使失效

Fatigue damage once invalidated railway bridge, fatigue crack ever resulted in collapse of artesian well desk in ocean.

疲劳损伤曾使铁路桥梁失效，疲劳裂缝的存在使海洋钻井台倒塌倾覆，酿成悲剧。

An advanced branch and bound method which reduces the computer resolving time enormously and leads the reliability research of large-scale spatial frame structural systems close to practical use is presented on condition that the same computation accuracy is ensured.

导出了大型空间刚架结构系统某梁元断面达到塑性屈服极限时的修正刚度矩阵和相应的等效节点力向量；提出了在保证同等计算精度的条件下，可成倍地减少运算时间的改进分枝限界方法，使大型空间刚架结构系统的可靠性研究向实用化迈进；本文开发出可自动生成失效衡准，自动选择主要失效形式，追踪失效过程的计算机程序。

The effect of tribology factors on bearing vibration is studied experimentally. AR model and WPT are used to processing the normal arid abnormal signals. The results are as follows:1. The vibration of ball bearings is caused by the tribology action of contact pairs of ball and ring races and has the essential of tribo-dynamics. Any factors affecting the tribology characteristics of contact pairs will affect vibration and noise of bearings consequently.2. Vibration characteristics of bearing keep almostly unchanged with the increasing of axial load expecting the increasing of nature frequencies. When radial load increasing with axial load unchanged, nature frequencies keep unchanged but some new vibration peaks appears in the spectrum.3. Vibration amplitudes are damped and nature frequency are enhanced with sufficient lubrication. Vibration and noise of bearings increase obviously and roar can happen and the contact surfaces scratch slightly under insufficient and unclean lubrication state. Bearing will be disabled in a few minutes without any lubrication.4. Bearing vibration is unstable under low speed. With the speed increasing, the vibration become stable and natural frequencies increase slightly but the amplitudes increase apparently.5. Bearing vibration can be excited only by some harmonics ofwaviness without lubrication and by all harmonics with lubrication based on the theoretical analysis.6. The nature frequencies of ball bearings decrease with the increasing sizes. When international clearance increasing, nature frequencies decrease in radial and increase in axial and angular and the amplitudes increase in radial and decrease in axial and angular. When the number of balls increasing, nature frequencies increase and amplitudes decrease. When the pitch diameter increasing, axial nature frequency increase and others nearly keep no change. When outer race groove curvature radius increasing, nature frequencies increase in radial and decrease in axial and angular and amplitudes keep no change in radial and increase in axial and angular. When inner race groove curvature radius increasing, nature frequencies decrease and amplitudes increase.7. The distortion in amplitude and frequency components of bearing vibration signals picked up by the present probe measurement method is founded and right conclusions cannot be achieved by the signals. When accelerometer is rigidly screwed with steel stud onto a flat outer surface of a ball bearing, vibration signal can be got without distortion and the reliability of research on bearing vibration is assured.8. AR model is suitable for large samples of bearing vibration signals, square root of length of samples can be used as the upper limitation of order determination and the FPE order selection criterion is effective. Many advantages of AR spectrum are founded over the classical based on FFT.9. Time-Frequency analysis is necessary for abnormal noise of ball bearings. WPT overcomes the principle shortcomings of STFT and proved to be a best tool to process the abnormal signals.

理论分析和试验研究表明： 1球轴承振动是钢球—滚道接触副中的各种摩擦学作用引起的，具有摩擦动力学的本质，任何对接触副的摩擦学特性有影响的因素都将对球轴承的振动和噪声特性产生影响； 2中心轴向载荷作用下，载荷增大使球轴承的固有振动频率升高，载荷越大同样的载荷增幅引起的频率升幅减小，足够大的中心轴向载荷作用下载荷的变化对球轴承振动的频率特性不会产生明显的影响； 3轴向和径向联合载荷作用下，径向载荷不大时球轴承振动的固有频率基本不变，但是可能引起变刚度激励的非线性振动，出现新的频峰，过大的径向载荷将使部分钢球脱离接触，使球轴承的振动和噪声呈现不稳定状态； 4润滑对球轴承的振动和噪声特性有重要的影响，良好的润滑对振动有明显的抑制作用，润滑不充分时，振动和噪声的水平会有明显增高，一定条件下还会激发接触副中的谐振，发出啸声，造成接触表面的伤害，无润滑干接触时，短时的运转就会损伤接触副表面，使振动和噪声迅速增大，并随时可能引发严重的磨损和卡滞失效；接触副润滑良好时，油膜的"刚化效应"使球轴承振动的固有频率有所提高，润滑剂中含有弥散性污浊时，振动的幅度总体升高，但弥散性污浊不会改变球轴承振动的频率特性；浙江大学博士学位论文：球轴承振动的研究 5低速时，球轴承振动的基本特征呈现不稳定状态，随着转速的提高，球轴承振动的频率特性趋于稳定，固有频率频峰升高； 6理论分析表明，干接触时钢球和滚道表面波纹度的某些谐波分量能激励球轴承的振动，振动的幅值与谐波幅值成正比，实际球轴承中钢球的分布不可能完全均匀，波纹度的激励作用会随时发生；润滑接触的分析表明，波纹度的任意谐波分量均能激励球轴承的振动； 7球轴承的几何和结构参数分析表明，球轴承尺寸越大，径向、轴向和角振动的固有频率越低；钢球中心圆直径增大，球轴承的径向和轴向振动的固有频率基本不变，角振动的固有频率有所上升，振动的幅频特性基本不变；径向游隙加大使球轴承的径向振动固有频率降低，轴向和角振动的固有频率有所升高，径向振动幅频特性的幅值升高，而轴向和角向降低；钢球的数量增多使球轴承振动的固有频率上升，幅频特性的幅值下降，径向振动的幅值下降最为明显；外圈沟曲率半径系数增大使球轴承径向振动的固有频率升高，轴向和角振动的固有频率降低，径向幅频特性基本不变，轴向和角向幅频特性幅值升高；内圈沟曲率半径系数增大使径向、轴向和角振动固有频率均下降，振动幅频特性的幅值均有升高； 8试验对比表明，传感器采用探针式安装时，由于探针接触副接触特性的影响，钡(量得到的球轴承振动信号有失真，采用专门设计和制作的试验球轴承，以固定式安装加速度计，首次测量得到了球轴承振动的真实信号，通过对振动信号的分析，验证了球轴承振动的理论模型； 9)基于时间序列分析的AR模型适用于大样本球轴承振动信号的分析，以样本长度的均方根值作定阶上界，FPE做判阶准则，给出的AR谱光滑，频率分辨率高，是球轴承振动分析的简便而可靠的手段； 10以时频域分析的小波包变换分析球轴承异音信号能够比较好地定位和聚焦异音发生的时间，时间间隔，频率范围，同样是球轴承振动分析的可靠的手段，可用作球轴承故障诊断技术。

Tear-down analysis indicates that for VRLA battery, water loss ,negative plate sulphation and positive active material softening are the main causes of failure.

通过对失效的VRLA电池的解剖分析，电池失水、负极板硫酸盐化和正极板活性物质软化是导致VRLA失效的主要原因，介绍了一种使失效电池容量恢复的方法，并对该方法的有效性机理进行了简单分析。

Anything which invalidates the input sequence will invalidate the match results.

任何使输入序列失效的事件都会使匹配结果失效。

Causing the omens of boasters to fail, Making fools out of diviners, Causing wise men to draw back And turning their knowledge into foolishness

赛44：25 使说假话的兆头失效、使占卜的癫狂、使智慧人退后、使他的知识变为愚拙。

Causing the omens of boasters to fail, Making fools out of diviners, Causing wise men to draw back And turning their knowledge into foolishness

赛44：25 使说假话的兆头失效、使占卜的癫狂、使智慧人退後、使他的知识变为愚拙。

Combined with the macro-morphology appearance analysis and working conditions of failure casing, the paper reached a conclusion that it is due to the impact and friction which come from the drill tools made the fatigue cracks formation on the casing thread root, and eventually leading to casing rupture failure, the material defects in failure casing accelerated crack initiation and growth.

摘 要：某井在钻井作业过程中，发生了上层Φ244.5 mm技术套管断裂失效事故，为了分析事故原因，对失效套管材料的化学成分、金相组织和力学性能进行了检测分析，结合套管失效形貌的宏观分析和套管使用过程中的现场工况分析，得出了套管螺纹发生断裂失效的原因是钻具对套管的撞击、摩擦，使套管螺纹根部产生疲劳裂纹，最终导致套管断裂失效，失效套管的材料缺陷加速了裂纹的萌生和扩展。

It is clarified for the first time that the thermal fatigue failure of solder joint is actually a creep strain low cycle fatigue failure, and a physical model for creep fatigue crack propagation has been proposed. It was pointed out that creep strain increases in the high stress area ahead of the tip of thermal fatigue crack, results on one hand that the slide of crack tip increase, inactivation more serious and crack close length increases, the other hand, that intergranular crack exists, whose direction will affect the fatigue crack propagating.

本文首次阐明了焊点的热循环失效本质上是以焊点内循环蠕变为主要应变的低周疲劳失效，并在此基础上提出了蠕变疲劳裂纹扩展的物理模型，指出热循环裂纹前端的高应力区内，蠕变加剧，使裂纹前端滑移增加，裂纹钝化加剧，导致随后的裂纹闭合扩展长度增加；同时蠕变也使裂纹前端的高应力区出现晶间裂纹，蠕变沿晶裂纹对主裂纹扩展的影响取决于沿晶裂纹的连接方向。

It is shown that the contact interaction enables bottom drillstring to whirl backward, and then an alternate bending stress with higher frequency is produced. So the drillstring fatigue failure could be accelerated. At the same time, a quite strong wallop force of high frequency is produced on the contacting point, and the contacting zone is next to the screw coupling of drill collars. It will easily result in the failure of screw couplings. The research results provide theoretical basis for the prevention of drillstring failure.

研究表明，下部钻柱与井壁的碰摩作用使下部钻柱反向涡动，产生高频的交变弯曲应力，会加速下部钻柱疲劳破坏；下部钻柱与井壁接触点处存在较大的高频冲击力，并且接触区域靠近钻铤螺纹联结处，更容易诱发螺纹联结处失效，该研究成果可为预防钻柱失效提供理论依据。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。