conditions.

本文充分考虑了驾驶员缴费技术选择与缴费车道选择的特性，提出了驾驶员缴费方式随机选择模型；在考虑了收费系统的投资成本、营运成本、不公平成本、漏收成本、驾驶员的额外成本和环境污染成本等因素的基础上，提出了多收费方式收费系统的优化模型，提出采用模拟退火遗传算法进行收费系统寻优的算法，可同时优化出一个收费系统的收费站位置与数量、不同收费站不同收费方式的收费车道数和ETC用户的折扣率等参数，可估算不同收费站TAG的安装率、不同收费车道实际使用量，可模拟不同决策情境下的最佳系统资源配置方案。

The following areas: design of transmission of the table, mainly the use of ball screws; the overall structure of the design table to understand the strengths and weaknesses, take full account of the principal contradiction, merit-based selection; control system design, its applications become more familiar with the Stepper motor-driven feed location can be accurate but the drawback is the lack of output power, so consider the source of the hydraulic motor as the driving force and the stepper motor drive system into the compound, hydraulic feeding Although it is impossible to locate, but with high output power, the two complement each other, so that accurate feed motion can be stable.

有以下几个方面：工作台的传动机构设计，主要是滚珠丝杠的运用；工作台整体结构的设计，了解优缺点，充分考虑主要矛盾，择优选取；控制系统的设计，进一步熟悉其应用步进电机驱动进给可以进行准确的定位但有个缺点就是输出力不足，所以考虑将液压电机作为动力源与步进电机驱动进给系统复合，液压进给虽然无法进行定位，但具有高输出力，二者优势互补，使进给运动可以准确稳定的进行。

Not only the permeability of the rock salt body, the convergence of the cavity and the stability of jambs must be considered , but also the heterogeneity of the interlayers must be full considered, like the permeability of interlayers and layers , the difference of interlayers .

不仅要考虑岩盐矿体的渗透性、溶腔的蠕变收敛性、矿柱的稳定性外，还要充分考虑夹层的不均质性，如夹层及层理的渗透性，夹层和盐层蠕变的差异性。层状岩盐矿床中建造油气储库是一个相当复杂而且涉及很多学科的深部岩土工程。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了