偏位的

This simulation achieves a stable configuration evolution from limiter to lower single-null divertor by using the vertical and horizontal displacement feedback and the current feedback.

数值放电模拟还利用基本的位移控制和等离子体电流控制系统实现了从孔栏位形到下单零偏滤器位形的稳定演变。

With lateral fluoroscopic guidance and the aid of preoperative planning, polyaxial screws with a diameter of 3.5 mm and a length of 26 mm were inserted in a trajectory of 10° medially in C1, and 20° medially and superiorly toward the superior-medial quadrant of the C2 lateral mass in C2. Then the 2 screws were fixed with rods.

在侧位透视导向和术前手术方案的帮助下，直径3.5mm、长26mm的多轴螺钉在C1向内偏10°，在C2侧块的内上象限向内、向上偏20°拧入钉道，再用2颗螺钉固定棒。

On the basis of separation density and probable error or imperfection, the quartile skewness and a parameter K that has the meaning of kurtosis are advanced. With above four characteristic values, a mathematical model called quartile model has been set up.

在分选密度、可能偏差或不完善度的基础上，引入了四分位偏度系数和类峰度系数K，直接用上述四参数构造了一个分配曲线数学模型-四分位模型。

Their were 1 transversion(site 100) and 1 coexistent site of transition and transversion(site 42),the others were all transition, which showed high ratio of transition to transversion.

所有多态位点中出现1处颠换(100位)，1处转换与颠换共存(42位)，其余均为转换，具有较高的转换偏倚。

The research indicated that, the structure inside the pure C8TES SAM was indeed loose and unassembled completely, the molecule density inside the SAM was very low, which would result in an ultra-low surface contact angle, only 20～21°, on the C8TES SAM surface.

我们的研究表明，由于C8TES分子头部三个乙氧基形成的空间(来源：b5e5ABe3C论文网www.abclunwen.com)位阻的影响，C8TESSAM的内部处于一种不完全组装的松散状态，所形成的自组装单分子膜内分子密度偏低，造成C8TES SAM的表面接触角偏低，只有20～21°。

Combined with investigation results of the furnace body erosion before relining, this paper analyzes the cause of production problems appeared in the first campaign life of the blast furnaces. Because of the existence of design shortcomings in large cooling block and bosh cooling stave, it resulted in poor furnace performance, such as stronger peripheral gas flow and irregular profile. The quick rise of bottom temperature of No.7 BF was caused by the penetration of molten iron into the joint of bottom carbon block, wheresas the quick rise of bottom temperature of No.6 BF was due to gas fleeing through the furnace bottom.

结合大修前炉体破损情况，对这两座高炉第一代炉役生产中出现的问题进行了调查研究。7号高炉大型模块和炉腰冷却壁设计上存在不足，引起高炉边缘气流发展，操作炉型不合理，炉况不顺；7号高炉炉底温度偏高是炉底炭砖渗铁造成的，6号高炉炉底温度偏高是炉底串煤气所致；7号高炉铁口失常的主要原因是铁口组合砖损坏严重和该部位炉壳开裂。

Methods Ninety-one coronal CT scans of chronic sinusitis were analysed with mutimedia software developed by the authors. Sinus CT images were scanned into multimedia computer and the subtle anatomic structures such as pneumatization of the middle turbinate, agger nasi cell, Haller's cell, septal deformity , maxillary sinus hypoplasia , abnormality of uncinate process and ethmoid bulla and so on were measured.

用自行开发的计算机图像分析系统定量分析91例慢性鼻窦炎患者的冠状位鼻窦CT，观测指标包括：骨性解剖结构变异(包括中鼻甲气化、反常曲线中鼻甲、Haller气房、鼻中隔偏曲、上颌窦发育不良、鼻丘气房、钩突气化)、筛漏斗、钩突角度、筛泡等，测量相应结构的冠状位截面积、角度、长度。

If these abnormities were laid according as frequency among 2-6 months,reflex abnormities are knee tendon reflex, palmar grasp reflex,...

其中 2— 6个月组，4个方面的异常项目按出现多少分别排列为：①反射异常：膝反射、手持握反射、巴氏征、非对称性颈肢反射、踝阵挛、坐位平衡反应、踏步反射、交叉伸展反射、紧张性迷路反射、躯干侧弯反射、拥抱反射；②姿势异常：仰卧翻成侧卧头后仰≥ 15°、立位悬垂、平卧颈后空隙≥1cm、俯卧悬垂、侧位悬垂、拉起、紧张性头偏斜、自发姿势异常；③肌张力异常：足背屈角、上肢围颈、手握拳、扶立足跟抬起≥ 3 0°、拇指交叉达掌心、窝角、内收角、跟耳角；④其他异常：头围≤ x -2s、斜视、主动运动减少/异常、听觉异常、视觉异常、眼颤、癫痫。

7 The production line put into operation early days of back-end electrostatic precipitator emissions standard will be replaced by silicon high-voltage power supply source of cross-flow, but the effect of the use of the electrostatic precipitator has been unsatisfactory, the original equipment set up ten-speed manual adjustment Stalls in the campaign, the number of open stalls in a process can only be adjusted under the best of the stalls, not with the technology changes and regulation at any time, the impact of collecting results in the actual operation can only be the largest transfer Six to file.

3.3.7该生产线投产初期，窑尾电收尘器排放超标，将可控硅高压电源更换为横流源供电，但电收尘器的使用效果一直不理想，原设备设置十档手动调节档位，在运动时，档位开的数量只能调整在某一工艺状态下的最佳档位，不能随工艺状况的变化而随时调节，影响收尘效果，在实际运行中最大只能调至六档。根据电场面积计算，高压整流柜额定电流应选取1600mA，而实际为1500mA，选用型号偏小。

Methods: The terminal position of the muscular contraction path and centric relation position with different vertical dimension were recorded for ten edentulous patients with gothic arch.

采用哥特式弓描记装置测量10例无偏侧咀嚼的牙列缺失患者不同垂直距离下肌力闭合道终点位与正中关系位在平面上的位置关系。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新