倒角

Flange hole inside the tube must be chamfered hole welding.

法兰内孔管件内孔必须倒角焊接。

To eliminate burrs and flashes in order to prevent human hands from cutting and to facilitate mounting, the ends of both the shaft and the hole usually need to be chamfered.

为了去除零件的毛刺、锐边，以防止划伤人手和便于装配，在轴和孔的端部通常需加工出倒角。

Therefore, it is suggested through present research that the chamfered testpiece is used and larger initial width of cut is adopted during chatter test in order that the experimental results would indicate the real dynamic behavior of machining system.

实验证明了初始切宽和试件倒角对稳定性阈限的影响，揭示出至今仍为国际上普遍采用的变切宽切削法的重要误差，为提高测量数据的一致性和完善机床动特性试验规范提供了理论和事实依据。

The chamfered edge at the peak of its slopping ceiling eliminating edges on its surface, creating a visually larger and brighter space.

在其得过且过上限消除其表面的边缘倒角边高峰，创造了亮度更高的视觉空间。

Satisfies wide range of positioning,pivot and alignment application, chamfered and makes mating hole location easily.

应用于安装板有位置排列、轴向定位要求的场合，尾部大倒角使安装更快捷。

Of metal, non-metallic, deburring, edge, chamfered, polished bright, and strengthen the workpiece surface during the electroplating, chemical surface treatment prior to finishing treatment.

对金属，非金属，去毛刺，飞边，倒角，抛光亮，强化工件表面在电镀，化学处理前的表面光整处理。

High cutting and chamfering quality,...

切割、倒角质量好、效率高； 2。

An effectual measuring method applied to inspect the chamfering depth of a small hole in production line is introduced.

介绍了一种高效测量方法，适用于小孔倒角深度的工序间快速检测。

This Belt is used to transport the slugs to the belt of Piece-Cutting Machine with Chamfering Device.

主要作用是将双泥条垂直切条机切割后的泥条，输送到带倒角切坯机的输送皮带上。

By chamfering the thicker member before welding on one side only

在焊接前？？？厚件的一？？行倒角

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。