偏振光

B In the case of randomly polarized incident light,ωLO increases with increasing angle of incidence.

c偏振光入射时，ωLO与入射角和入射光的偏振方向都有关系。

This ellipsometric method does not need to rotate the sample azimuthally. The physical parameters of sample are measured under various linear polarized lights through the numerical fitting to its theoretical model. In addition to the orientation of the first layer of nematic liquid crystal is considered, the total phase retardation and twist angle of twist Nematic Liquid Crystal cell are the physical parameters measured by this method.

本论文以椭圆偏极术为基础，在不需转动样本方位角的情况下，以不同偏振方向的线性偏振光入射样本，藉由出射光偏振态的变化，用数值方法拟合出样本矩阵模型参数；我们所量测的样本为扭转式液晶盒，其矩阵模型包含了三个参数：总相位延迟、扭转角及第一层液晶锚定方向。

Proposed a new method of determining the cell thickness and the twist angle of twisted nematic liquid crystal cells, a quarter-wave plate was inserted between the liquid crystal cell and the analyzer, a stepper motor rotated the Retarder by , and measured the light intensity of every modulated point, solved the stokes parameters of polarization light exiting from the liquid crystal cell using Fourier analysis method, thereby determining the cell thickness and the twist angle.

本文提出了一种测量扭曲向列相液晶盒盒厚与扭曲角的新方法，在液晶盒和检偏器之间放置四分之一波片，通过旋转此四分之一波片，测量各个调制点的光强，用傅里叶分析法计算线偏振光穿过液晶盒后的stokes矢量，从而求出液晶盒盒厚以及扭曲角。

In order to study the grating diffractive field's characteristics of the partially polarized and coherent beams, an analytic expression of polarization degree and angular correlation of partially ploarized and coherent beams through polarized gratings is derived based on the beam coherentce-polarization matrix approach of partially coherent beams.

为了研究部分偏振部分相干光光栅衍射场的衍射特性，利用部分偏振部分相干光的光束相干-偏振矩阵，推导出了部分偏振部分相干光通过任意偏振光栅后，衍射场的偏振度及场中衍射级次角相关的一般解析表达式。

Correlation between spin angular momentum s and background angular momentums of planets;2. In the paper the principle of optical rotation due to the transfer of spin angular momentum from light to particles was discussed by analyzing the interaction between the beam of light and birefringent crystal particles, and then an optical tweezers was formed on nanometer optical tweezers system with a linearly polarized light beam (He-Ne laser 633 nm, 10 mW).

从理论上分析了偏振光束与双折射晶体粒子的相互作用过程，讨论了由于光束自旋角动量向晶体粒子的传递所导致的光致旋转效应的原理，并在纳米光镊装置上利用线偏振He Ne激光器(633 nm，10 mW)形成了光镊光阱，利用1/4波片来改变光镊光束的偏振状态，在不同的椭圆偏振状态下实现了直径约为几微米的CaCO3 晶体微粒的捕获和光致转动。

The characteristics of different types OCS were analyzed and research into polarized light system of OCS using Jones matrix method, then the mathematics model of OCS was set up at last.Full-fiber OCS with effective band of 300 MHz and correlative circuit has been developed. Double constructer was adopted to enhance the sensitivity of system.

分析了不同类型光纤电流传感器的特点，利用琼斯矩阵法对光纤电流传感器的偏振光系统进行研究，给出了不同状态偏振光的归一化琼斯矢量，对本文涉及的光学器件推导了相应的Jones矩阵，最终建立了光纤电流传感器的数学模型。

The whole progress of mathematics derivation about it is proposed by analysing the modulation principle in the new spectropolarimeter. The simulation experiment on the demodulation progress is also achieved.

结合强度调制偏振光谱仪实现偏振光谱信息调制的机理，给出了采用傅里叶变换法实现偏振光谱信息解调过程的完整数学推导，并对解调过程进行了计算机仿真模拟。

It has been used to determine the real part and imaginary part of indices and thicknesses of thin layer synchronically.

光度法椭圆偏振光谱中椭圆旋向是不能直接确定的，从而不能确定椭偏参数Δ。这一定程度上有碍椭圆偏振光谱的应用。

In this paper, numerical calculations of magnetically induced twist effect in planar nematic liquid crystal are presented. The transmission of polarized light passing through magnetically induced twist distribution in planar nematic liquid crystal is calculated with "4-4" matrix algorithm. On the experimental side, the optical phase retardation method is used to detect the magnetically induced twist effect in planar nematic liquid crystal 5CB(4′-n-penty1-4-cyanobiphenyl) at 27℃.

对平行排列5CB(4′-n-penty1-4-cyanobinpheny1)丝状液晶在静磁场中扭曲变形做了严格的数值解，给出了严格分布情况；利用光学&4*4&矩阵算法，计算了线偏振光在严格分布下的传输情况；在实验方面，应用光学相位延迟法对平行排列5CB丝状液晶在静磁场中(温度27℃)线偏振光的通过情况进行了测量。

A manufacturing method for a polarized light film is following: processing the material film (1) of the polyvinyl alcohol resin through the expanding sink (3) as a procedure, processing the material in the dipping sink (4) as a procedure, the dyeing procedure for the dyeing process in the dyeing sink (5) and continuous procedure for the boric acid process in the boric acid sink (6); and processing the single shaft extending for the polarized light film (9) in one procedure at least of the dyeing sink (5) and the boric acid sink (6), the invention processes the polyvinyl alcohol resin film in the direction of the mechanism in the dipping sink (4), which reaches the extending multiplying power above 1.0 fold and below 1.05 folds.

偏振光薄膜的制造方法，使聚乙烯醇系树脂的原料薄膜(1)按顺序通过在膨润槽(3)中的膨润处理工序、在水浸渍槽(4)中的水浸渍处理工序、在染色槽(5)中的染色处理工序以及在硼酸槽(6)中的硼酸处理工序连续进行处理，并且在染色槽(5)以及硼酸槽(6)中的至少一个工序中进行单轴拉伸制造偏振光薄膜(9)时，在水浸渍槽(4)中相对于机械方向处理聚乙烯醇系树脂薄膜，使拉伸倍率达到1倍以上并且在1.05倍以下。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。