侧板

PRL-LIR positive perikarya were mainly seen in nucleus suprachiasmaticus, nucleus paraventricularis preopticus, nucleus supraopticus, nucleus hypothalamus paraventricularis, nucleus periventricularis arcuatus and nucleus accumbens. PRL-LIR fibers and their terminals were detected in paleostriatum and median eminence.

结果，PRL阳性胞体主要分布在视交叉上核、视前室旁核、视上核、下丘脑室旁核、弓状核和伏隔核，旧纹状体、正中隆起存在大量阳性纤维末梢，在侧脑室腹侧的室管膜和脑基底神经胶质板上也存在PRL阳性神经元。

Method］twenty six wistar rats were divided into two groups, with 13 in each group, peroneal nerve was transacted on the right side of all the animals, in one group, the proximal end of peroneal nerve was turned back and ligated, the distal end was sutured to the side of tibial nerve with perineurial window, in another group,both ends of the transacted peroneal nerve were turned back and ligated as contrast, no operation was done on the left side.

方法］wistar大白鼠26只，随机分实验组和对照组，每组13只，实验组右侧腓总神经切断后，近端反转结扎，远端与胫神经外膜开窗处行端侧吻合，对照组右侧腓总神经切断后，两端均反转结扎，两组动物左侧作正常对照，不作处理。术后3个月，行双侧腓总神经、胫前肌组织学检查，胫前肌湿重测定，运动终板检查。

3 patients were all treated with nuss procedure, which were performed under general anesthesia with endotracheal intubation. a transverse incision was made in each lateral chest wall and a steel bar was passed under the sternum from the right thoracic cavity under thoracoscope, then the bar was turned over to raise the sternum to the normal position.

3例患儿均应用nuss手术治疗，即在胸腔镜下将塑形矫正板由一侧胸腔经胸骨后心包裸区穿至对侧胸腔，翻转后固定于对侧胸骨。

Obvious cartilage and island-distributed immature bone formation in implants of the experiment side were observed at 2 weeks after operation, and massive mature bone observed at 4 weeks. Newly formed bone had fused and formed mature lamellar bone and trabecularism. No bone formation was observed in the control side of the mice.

实验侧术后2周出现大量软骨组织和呈岛状散在分布的骨组织，术后4周可见大量成骨组织，新生骨相互融合生长并形成较为成熟的板层骨和骨小梁结构；对照侧未见骨组织形成。

Although these injuries may consist of a variety of posterior element pathologies spanning the spectrum from fracture separation of the lateral mass 25,26 (with translation or rotation since an undisplaced lateral mass fracture falls within the compression morphology) through completely dislocated or locked facets.

尽管这种损伤可以包含多种后方结构的病理改变，包括从侧块的骨折分离到完全的脱位或关节交锁，各种程度的棘突、椎板、侧块等后方结构的骨折伴随椎体的爆裂、矢状面和/或冠状面的骨折，如所谓的泪滴状骨折。所有这些损伤存在于1个椎体相对于邻近椎体的平移。

It also showed that the main influencing parameters of the uniformity of LGP front, middle and rear regions are the angle and interspacing of incidence side V-Cut.

导光板均齐度最主要影响参数前区域为底部V-Cut角度、其次为底部V-Cut间隔；中区域为底部V-Cut间隔、其次为入光侧V-Cut角度；后区域为入光侧V-Cut间隔、其次为底部V-Cut间隔。

Methods Three kind of palatal connecter palatal bar, anterior-posterior-lateral palatal bar, palatal plate were used to retain RPDs. Then food chip was masticated between the upper and lower dentitions on left side.

运用上领双侧游离缺失模型，制作三种腭部大连接体，分别为中央开&天窗&的腭板、前后侧腭杆和腭杆的可摘局部义齿。

Drills in the median line with the small crack marks the good median line position, The horizontal osteotomy is then completed with a saw, and removal of midline wedge of bone from a lingual approach.

在中线用小裂钻标记好中线位置，在左右下牙6到6之间截骨，截骨完成后，再于颏部中央截取底边在舌侧的等腰三角形骨块，将颏部骨块内旋，在唇侧表面以微型钛板固定。

In predicting tripping stress of stiffeners in stiffened panels it is necessary to calculate the local buckling strength of plate.

本文研究分析船体骨材的侧倾屈曲问题，分析中考虑了板屈曲对骨材侧倾的影响。

According to the trimming-mechanism and the trimming-deformation process of the strip ,the trimming force and the driving power of rotary trimming shears are analyzed and calculated.

从剪切机理、板带的剪切变形过程，分析计算圆盘剪剪切力和传动功率，介绍了圆盘剪开口度调整装置，剪刃侧间隙调整机构和重叠量调整机构以及侧间隙和重叠量对剪边质量的影响

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。