英语人>网络例句>倾斜角 相关的搜索结果
网络例句

倾斜角

与 倾斜角 相关的网络例句 [注:此内容来源于网络,仅供参考]

Lateral roentgenograms of the lumbar spine and the hip joint were obtained in the upright position to determine pelvic inclination, sacral slope angle, lumbar lordotic angle (L1-L5), disc angle of L5/S1, and pelvic angle (by Jackson's method).

所有病例都拍摄了竖立位腰椎和髋关节侧位片,从而确定他们的骨盆倾斜度、骶骨倾斜角、腰椎前凸角(L1-L5)、L5/S1椎间盘成角和盆腔角。

Results: We obtained high-quality MRI images.Pelvis, bladder, urethra, levator, and obturator muscle can be clearly showed.We Can observe clearly the levatormorphology of the various components.The end of the iliac muscle was inverted "eight"-shaped;Suprapubic vaginal muscle was "V"-shaped; Puborectalis was "U"–shaped. Funneling at the Bladder Neck and shorter urethra were found in two patients with SUI.

在虚拟系统三维空间中测量SUI组静息和应力状态下膀胱尿道后角分别为121.47±6.15°和141.27±7.71°均大于对照组的101.49±4.73°和113.38±2.69°差异均有统计学意义﹙P.05﹚,SUI组静息和应力状态下尿道倾斜角分别为23.33±4.68°和36.27±4.71°均大于对照组的9.29±2.93°和21.96±3.81°差异均有统计学意义﹙P.05﹚,SUI组膀胱颈移动度为15.67±2.36大于对照组的7.87±1.33差异有统计学意义。

From 30 degrees to preference, flat, from 0 degrees to preference. All independent variables are within-subject variables. Electromyograph and dynamic single/two-axis goniometers were utilized to evaluate the associated muscular loads and postural settings for the upper extremity.

第二阶段实验独立变数包括:桌面倾斜角起始设定(分别为由30度往下调,水平0度未调整与由0度往上调),而评估之应变数为颈部与上肢姿势参数及以肌电仪量测受试者之上肢肌肉负荷。

To certain viscosity experimental medium, the discharge coefficient of the great pitch pump is higher than the conventional pump, along with the obliquity of the pump barrel is increase(that is from the level to the vertical lay),the discharge coefficient of the well pump is increase, looked from the test result, the discharge coefficient of the great pitch pump is higher than the conventional pump, on this condition that low frequency of stroke, and it is more obvious on the small oblique angle condition.

对一定粘度的试验介质,大斜度抽油泵的流量系数高于常规抽油泵,随泵筒倾角的增加(即从水平放置到垂直放置),抽油泵流量系数增大,从试验结果看,低冲次条件下,大斜度抽油泵流量系数高于常规泵,且小倾斜角状态较明显。

In the conclusion, we will change the latitude, oblique angle of sun board and number of days of the formulas to observe the variation of radiation quantity, absorption ratio, current, voltage, resistance and power, and the compare of the three calculation modes.

在结论中将利用程式可改变纬度、太阳板倾斜角和天数来观察辐射量、吸收比、电流、电压、电阻和功率的的变化、三种模式算法之相互比较。

The basic flow patterns in the corrugated channel of plate heat exchangers is described by experimental data available. The corrugated inclination angle is of principal influence on performances of plate heat exchangers.

根据已有实验数据,阐明了板式换热器人字波纹通道中的基本流动模式以及波纹倾斜角对板式换热器性能的重要影响。

The basic flow patterns in the corrugated channel of plate heat exchangers is described by experimental data available. The corrugated inclination angle is of principal influence on performances of plate heat exchangers.

摘 要:根据已有实验数据,阐明了板式换热器人字波纹通道中的基本流动模式以及波纹倾斜角对板式换热器性能的重要影响。

According to the experimental results, the back rake angle of single crystal diamond tool is the most important factor to the form accuracy of aspherical micro lens array.

从本论文中的实验结果得知,影响非球面微透镜阵列形状精度的最主要因素是刀具的面倾斜角的角度大小。

Their influence on the chaotic motion region is also examined. With temperature rising the changes of modul of elasticity and coefficient of thermal expansion of plate will not effect chaotic motion region.

结果表明:随温度、长宽比的增加,混沌运动区域变大,随着倾斜角及板厚的增加,混沌运动区域将变小,且温度升高引起板的弹性模量及热膨胀系数的改变对混沌运动区域几乎没有什么影响

Decided Friction Stir Processing processes parameters, included the shape of welding head, specification of aluminum alloy plate material, feed rate, inclination angle, rotational speed, and weld speed.

决定搅拌摩擦制程各参数,包括搅拌头形状、板材规格、进刀量、倾斜角、转速及焊速。

第5/7页 首页 < 1 2 3 4 5 6 7 > 尾页
推荐网络例句

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸,那乌黑、忧郁的眼睛,她便会相信,他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失

But because of its youthful corporate culture—most people are hustled out of the door in their mid-40s—it had no one to send.

但是因为该公司年轻的企业文化——大多数员工在40来岁的时候都被请出公司——一时间没有好的人选。