使...硬化

The lower heat-treating temperature of the case results from the fact that hypereutectoid steels are normally austenitized for hardening just above the lower critical point.

由于恰好高于低临界温度通常使过共析钢奥氏体化而硬化，所以对外层采用较低的热处理温度。

Tepals 5, rarely 1-4, erect or obliquely spreading, sometimes indurate at base after anthesis, green, equal or subequal, membranous.

花被片5，很少1-4，直立或者斜开展，有时使在基部在花后硬化，绿色，等长或近等长，膜。

In atherosclerosis, fatty plaques develop on the inner lining so that the normal flow of blood is reduced.

在动脉粥样硬化，脂肪斑块的发展对内衬，使正常流动的血液减少。

The relationship between the ratio of Ca to Si with shrinkage value was needed to be studied further.The strength of M-AAS was comparatively high, but the flexural strength was regressed in the long term. The compressive and flexural strengthes of 3 days were able to surpass 8MPa and 78MPa, respectively, and compressive strength of 90 days were all around 100MPa, but compared to flexural strength of 28 days, the flexural strength of 90 days was regressed by 19.0%. The high strength property of M-AAS associated with its hydration products and Interfacial Transition Zoo. The main hydration products of M-AAS were microcline and CSH, no calcium hydroxide was found. The coexistence of microcline and CSH worked as micro-aggregate by each other, and no weak ITZ, both resulted in its high strength. The regression of its strength was related to its high shrinkage property, because the crazing caused by shrinkage would decrease the strength, especially the flexural strength.

M-AAS强度较高，但长期抗折强度倒缩。3天抗折和抗压强度分别可超过8MPa和78MPa，90天抗压强度在100MPa左右，但90天抗折强度比28天抗折强度相比低19.0％。M-AAS的高强特性与其水化产物和界面过渡区有关，M-AAS的水化产物主要为微斜长石和CSH凝胶，没有氢氧化钙，微斜长石与CSH凝胶相互填充和配合共同起到强度的作用，M-AAS砂浆中几乎没有发现界面过渡薄弱区。M-AAS的强度倒缩现象与其收缩值较大有关，收缩会引起M-AAS硬化体内部出现微裂缝，使强度下降。

Nevertheless they may, through the temptations of Satan and the world, the prevalency of corruption remaining in them, and the neglect of the means of their preservation, fall into grievous sins; Mt 26:70,72,74 and for time continue in them: Ps 51:1,14 whereby they incur God's displeasure, Isa 64:5,7,9 2Sa 11:27 and grieve his Holy Spirit; Eph 4:30 come to be deprived of some measure of their graces and comforts; Ps 51:8,10,12 Re 2:4 So 5:2-4,6 have their hearts hardened, Isa 63:17 Mr 6:52 16:14 and their consciences wounded; Ps 32:3,4 51:8 hurt and scandalise others, 2Sa 12:14 and bring temporal judgments upon themselves.

Ps 89：31，32 1Co 11：32 3 ），但他们可以通过种种诱惑，撒旦和全世界来说， prevalency腐败的留在他们，而忽略了手段加以保存，落入他人的罪过；吨26：70，72，74和时间继续在他们：聚苯乙烯51：1，14让他们蒙受上帝的不悦，伊萨64：5，7，9 2sa 11：27和悲伤，他的圣灵；弗4：30来被剥夺了一些措施，他们的青睐和舒适；聚苯乙烯51：8，10，12重2时04分，使5：2-4，6有他们的心硬化，伊萨63：17先生6时52分16时14分和他们的良知受伤；常任32：3，4 51：8伤害和scandalise他人， 2sa 12：14和造就颞判断自己。

Innovation supervises a concept, improve and sclerotic supervisory method, make supervise real play effectiveness.

创新监督理念，改进和硬化监督手段，使监督真正发挥效力。

This new process combines hot forming and subsequent quench hardening in a single process step.

这种工艺结合了热成型和随即淬火硬化，使之在一道工序中完成。

Practice had hardened me , and i grew audacious to the last degree

习惯使我的心硬化了，我胆大到极点了。

The fracture mechanism of TWIP steel (steel1#) which contained second phase was that the microvoids nucleated due to the decreasing of binding force between austenite and second-phase or the second phase dehiscence caused by strain hardening, then the microvoids grew, got together and broke by the stress concentration during deformation.

含有第二相的TWIP钢（1＃钢）的断裂机制为：第二相和奥氏体相界面聚合力的减弱或第二相本身加工硬化导致的开裂促使微孔形核，形变过程中产生的应力集中使微孔长大、聚合直至发生断裂。

The fracture mechanism of TWIP steel (steel1#) which contains second-phase is: micro-voids nucleate due to binding force weaken between austenite and second-phase or second-phase dehiscence itself caused by strain-hardening. Micro-voids are formation, growth, coalescence and break by the stress concentration during deformation.

含有第二相的TWIP钢（如1＃钢）的断裂机制为：第二相和奥氏体相界面聚合力的减弱或第二相本身加工硬化导致的开裂促使微孔形核，形变过程中产生的应力集中使微孔长大、聚合直至发生断裂。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。