侧部

The three groups were loaded and analyzed under the same loading according to the mean value of the bite force of incisors. RESULTS:(1)The maximum stress of dentin in group A was twice higher than that in group B. The maximum primary stress, minimum primary stress and maximum shear stress of group A were respectively 236.35, 228.83 and 218.05 percent of those in group B. The difference of maximum stress values of group B and group C was neglectable.(2) The maximum stress distribution of dentin in group A and group B was quite different (the stress was concentrated in labial and lingual side of the cervical dentin in group A, otherwise in group B it was concentrated in the area around the alveolar and the labial and lingual side of the dentin which was opposite to the tip of the cast metal post and core). The maximum stress distribution of dentin in group A and group B was almost the same.

结果：(1)从牙本质的应力大小来看，A组中牙本质最大应力值比B组中牙本质最大应力值增大了1倍以上（最大主应力、最小主应力和最大剪切应力A组分别是B组的236.35%、228.83%和218.05%），而B组与C组的牙本质最大应力值相差极小；(2)从牙本质的应力分布位置来看，A组与B组的牙本质最大应力分布位置相差甚远（A组主要集中在牙颈部唇舌侧肩台部的牙本质上，B组主要集中于牙槽嵴顶附近及铸造桩核尾端相对应的唇舌侧的牙本质上），而B组与C组的牙本质最大应力分布几乎在同一位置。

Methods Twenty-two pieces of temporal bone were taken for this study. The mastoid cavity was opened, scutum removed,"bridge" broken down, posterior wall of external auditory canal abraded and the related anatomic structures were fully exposed. The distance between the origin of facial nerve canal and the anterior border of round window （ OOFNC-ABORW ）, between the highest point of the facial nerve canal and the bottom of posterior mastoid sinus,and between the stapes head and round window niche was measured under operating microscope.

方法取成人颞骨22侧（左右各11侧），用耳科钻磨开乳突腔，去上鼓室盾板、断"桥"，磨低骨性外耳道后壁，充分暴露相关结构，在手术显微镜下测量面神经管垂直段起始部前缘至圆窗龛前缘的距离、面神经管最高点与后鼓室底壁之间的距离、锥隆起的高度（即锥隆起基底到锥隆起顶端的距离）、镫骨头至圆窗龛前缘的距离。

Pem gene is expressed in a time and stage specific manner. Pem transcripts are detectable as early as day 6 in mouse embryonic development, and are abundant in day 7 and 8, but decrease precipitously thereafter. Although Pem transcripts are not detectable in most of adult tissues, they are present in reproductive system. Furthermore, Pem has also shown to be specifically expressed in the proximal cauda and distal corpus regions of the epididymis, the regions where spermatozoa gain forward motility and fertilization competence.

Pem基因的表达具有明显的时间和空间特异性：在鼠胚发育的第6天，即可检测到Pem转录本的表达；第7-8天，Pem表达量达到最高，随后迅速减少；Pem基因在成年组织中一般不表达，但可在生殖组织表达；另外，Pem特异地在附睾近侧尾部和远侧的体部中表达，此处是精子获得运动性和受精能力的地方。

The fibres of the corticospinal tract, which run craniocaudally in the dorsal pons, the pontine tegmentum, and the superior cerebellar peduncles ventrally, were all preserved, this differential involvement therefore being responsible for the cruciform appearance on MRI.

译：脑桥神经元和横桥纤维严重减少，造成脑桥基底部和小脑中脚的苍白和萎缩。上下走行于脑桥背侧的皮质脊髓束、脑桥背盖部、腹前侧的小脑上脚/结合臂均未受累。这种差异性受累是MRI上出现十字征的原因。

HRP was coupled with the fluorochrome FITC and encapsulated with liposome . pEGFP-N1 plasmid (expressing green fluorescent protein) with encapsulation in commercially available liposome was prepared. The eyes were enucleated 1, 4 and 8 weeks after zonule rupture and anterior segments comprising lenses were incubated in medium containing one of these components. Cryo-sections were made and translocation of fluorescent macromolecule from the medium into the lens and green fluorescent protein expression in the epithelium were observed by fluorescent microscopy.

制备FITC标记的HRP脂质体；制备pEGFP-N1质粒（表达绿色荧光蛋白的质粒），并用脂质体包裹；豚鼠悬韧带部分离断后1周、4周、8周取含晶状体的眼前段标本分别在含有FITC-HRP复合物、pEGFP-N1质粒的培养基中孵育，冰冻切片，荧光显微镜观察FITC-HRP复合物进入晶状体和pEGFP-N1质粒在晶状体内表达的情况，比较悬韧带离断侧与非离断侧的差异。3。

Inflorescences lateral or terminal on old or new growth; male and female inflorescences separate: male spikes in clusters of 3, lateral at base of new growth or rarely on old growth, pendulous; female spike terminal on new growth, erect. Flowers anemophilous.

在老的或幼枝上的花序侧生或顶生；雄和雌的花序分开：在3的簇生里的雄性穗状花序，在老枝上的幼枝或很少的侧的在基部，下垂；在幼枝，直立上顶生的雌性穗状花序。

Supraperiosteal dissection was performed extending from the glabella anteriorly to the posterior lip of the foramen magnum posteriorly. craniotomies were performed to separate the bifrontal and biparietal-occipital frangments.

患儿采取改良的俯卧位，通过头皮冠状切口显露从眉间至枕骨大孔后唇的整个颅盖，切开颅骨分离双侧额骨和双侧顶-枕部骨块。

The abdominal wall in the left lower quadrant, 2 finger breadths (3 cm) cephalad and 2 finger breadths medial to the anterior superior iliac spine, has been shown to be thinner and with a larger pool of fluid than the midline and is usually a good choice for needle insertion for performance of a therapeutic paracentesis.27 The right lower quadrant may be a suboptimal choice in the setting of a dilated cecum or an appendectomy scar.

在过去，常常将腹部正中线耻骨与肚脐中间定为穿刺点，现在，由于腹腔穿刺引流大量液体以及腹中部脂肪厚度增加，左下腹成为腹腔穿刺部位（表1），在左下腹部中线至髂前上棘连线上2指宽（3cm）与距髂前上棘2指宽，已经显示较中部脂肪少及腹水较多是治疗性腹腔穿刺好的首选部位27，在盲肠有扩张或阑尾切除术后瘢痕时右下腹是次选的穿刺部位，应避开腹壁下动脉，这些血管走行在耻骨与髂前上棘之间的中线然后在腹直肌中向上行走，，腹壁可见的侧支循环亦应该避开，腹腔镜检查发现侧支循环可出现在中线并且在腹腔穿刺时有导致血管破裂的风险28。

The increase in either OCDAS or AAS scores associated with provocation was statistically significant (P＜0.01). A statistically significant increase (P＜0.05) in rCBV during the OCD symptomatic state versus the control state was found in the right inferiofrontal cortex, postcentral cortex, angular cortex, and bilateral orbitofrontal cortices, cuneus cortices, heads of caudate neucli, thalami and amygdalae.

结果 静息期和诱发期的强迫症状评分结果分别是1.00±0.33和6.65±0.71，有显著性差异（P＜0.01）；静息期和诱发期的焦虑症状评分结果分别是1.20±0.42和2.75±0.42，也有显著性差异（P＜0.01）；与静息期相比，右侧额下回、中央后回、角回、双侧眶额部、楔叶皮质及双侧尾状核头、丘脑、杏仁核rCBV在症状诱发期显著增加（P＜0.05）。

However among the experimental groups no positive labeling was found in 2h group, positive cells were labeled in SFO and choroids plexus of lateral ventricles in 6h group, especially in ependymal cells of body part of SFO, but no positive cells were found in the other regions.

观察实验组可见：2小时组未发现阳性结果。6小时组在SFO与侧脑室脉络丛，发现阳性细胞，在SFO体部的室管膜细胞阳性较多；其它部位未见阳性细胞。8小时与16小时组在海马、下丘脑、背侧丘脑、脉络丛等多处均有阳性细胞。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。