使厚

Based on the project instance, construction craft is introduced that shallow layer guide hole technology to improve soft soil foundation under thick hardpan and the refit of main construction equipment. It has succeeded in solving problem of the drain consolidation of silt. The result is good

摘 要：结合工程实例介绍采用浅层引孔技术加固硬土层下软土地基的施工工艺及主要施工设备的改装，成功地解决了穿透较厚硬土层使下卧淤泥层排水固结的技术难题，效果良好，经济实用，有较好的推广价值。

Laser engraving roller is how to make the delivery of low holdout?

激平雕镂网纹辊又是如何使传达的不朱层纤不不厚的呢？

Our skin every day on their own metabolism, resulting from the basal cells gradually reach the skin surface, and then become a cuticle, the skin hyperkeratosis cycle is usually around 28 days, due to the environment, season, UV, rest is not normal and other factors, sometimes cause slow metabolism, so our skin piles up thicker stratum corneum, horny excessive accumulation, it will allow a transparent discussion so that the skin does not feel a sense of, and have lost the flexibility of the original, so fixed and the appropriate exfoliation, dander can be removed, so that the skin is more translucent.

我们的肌肤每天都会自行新陈代谢，由基底层产生的细胞会慢慢的到达肌肤的表面，然后成为角质层，皮肤的角化周期通常约为28天，由于环境、季节、紫外线、作息不正常等因素，有时会使新陈代谢变得缓慢，所以我们的皮肤表面角质层越堆越厚，角质过度的堆积，就会容议让肌肤感觉没有透明感，也失去原本的弹性，所以固定且适当的去角质，可以将皮屑去除，让肌肤更晶莹剔透。

It is proposed that the runner location should be first to be selected to ensure molten metal filling along the die wall in order to reduce melt flow resistance and then ingate should be located in the heavy section of the workpiece to which the melt would be filled at the beginning. As a result, the applied pressure could be transmitted fluently to avoid shrinkage cavity and to ensure castings quality.

指出浇道位置的选择首先要保证金属液沿着型壁顺序充填，以减少金属液的流动阻力；内浇道应使液态金属从制件厚壁处开始充填，以利压力的传递，消除缩孔，保证制件的质量。

Chlamydospores of kaoliang head smut treated under moist conditions at 32-35℃ inan incubator for 30 days,and then transferred to the cane-sugar solution,resulted 60 to 90%germination in contrast to only about 10% with the untreated control.

在32—35℃高温和湿润环境里处理30天后，就能完成厚垣孢子生理后熟的发育阶段，使孢子发芽率从10%左右提高到60—90%。

It is related that the large button with the high sculpture and the thick edge, but the thickness of button, sculpture, edge and other part of back are so different that the thickness of oxide layer on these different part are not equal.

因这些镜种的背面全部都是以钮为中心往下凹，而镜面的铸态毛坯却是平面；这就形成了镜体中心薄，越往外缘越厚的铸件；为使磨制出的镜面没有铸造缺陷，也为了尽量减少镜体重量，须将镜面中心少磨削、外围多磨削。

Using the spatula as a guide, drop the dough by spoonful into a 2.5-inches wide and 18-inches long log directly onto the parchment paper. Slightly flatten it to 1/2-inch thick. Leave 2 inches space between logs.*** Brush eggwash over logs.

用刮刀做指引，一大勺一大勺地把面团直接舀到油布上，使它形成一个长18英寸（45cm），宽2.5英寸（6.3cm）的圆柱体，然后轻轻压扁成1/2英寸（1.3cm）厚。

Using the spatula as a guide, drop the dough by spoonful into a 2.5-inches wide and 18-inches long log directly onto the parchment paper. Slightly flatten it to 1/2-inch thick. Leave 2 inches space between logs.

用刮刀做指引，一大勺一大勺地把面团直接舀到油布上，使它形成一个长18英寸（45cm），宽2.5英寸的圆柱体，然后轻轻压扁成1/2英寸厚。

The cork cambium gives rise to the PERIDERM, a protective layer of tissue on the outside of the stem or root, which consists of the cork, the phellogen, and the PHELLODERM.

木栓形成层的活动使周皮增厚，这种主要由木栓层、木栓形成层和栓内层组成的周皮是植物茎或根表面的保护层。

But a thicker cell is necessary to keep higher precision. Superimposing a constant phase difference proposed in the thesis make it is possible to measure the pretilt angle in thinner cell. This method was applied in our newly developed pretilt angle tester successfully.

晶体旋转法是测试预倾角的常用方法，但要求有较高的盒厚，本文提出的叠加一位相差的方案使这种方法可以实现对较薄盒的测试，并成功的应用于我们最新开发的预倾角测试仪。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。