偏心轴

Unsteady flow of power-law fluid in eccentric annuli with the inner cyinder reciprocating axially is studied in this paper.

本文研究了幂律流体在内管做轴向往复运动的偏心环空中非定常流的流动规律。

V belt driving device developed is superior to flexible plate coupling and roller chain driving in VNH behavior, working endurance and axial and lateral offset tolerance.

所开发的三角带传动装置在振动噪声性能、作寿命和对轴向以及径向偏心的容忍度等方面都优于常用的柔性板式联轴器和高速滚子链传动装置。

Methods Acˉcording to the standard YY0290"Intraocular Lens",dioptric power,differentiate rate,axial displacement under presˉsure and optical eccentric distance of10types of intraocularlens were tested.

按照行业标准YY0290《人工晶体》规定的方法对国内外10种一件式或三件式人工晶体的屈光度、分辨率、压缩力下轴向移位和光学偏心等指标进行了测试。

In order to achieve the setting up angle should be monitored and debugged, a new approach is brought up. With the CCD receiving the focusing spot of parabolic mirror, while rotating the parabolic mirror, collecting the focusing spot location information, the eccentric angle between the optical axis and the structural central axis could be found. System principle and design have been studied.The experimental results meet the need to test and monitor to the setting up angle of the discal parabolic mirror.

为了实现对抛物面反射镜的装配角度进行监控和调试，提出了一种通过CCD接收回转抛物面镜的聚焦光斑，同时旋转抛物面镜，采集光斑重心位置信息，从而计算出光轴与结构中心轴之间的偏心角的实现方案，并从方案原理和设计上对其进行研究和实验，实验结果证明该系统能应用于对盘状抛物面反射镜装配角度的测试和监控。

InWürth's scheme, it is stays identical with the main axis, whereas inEvert's scheme, it is excentric from the common axis and rotates aroundit with an angular speed depending from the cogs'ratios.

在沃思的计划，这是保持一致的主轴，而在埃弗特的计划，这是偏心的共同轴和它周围旋转的角速度而从螺丝钉'的比率。

Based on rubbing model of a two-disk rotor-stator system with consideration of both rotor and stator dynamics,a numerical integration program is applied to numerical simulation and analysis of the nonlinear dynamics of this system,such as bifurcation,Poincare section map,trajectory of axes,phase trajectory,frequency spectrum diagram and time response.

基于一新型径向-轴向复合碰摩双盘转子-机匣力学模型，利用数值积分和Poincare映射方法，对转子-机匣系统由于径向-轴向碰摩故障导致的非线性动力学行为进行了数值仿真研究，给出了系统响应随转速和偏心量变化的分岔图和一些典型的Poincare截面图、相轨图、轴心轨迹、幅值谱图和时域响应等。

The eccentricity property measures the ratio of the minor axis to major axis of a bounding ellipse.

偏心财产措施的比值小轴的边界椭圆长轴。

The study found that it is not symmetrical convex parabolic type, left and right sides are not equal to the minimum axial velocity near the rod at the minimum axial velocity is small in the different condition from water to the various solution of HPAM chroma in the vertical eccentricity annuli with wide gap at pipe.

研究发现不同介质的流体在螺旋流条件下，其在偏心环空中的轴向速度分布不是左右对称的凸抛物线型，而是中间有凹陷且左右不对称的抛物线型，其轴向速度的极值点向模拟油管内壁偏移。

When two axes make the synchronized reverse rotation, on each instantaneous two axis eccentric qualities produce the centrifugal force of inertia, always mutually counterbalances along x-x force component, but always mutually superimposes along Y-Y force component, this has formed the sole this direction simple harmonics strength.

两轴作同步反向回转时，每一瞬时两轴上偏心质量所产生的离心惯性力，沿x-x方向的分力总是互相抵消，而沿Y-Y方向的分力总是相互叠加，这就形成了单一的该方向的简谐力。该力作用在筛箱上，驱动筛箱作轨迹为直线的往复振动。

In the oil hub with some wavy-coated layer of rubber, able to adapt to relatively large rotation axis eccentricity (usually only requires about 0.5mm) and axial deviation of the larger size range, there are better axial and the performance of radial buffer.

在油封内毂部份包覆一层波浪状橡胶，能适应旋转轴比较大的偏心度（通常只要求在0.5mm左右）和轴较大范围的尺寸偏差，有较佳的轴向及径向缓冲性能。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。