使均匀

This approach first aligned 3D faces based on non-uniform mesh re-sampling which result the uniform number of vertex and topology structure and kept in a vector. Second, we changed the vector to the matrix by division and overlap, and then 2DLDA suggests a feature selection strategy to select the most discriminative features from the corner.

该算法首先使用基于非均匀网格重采样的方法对所有三维人脸做规格化处理，使三维人脸具有统一的点数和拓扑结构；其次，以先分段、再重叠的形式将原本一维向量表示组织为二维矩阵表示，然后使用二维线性判别分析方法(2DLDA)对获得的数据进行特征抽取。

Therefore, only elimination of reflux and the vortex, so that uniform distribution of flow velocity in order to ensure the normal operation of pump unit.

因此只有消除回流和漩涡，使水流速度均匀分布，才能保证水泵机组的正常运行。

An improved design of such a large tower must be achieved which results in more uniformed temperature distribution in it.

必须改进这种大型塔的设计，以使塔内温度分布更均匀。

In present technology condition, it is impossible to make the video signal of IRFPA perfect uniformity.

在现有的技术条件下，要使生产出来的红外焦平面阵列视频信号达到理想的均匀性是不可能的。

But also the body's muscle ministries have been uniformly coordinated development.

而且还可以使身体各部的肌肉得到协调均匀的发展。

The thesis also applies FE sub-model and numerical optimization design techniques to conduct the cross-section configuration optimization for the wings joint of some unpiloted air vehicle project, with the light weight objective and the balance of pin-load distribution at each row screws, which lays an excellent design foundation for reducing the around-hole stress concentration and its life improvement.

论文还应用子模型法对某无人机机翼前后段连接接头的截面构形进行了优化，使各列铆钉上的钉载趋于均匀，为降低紧固件孔边应力集中奠定了设计分析基础。

A series of grafting-modified dregs were prepared and the influence of monomer ratio, rotation speed and time of ball milling on grafting efficiency was investigated. It is demonstrated that mechanochemical techniques of ball-milling can smash up dregs as well as initiate in-situ grafting polymerization. Thus the usableness and uniform dispersion of dregs in polymer matrix can be ensured.

通过红外光谱和热失重分析证明，球磨过程在粉碎细化废渣的同时，可由力化学作用引发原位接枝聚合反应，将改性聚合物化学键接在废渣表面，使废渣具备与聚合物共混、在聚合物基体中均匀分散的基本条件。

The furnace cover use stainless steel insulation cover. The cover panel and the tank body use double water cooling vacuum rubber sealing. 60 KW above Pre-Pumped Vacuum and Protective Atmosphere Furnacecover installated stainless steel vacuum sealed fan which will enable inner temperature uniformity,,furnace panels are installed on the vacuum interface, Interface sent to protect the atmosphere, vacuum Pressure Gauge.

炉盖采用不锈钢内保温炉盖，炉盖面板与罐体采用双水冷真空橡胶密封，60KW以上预抽真空保护气氛电炉盖上安装有真空密封不锈钢风机，可使罐内温度均匀，电炉面板上安装有抽真空接口、送保护气氛接口、真空压力表。

The furnace cover use stainless steel insulation cover. The cover panel and the tank body use double water cooling vacuum rubber sealing. 60 KW above Pre-Pumped Vacuum and Protective Atmosphere Furnace cover installated stainless steel vacuum sealed fan which will enable inner temperature uniformity,,furnace panels are installed on the vacuum interface, Interface sent to protect the atmosphere, vacuum Pressure Gauge.

炉盖采用不锈钢内保温炉盖，炉盖面板与罐体采用双水冷真空橡胶密封，60KW以上预抽真空保护气氛电炉盖上安装有真空密封不锈钢风机，可使罐内温度均匀，电炉面板上安装有抽真空接口，送保护气氛接口，真空压力表。

Within holdingfurnace using stainless steel lid covered lid panels and d-ual-use water-cooled vacuum tank rubber seal,60KW above p-re-puamping vacuum protective atmosphere furnace covered with installation of stainlesssteel vacuum sealed fan willenable inner temperature uniformity,EAF panel install a v-acuum interface,interface sent to protect the atmosphere, vacuum pressure gauge.

炉盖采用不锈钢内保温炉盖，炉盖面板与罐体采用双水冷真空橡胶密封，60KW以上预抽真空保护气氛电炉盖上安装有真空密封不锈钢风机，可使罐内温度均匀，电炉面板上安装有抽真空接口、送保护气氛接口、真空压力表。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。