侧弯

Methods Seven cadaveric spinal specimens were measured of neutrol zoneand range of motionin 6 movements including anteflexion,retroflexion,left and right lateral flexion,left and right axial rotation.

测试前屈、后伸、左侧弯、右侧弯、左旋转、右旋转的中性区(neutral zone，NZ)和运动范围(range of motion，ROM)。程序：完整状态；②骨折后状态；③椎体成形后；④3000次循环疲劳后。结果骨折后中性区和运动范围均明显增大。椎体成形后屈伸、侧弯、旋转在NZ及ROM均明显减少。

It is a painting: a white-bearded old man holding fans sat侧着头,歪着嘴,傍边station curette small孙孙hand, spread his legs, slightly curved body, single-handedly take the old man on his shoulders, eyes staring at the ear is for the old man out cerumen.

它画的是：一白胡子老翁持扇而坐，侧著头、歪著嘴，傍边站的小孙孙手拿耳挖，散开双脚，略弯身子，一手搭在老翁肩上，眼睛瞪著耳内，正为老翁掏耳屎。

"In LIS, only patients with thoracic apices and curves of more than 100 degrees are at increased risk of death from cor pulmonale and right ventricular failure," the authors write.

在晚发作型原发性脊椎侧弯的病程中，只有侧弯角度大于100度且有胸廓尖点才会增加因肺心症或右心室衰竭致死的机率。

They found that the joint moments measured at any given motion increased with greater magnitudes of joint displacement, and were significantly larger in the two most caudad facet joints (L4 L5 and L5 S1).62 With lateral bending, strains of the joint capsule tended to be larger in magnitude in the three most caudad joints(L3 S1) during contralateral flexion (i.e., the left facet joints are most strained during right lateral flexion),whereas the two most cephalad joints (L1 L2 and L2 L3)bore the greatest strain during bending to the ipsilateral side.

当向对侧弯曲时侧弯时最尾端(L3 S1)的三个椎体的小关节囊的拉伸强度增大（例如右侧屈曲时左侧小关节达到最大的应力）。而头端的两个关节(L1 L2 和L2 L3)在向同侧屈曲运动时拉伸力量最大。

Objective:To investigate the efficacy of spinal orthosis combinated with orthopedic gymnastics in treating patients with idiopathic scoliosis.

目的：探讨脊柱矫形器配合矫正体操治疗特发性脊柱侧弯患者的疗效。方法：40例特发性脊柱侧弯患儿。

Objective: We developed a method of experimental scoliosis in rabbits in order to observe the effect of scoliosis on distribution of muscular fiber type s in paravertebral muscles.

目的：通过脊柱侧弯动物模型，观察脊柱侧弯对椎旁肌肌纤维型分布的影响，探讨肌纤维型分布不对称现象的原因。

The severity of scoliosis was described by Cobb angles, spinous process angles, and scoliotic index calculated from the radiographic images.

S。 A。同步测量。脊柱侧弯的严重度分别在X光影像上用科布角度，脊突角度及侧弯指数来表示。

It is urgent to solve how to produce it efficiently and economically.In this paper, with the guidance of precision forming complex components, basing on the forming theory of obturated-extrusion, combining the technique of hot extrusion, considering the characteristics of steering knuckle, so the one-step precision obturated lateral-bend extrusion forming method and the two-step forming method are presented.

本文以复杂零件的精密成形为指导思想，根据闭塞挤压成形理论，结合热挤压技术，针对轿车转向节零件的自身特点，提出轿车转向节零件的闭塞侧弯挤压精密一步成形法和闭塞侧弯挤压精密预制坯与开式终锻相结合的两步成形法两种工艺。

"We aim to make family doctors take over the management of minor curvatures because there is a tendency with all health problems for people to see a specialist," he said.

他这样说道：&我们的目标是使家庭医生也能对轻度侧弯进行处理，因为轻度侧弯可以引起很多专科的健康问题。&

Locking pedicle screws were placed into pedicles of apical vertebra and the 3 to 5 adjacent vertebrae.

男106例，女103例，其中特发性脊柱侧弯92例，先天性脊柱侧弯72例，青年驼背26例，其他19例。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。