倾角

The design method is described, and the calculation results are presented under the standard air conditioning condition. The working process of the two-stage expander is discussed, and the difference between the two-stage expander and the conventional one is stated. In addition, the influence of the dip angle on the expansion chamber volume is analyzed. The results show that the dip angle has little effect on the expansion chamber volume and it is suggested that the effect may be neglected in the expander design.

介绍了该膨胀机的设计方法，给出了标准空调工况下的计算结果，详细讨论了两级旋叶式膨胀机的工作过程，并对两级膨胀机与传统旋叶式膨胀机的区别进行了论述，最后分析了滑片倾角对工作腔基元容积的影响，结果显示，滑片倾角对工作腔基元容积的影响很小，在膨胀机的设计过程中忽略滑片倾角的影响是合理可行的。

It is obtained that the heat transfer performance is the best for the louver angle at 24°, and the pressure drop increases with the increase of the louver angle.

对4种百叶窗倾角(15°，20°，24°，28°)进行了数值模拟，比较发现24°倾角的百叶窗翅片的传热性能最好，压降随着倾角的增大而增大。

Using inclination vector as a non-singular orbital element, engineering oriented mathematical models for inclination control of geosta- tionary orbit are established,and unified optimal strategies for inclination control both in north-south station aquisition and north-south station keeping derived.

本文以倾角矢量作为无奇点轨道要素，建立静止卫星轨道倾角控制的工程实用数学模型，进而导出南北定点捕获和南北位置保持两种情况下统一的倾角控制燃料最优策略。

The influence of the steering wheel alignment parameters (consisting of caster, king-pin inclination, camber and toe-in) and tyre meandering frequency on the vehicle shimmy is systematically studied. Some new conclusions having practical value are obtained and proved by the road test.

利用所建的汽车摆振数学模型，系统地研究了转向轮定位参数（包括主肖后倾角，主肖内倾角，车轮外倾角和车轮前平角）和轮胎蛇形运动频率对汽车摆振的影响规律，获得了许多新的具有实用价值的结论，并得到了道路试验结果的证实。

The results show that the length of the soil hole increases with the increment of the horizontal and vertical angles o f the declined spade soil opener and the width of the soil hole increases with the increment of the horizontal angle.

试验结果表明，穴孔长度随着水平倾角和垂直倾角的增加而增加，穴孔宽度随着水平倾角的增加而变宽。

Finally, we adopt the fault smoothing constraint and dipping angles obtained from previous two steps and invert for the coseismic rupture distribution.

建模过程经历三个步骤：（1）采用直立断层模型反演，根据解的分辨率和拟合差的折中曲线得到最优平滑约束；（2）改变断层倾角，找到使得观测数据和正演计算拟合最好的断层倾角；（3）根据前面两步得到的最优平滑约束和断层倾角求得地震同震破裂分布。

But the influence of interface dip is relatively small and can be omitted. A considerable declinational departure of the ellipse's center from the reflection point may be caused by the reflector's dip, and the deflection grows rapidly with the dip increasing.

界面倾角对椭圆大小和形状的影响相对微小可以忽略不计，但界面倾角却是影响椭圆中心位置偏离反射点程度的主要因素，倾角越大，椭圆中心在反射点下倾方向上偏离得越远。

The canopy structure and leaf morphological characters of 4 sugarcane genotypes at different leaf layers on seedling were studied by using CI-100 plant canopy instrument and CI-203 area meter instrument. The results showed the leaf morphological parameters, canopy structure and radiation transmission at different leaf layers were notably different among different genotypes. The variation of Ila, Amfi, Dl at different leaf layers were mainly caused by the leaf width at relevant position. The variation of K at different leaf layers was related to Amfi and Dl. The variation of Td（transm. coef. for diffuse penetration）had significant correlations with Ila, Amfi and Dl. The variation of Tr（transm. coef. for radiation penetration）had significant correlations with Dl, leaf width and the ratio of leaf length to width. The variation of Par had significant correlations with Ila, leaf area, leaf width and the ratio of leaf length to width.

摘要利用CI-100数字植物冠层分析仪和CI-203叶面积分析仪测定了4个甘蔗品种不同叶位层的冠层参数和相应叶位叶片的形态特征，结果表明：不同基因型不同叶位层间叶片形态、冠层空间结构和冠层辐射特征存在显著差异，不同叶位层叶面积指数、叶簇倾角和叶分布的变化主要由冠层内不同叶位叶片叶宽的变化引起，而不同叶位层消光系数的变化主要与叶簇倾角和叶分布有关；散射光透过系数的变化主要与叶面积指数、叶簇倾角和叶分布有关，直射光透过系数的变化主要与叶分布、叶宽、长宽比有关，光合有效辐射的变化与叶面积指数、叶面积、叶宽、长宽比有关。

In this paper, 4-4-(trifluoromethoxy benzoyl cyclohexyl-3, 5-diaminobenzoate with a large branch chain, pyromellitic dianhydride and 4-(4-aminobenzyl) benzenamine were used to synthesize polyimides. The effect of monomer charge order on pretilt angle was investigated for the first time when PIs were used as LC alignment layer, and the effect of diamine mole ratio on pretilt angle was studied. The thermal stability of the pretilt angle was discussed.

文章用均苯四酸二酐、4，4'-二胺基二苯甲烷和具有较大支链的4-（4-苯甲酰基）环己基－3，5-二胺基苯甲酸酯等单体制备聚酰亚胺，首次研究了单体加料顺序对液晶预倾角的影响，同时也研究了二胺配比对液晶预倾角的影响问题，并探讨了预倾角的热稳定性等问题。

So far, only a few reports can be seen which indicate cervical biomechanical change caused by ADR, and no experiment and clinical study have been undertaken on the affects versus ACF on inferior segment zygapophyseal joints.

第一章 成人下颈椎椎体与关节突关节倾角X线测量及其意义目的：测量成人下颈椎(C_3～C_7)关节突关节的倾角，为影像学提供参考数据，探讨年龄因素对倾角的影响。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。