使扭转
- 与 使扭转 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
I seriously fried the small battery holder I was using for the reversing battery and melted one of my oscilloscope probes on the very hot reversing FET when fiddling with the oscillator circuit so I decided to make the output stage absolutely unable to go into forward and reverse at the same time by putting the two opto isolators back to back from one chopper amplifier to the other so only one of them can ever be on at a time - gets rid of some parts and adds a major safety improvement - bonus!
i认真油炸小电池匣,我使用为扭转电池和融化我的一个示波器探头就非常热扭转场效应管时,fiddling与振荡电路,所以我决定使输出的阶段,绝对无法进入正向和反向在同一时间,把两个光电隔离器背靠背从一菜刀放大器到其他,所以只有一个人能永远就在一个时间-摆脱部分,并增加了一个重大安全改善-奖金!
-
If the same two single are plied into a double by twisting 100 tpm in the Z direction, the counterclockwise twist will tend to unwrap the single yarns and the internal torque of the single yarns will be reduced to 100 in the S direction.
如果给相同的两根单纱加上Z方向上100tpm的捻度使它们合成一股时,逆时针方向的加捻则会使单根纱线易于解开,使其在S捻向上的内部扭转力降到100。
-
Due to the effect of torsional vibration arose by eccentricity of the center of mass and the center of rigidity, there will produce stress concentricity in some local location of the structure, which is very detrimentally. This paper discussed the contribution of the reduction of the response of torsional vibration of the accessorial eccentrically braces in structure on emphasis.
由于不规则高层建筑的质心刚心偏心而引起的扭转振动效应,会使结构的局部产生应力集中等极为不利的情况,因而本文着重讨论了增设偏心支撑后的结构,对减小原结构的扭转振动效应的贡献。
-
Methods A vertical incision was made on epigastrium to accommodate five fingers. The mesocolon was exteriorized and rotated counterclockwise 90 degrees to parallel to the incision. A rubber support was placed beneath the exteriorized colon and sutured to the skin on either side of the wound.
在上腹正中做一纵切口,使之容纳5个手指,将横结肠提出并逆时针扭转90度,使之与切口方向一致,在横结肠下放置支撑棒,支撑棒两端与皮肤缝合固定。
-
The axially symmetric torsion of rigid circular shaft of varying diameter embedded in an elastic half space is studied by line-loaded integral equation method, where the problem is formulated by distributions of fictitions fundamental loads PRCHS (point ring couple in half space) along the axis of symmetry in interval of the shaft and is reduced to a one-dimensional and non-singular Fredholm integral equation of the first kind and is easily solved numerically.
弹性半空间;本文用线载荷积分方程法研究嵌在弹性半空间的刚性变直径圆轴的轴对称扭转。利用将"半空间的点环力偶"这一虚的基本载荷沿对称轴的圆轴区间中分布就能使本问题归结为一个一维的非奇异的Ferdholm第一种积分方程,且很易用数值求解。文中给出刚性圆锥,圆柱,圆锥柱嵌在弹性半空间的扭转的数值计算的例并和他人的已知结果相比较。
-
Pass to count to Wisterch parameter , and the steel wire is different from the molding tool get in touch with the length, and settle the path the research taking the length work the stabber angle to get under differently pull to stir the term, mold core adoption of best severally why size, combine the best work stabber of research the Cape, and settle the path to take the length nextly steel wire is in the molding tool of have fever to measure, air inside dispel-heat calories, winding dispel-heat on the coil-canister , and its molding tool dispel-heat calories of, and cause the steel wire the temperature difference pass in and outing the molding tool to influence steel wire machine function, under the experiment inside pull to stir the term according to the same race different work stabber Cape half of adoption the Cape(7 degree,10 degree,12 degrees, the best mold Cape, experience mold Cape) settle the path to take the length(2-3 mm,3-4 mm,4-5 mms, theories length, experience length) to proceed to experiment, and get the conclusion, work stabber the Cape then is more big the steel wire get in touch with the length with
通过对Wisterch参数,钢丝与模具接触长度、定径带长度、工作锥角度的研究得到了在不同拉拨条件下模芯采用的最佳几何尺寸,并研究最佳工作锥角、定径带长度下钢丝在模具中的发热量、空气中散热量、卷筒上的散热量及其模具散热量的不同,导致钢丝进出模具的温度差别对钢丝机械性能的影响,在实验中根据同种拉拨条件下采用不同工作锥角半角、定径带长度进行试验,得出结论,工作锥角越大则钢丝与模具接触长度越短,钢丝变形越剧烈,在模具中发热量就越高,导致钢丝出模温度高,使钢丝强度、硬度升高,弯曲、扭转次数降低,并且降低模具使用寿命。在其它条件相同的情况下,定径带越长则钢丝与定径带简壁磨擦增大,使钢丝发热量加大,从而使钢丝强度、硬度略升高,弯曲扭转次数略降低但定径带的增大减小了钢丝变形产生的弹性后效使钢丝出模直径比较稳定。
-
A third force is known as a torsional force,or a torque since it tends to twist an object.
第三种力就是众所周知的扭转力,或者称为转矩,因为它趋于使一个物体扭转。
-
By applying electromagnetic vibration on solidification front of Sn-10Pb alloy,creation of equiaxed grain zone in ...
在低强度电磁振荡条件下,凝固组织细化和等轴晶化的原因是:电磁振荡力对金属初生晶的周期性拉伸、压缩、剪切、折弯、扭转等机械作用,使其出现断裂和剥落,增加形核数量;电磁振荡的局部搅拌作用使固/液界面前沿的温度和成分趋于均匀化,导致梯度降低,抑制了柱状晶的生长。
-
Kudai meal-meal-Kudai intra-abdominal pressure can drop, the activities of the digestive organs and ligaments increase the capacity and thereby facilitate the intestines wiggle intensified, prone volvulus, people abdominal distention, abdominal pain, vomiting, Also vulnerable to diseases such as Gastroptosia.
饭后松裤带饭后松裤带可使腹腔内压下降,消化器官的活动与韧带的负荷量增加,从而促使肠子蠕动加剧,易发生肠扭转,使人腹胀、腹痛、呕吐,还容易患胃下垂等病。
-
The results show that the torsion energy and van der Waals interaction energy are the main types of energy and the substitution group has a great effect on the total energy of molecular. The aliphatic substitution would lead to the increase of total energy, while the aromatic substitution would lead to the decrease of total energy. The calculated results of bond length show that the bond length of aliphatic C—C is longer than that of aromatic C—C, which indicates that the rupture of aliphatic C—C is easier than that of aromatic C—C on heating.
研究结果表明,扭转能和范德华能是分子中的主要作用力,取代基对体系能量有明显影响,烷基取代基使体系能量增加,而苯基取代基使体系能量降低;脂肪C—C键长比芳香C—C键长长,说明脂肪C—C在受热过程中比芳香C—C更容易断裂分解。
- 推荐网络例句
-
The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.
采用不同浓度K2CrO4(0,0.4,0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗,测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。
-
By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.
通过分析数学形态学在图像中的理论基础,研究二值图像的形态分析算法,探讨最小结构元素的两种基本形态:膨胀和腐蚀;分析了数学形态学复杂算法的基本原理,把数学形态学的部分并行处理理念引入到家实际应用中。
-
Have a good policy environment, real estate, secondary and tertiary markets can develop more rapidly and improved.
有一个良好的政策环境,房地产,二级和三级市场的发展更加迅速改善。