使厚

Second, at the manufacturing, so the overall effect is more noble, elegant, thick-skinned because of its unique natural dermatoglyphics enable it to have different effects.

其次是在制造方面，使其整体效果更加高贵，典雅，厚皮因其特有的自然皮纹，使其有与众不同的效果。

Another situation is in order to reduce material costs and adopt only 330-molecular-weight natural Rosin, in order to achieve-and-ink system stability, in recent years, we have dozens of chemical properties caused by not changing inorganic materials, use of the tetrahedroid of hydrated silicon dioxide as a porous form of assiociation matozoa, a steady and adsorbed on low molecular weight of rosin Sol heterogoneous on the surface, forming a layer, the Pro-numberrepresentationof goes with liquid water, addresses the thixoforming improve its water washable, and has a certain thickness, especially when more than 5 per cent, packaging business card printing and membership card by making the formation of a layer of short thick membrane of lowmolecular of monlchamus, in which case it reduce-and-Ink viscosity, increase the concentration would affect the business card printing and membership card to make the mobility of transfer affects gloss, the reason is that in the process of associating exothermic rise ink system temperature diminishes the Rosin molicule assiociation.

另一栽境况是：为了贬矮质料不败本，合座拔取仅有330不合子量的人造松香，为到达火不朱编制不时间的安定性，近年来，我们在数不一栽不引起冻学本质保持的不不不不无机质料洋，诳骗四面体的火合二氧冻硅的多孔形式作为缔合胶体，使之能安定不天吸附在矮不合子量的松香溶胶粒子的暗不天上，形不败一层爱护膜，把干液性基团伸向火洋，既可打消触变又能提矮其火可洗性，并具有必定的厚量，格边是当超功5％之后，包装制卡和会员卡制作的不朱膜形不败了一层长稠厚的矮不合子不朱膜，这时则更会贬矮火不朱粘量，如果补充了浓量，则既会感冻制卡和会员卡制作迁徙的流动性，又会感冻平泽的提矮，来因是：在缔合放热的历程洋升矮了油不朱编制温量而放松了松香不合子的缔合方向。

But the problem is this thin layer of atmosphere is being thickened by all of the global warming pollution

现在的问题是由于导致变暖的污染物的囤积，这个原本很薄的气层越来越厚，这样下来此气层被不断增厚，更多的红外辐射被捕获了，这样全球大气升温而这就使全球变暖。

Electroless Copper is a chemical metalization process intended to metallize the surface of dielectric material at the hole wall and institute electrical connection between all exposed copper surfaces.

化学沉铜：为了使孔壁上不导电的树脂及玻璃能够导电，进行化学沉铜，使孔壁与板面上沉上的一层很薄的铜层，只有大约75微英寸厚（0.5mil），再通过全板电镀，使板面和内层铜联接起来。

Through designing of composition and structure of the bioactive graded coating,innerstress and its distribution in the coating were analyzed and calculated, the resultsshowed that when composition distribution coefficient n was 1.5, a reasonable stressdistribution could be got, that was at the beginning of deposition the suspension containingrichly BG granules was used so that a rich BG granules layer, a good transitional layerbetween BG layer at the bottom and the coating could be obtained at the titanium alloy side,the bottom of the coating; the stress value near the interface and surface and its character,pressure stress or tensile stress, were decided by the character of its composition itself.Changing composition distribution coefficient n could only change the variation tendency ofstress in the coating, but did not change the stress distribution rule in the coating. Thethinner the coating is, the sharper stress variation in the coating is, which does not mean thatthicker coating is better because the thicker the coating is, the little the permitteddeformation of coating is, so the coating thickness should be thinner, for example, about50μm for bending applications, but for applications only bearing pure shear stress, such asroot of tooth implant, the coating can be thicker little, for instance, about 80～100μm. The study on electrification characteristic and electrophoresis deposition of HAand BG granules in aqueous and non-aqueous solution system found that EPD almost didn'toccur in aqueous solution system. However, because HA granules take position charges inabsolute alcohol, a homogeneous EPD be carried out on the cathode titanium alloy slice, but taking negative charge in absolute alcohol the BG granules not be deposited on the cathode. A guided HA crystallizing, 100～300nm, on surface of the BG granules be realized by metathetical reaction, which cover BG granules with HA microcrystals and make the covered BG granules taking position charges in absolute alcohol, sequentially realize the EPCD of the BG and HA granules on the cathode, so it is feasible to make a titanium alloy/BG/HA bioactive graded coating by making use of EPCD technology. The corrosion experiment of rich boron bioglass coating and plasma spray coating showed that split phase, rich boron and rich silicon phase, occurred during its preparation. In basic medium the corrosion behavior of 〓 BG coating showed uniformity corrosion, the corrosion mostly occurred at rich boron phase area, therefore batch formula design of BGshould avoid the occurring of split phase. The corrosion appearance of plasma spray coatingappeared a non-uniform corrosion, mostly occurred at the edge of the laminated HA moltendrops, and emerged an accelerated corrosion tendency, which will easyly lead to corrosioncrackles extending to the interface and the happening of osmotic interfacial corrosion, thatmay be one of the major reasons leading to the coating cracking-off in the later period. Thetesting results of thermal expansion coefficient of 〓 and 〓BG showed the thermalexpansion coefficient of 〓 BG matched with that of titanium alloy better, and 〓 BG couldsinter with titanium alloy into densification enamel layer at low temperature (720℃).

将Ti6Al4V合金在1000℃下进行真空热处理会降低其力学性能，且合金内的V元素会向表面富集，因此，钛合金真空热处理和表面涂层的烧结温度不能过高，即应低于其相转变点；通过对生物活性梯度涂层的组成和结构的设计，分析和计算了梯度涂层内的应力大小和分布，结果表明：对于本研究，当成分分布系数n=1.5时，可以获得较合理的涂层力学性能，即在沉积开始时，采用富含BG颗粒的悬浮液，以便在钛合金侧获得同底层BG有良好过渡的富BG涂层；梯度涂层界面和表面的应力大小、性质由材料组成本身的性质决定，改变成分分布系数，只能改变涂层内应力变化的趋势；涂层的厚薄不影响涂层内的应力分布规律，但涂层越薄，涂层内的应力变化越快，但这并不意味着涂层越厚越好，因为涂层越厚，涂层允许的变形越小，对于应用于弯曲受力部位的涂层而言，涂层应薄一点为好(50μm)；而对于仅纯受剪切应力的部位，如牙根种植体，涂层可适当加厚(80～100μm)；通过对HA和BG颗粒在水溶液体系和非水溶液体系中的带电特性和电泳沉积的研究发现，它们在水溶液体系中很难发生电沉积；在无水乙醇溶液中，HA颗粒带正电，可在阴极钛合金片上发生均匀的电泳沉积，而BG颗粒则带负电荷；利用复分解反应法，可以制得100～300nm的HA，通过诱导HA在BG颗粒表面结晶，可对BG颗粒进行表面包覆，获得了被HA包覆的BG颗粒，改变了BG颗粒表面的带电特性，使BG和HA颗粒在无水乙醇中均带上正电荷，从而实现了HA和BG颗粒在阴极上的共沉积。

Lateral crus presented diamond-shaped or long strip,(16.21 ± 2.71) mm in length,(8.45 ± 1.72) mm in width,(1.09 ± 0.18) mm in thickness. Cephalic rim intersected lower edge of lateral nasal cartilage, and slightly covered the lower edge of the lateral nasal cartilage, so that the two were overlapped, but also only the intersection without overlapping. Lateral crus constituted the base of nasal wings. Narrow medial crus formed nasal tip and the frame of front nasal columella, showing posteroinferior curve or S shape,(13.06 ± 2.16) mm in length,(3.79 ± 0.58) mm in width,(1.02 ± 0.18) mm in thickness. The left and right medial crus in the middle were connected by connective tissue, and in the same way connected to the anterior margin of the lateral nasal cartilage.

外侧脚呈菱形或长条形，长(16.21±2.71) mm，宽(8.45±1.72 ) mm，厚(1.09±0.18) mm，头缘与侧鼻软骨下缘相交，并略覆盖侧鼻软骨下缘使二者部分重叠，也可仅相交而无重叠；外侧脚构成鼻翼大部的基础；内侧脚狭细，构成鼻尖和鼻小柱前部的支架，呈向后下的弧形弯曲或S形弯曲，长(13.06±2.16) mm，宽(3.79±0.58) mm，厚(1.02±0.18) mm；左、右内侧脚在正中线借结缔组织相连，并以相同方式连于侧鼻软骨的前下缘。

About feeding thick material flush ioint machine,Usee five connecting rods to be possible to adjust about thickness the compound feeding,to swollens the wseam material and dives moves the natural big especially thick material and the thin material,Can enable the lower level in the tailoring process the feeding quantity to achieve consistently;Uses turns on lathe the shuttle greatly,The raduction trades the agent number of times,Most major characteristic thickness dual purpose,Enhances the working efficiency,Uses the completely automatic lubricating arrangement,Enhances the machine service life.

0388系列上下送厚料平缝机使用五连杆可调整厚薄上下复合送料，对膨体类缝料和潜移性较大特厚料和溥料，在缝纫过程中能使上下层的送料量达到一致；采用大旋梭，减少换底线次数，最大特点针线张力小；缝纫厚度能力增大，缝纫薄料性能优良。

The simulation of field data indicates that this method avoids the effects of parameter variations by letting AFC and AGC to adaptively track the parameters variations for reducing disturbances. It ensures a good performance in decoupling,and improves the precision of flatness and gauge control.

现场实际数据的仿真结果表明，该方法的应用消除了参数变化产生的影响，使板形板厚控制系统具有良好的自适应跟随参数变化和抗干扰性能，解耦控制效果良好，提高了板形板厚的控制精度。

GK31030-5A High Speed Two-needle Collar Binding Machine,with the capacity of sewing heavy weight fabrics,equipped with binder and passing belt device,can make the belt automatically into the upper part tight and the lower part loose.it is available for collar binding and binding on one side of knitted underwears.

GK31030型高速中厚料三针绷缝机采用齿轮泵内循环自动润滑系统和可靠的密封方式，能保证在高速时的正常运转和衣料的洁净。装有独特的移动护针机构和上轴外支座，使其增强了缝厚能力。具备基本缝、单边压平缝和拼接缝的双面装饰缝纫功能。

The thickness of surface layer,thick angle tissue and vassular tissue were raised and the invasion and growth of Alternaria solani were hindered after applying K fertilizer,therefore the breaking－out time of the disease were delayed 3-4 d.Thus,the incidence of tomato early blight dropped.

32.0%和12%？22%。番茄茎角质层明显，厚角组织、维管组织厚度增加，占茎总横断面积比增大，细胞壁增厚，延缓茎发病时间3-4d，阻碍番茄链格孢菌的侵入和生长，使番茄早疫病发病率降低。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。