偏置电路

Improvement in the voltage dividing precision of a Photomultiplier Tube biasing circuit.

生命科学仪器中光电倍增管偏置电路分压精度的提高。

If you jumper the 220 ohm, clip out the extra buffer transistor and connect the jfet signal coupling cap to the emitter of the input buffer, and change one resistor in the input buffer biasing circuit, you have a working TS9 in the TS10 case.

如果你跳了220欧姆，剪辑出额外的缓冲晶体管和连接场效应信号耦合帽来灌水的输入缓冲区改变一个电阻器的输入缓冲器偏置电路，你有一个工作ts9在ts10案件。

A bandgap reference circuitry is also designed for providing the biasing voltage and current.

文中也设计了为前置放大器提供偏置电压和偏置电流的带隙参考电路。

This paper aims to summarize experience in design of high power GaAs FET bias circuit used in solid-state transmitter.

本文主要总结了固态发射机设计中部分大功率G aA s FET偏置电路的设计经验。

aining at high impedance weak signal measurement,the relations among measuring precision,input impedance and input bias current,the guard technology is applied to design a measuring circuit with guard circuit,adding a guard potential to low-impedance nodes of circuit,the effect of leakage current is reduced.using spice simulation and validates that guard circuit can increase the input impedance of the system and lower the input bias current,the results show that the guard circuit provids a valuable solution for high accuracy measurement of the high impedance weak signal.

摘 要：针对高阻抗微弱信号测量问题，对测量精度与系统输入阻抗、输入偏置电流的关系进行分析，应用保护技术设计了带保护电路的测量电路，将电路中的低阻抗节点加上保护电势，减小漏电流的影响。通过pspice仿真分析，验证保护电路能提高测量系统的输入阻抗和降低输入偏置电流，结果表明保护电路技术能实现对高阻抗微弱信号的高精度测量。

A charge pump phase locked loop based on self biased technique is presented. In this technique, the operating bias levels are essentially established by the operating frequency of the voltage controlled oscillator, namely, all bias voltages and currents are determined by VCO controlling voltage. Thus, a fixed damping factor and a fixed ratio of the bandwidth to operating frequency are obtained, which are defined by th...

给出了基于自偏置技术的电荷泵锁相环电路，压控振荡器的工作频率动态地建立了电路内部所有的偏置电压和电流，从而实现了固定衰减因子，固定环路带宽与工作频率之比，这二者由电容的比率决定，极大地实现了电路设计的工艺无关性，同时也得到了小的相位抖动，最后，对这种锁相环的稳定性进行了一定的分析。

Point out among multistage amplifier reducing total noise directioning of coefficient , design one low in noise to setover the circuit, there is certain reference value to the design of the circuit amplifier.

指出在多级放大器中降低总噪声系数的方向，设计出了一种低噪声偏置电路，对电路放大器的设计有一定的参考价值。

The modulator (25) may also include an offset circuit (24) so that the modulated waveform includes a carrier frequency indicator.

所述调制器(25)还可以包括偏置电路(24)，使得调制波形包括载频指示符。

The effect of GaAs hbt Self-Heating effect on current mirror bias circuit for power amplifier was studied.

研究了GaAs HBT的自热效应对功率放大器镜像电流源偏置电路性能的影响。

A method to generate the bias voltage of infrared focal plane array is proposed,which use cascade weighted-capacitor network to scale charge on them.

以上研究证实了这种可集成在红外焦平面读出电路上的偏置电压产生电路是可行的，为下一步直接设计并制造包含偏置电压产生电路的焦平面读出电路芯片打下了坚实的基础。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。