低聚反应

Urethane adduct was synthesized from decarboxylated cashew nut shell liquid,hexamethylenediisocynate and polyethylglycol,which was then reacted with melamineformaldehyde resin to form aqueous coating material.

采用天然植物油、己二异氰酸酯和聚乙二醇在较温和的条件下反应，制得了水溶性的氨基甲酸酯加成物，以此和低醚化度甲醚化三聚氰氨甲醚甲醛树脂制备了水性涂料。

When the sodium lauryl sulfate and p-octyl polyethylene glycol phenyl ether is used and its level in 3% and 6: 4 ratio, the polymerization process has the lowest coagulum and the highest monomer conversion. Higher reaction temperature and more level hydroxyl value lead to more coagulum, the latter also lead to larger particle size. The acid value has larger influence on viscosity and coagulum, there exist a best range. The emulsion particle size is larger for its hydrophilicity, most of its particles are connected together.

在含较高亲水单体的乳液聚合体系中，难以制得稳定的预乳化液，不能采用工业生产中常用的预乳化工艺，而只能采用混合单体直接滴加的方法；由于单体混合物的亲水亲油值较高，用阴离子型乳化剂十二烷基硫酸钠和非离子型乳化剂聚乙二醇辛基苯基醚混合，用量为单体总量的3％，且比例在6：4时，乳液聚合时具有最低的凝聚物含量和最高的单体转化率；乳液聚合反应温度升高，可以提高单体转化率，增加反应速度，但凝聚率相应提高；随着羟基单体含量的增加，聚合过程中凝聚率增加，聚合物乳胶粒平均直径增加；羧基单体有一个最佳的用量（2.6％），过高或过低凝聚率均提高；羧基含量对乳液的粘度有较大的影响，当羧基含量较低时，羧基含量增加，乳液粘度增加明显；含羟基乳液粒子由于含亲水基团较多，使得乳胶粒径增大，乳胶粒子大多数互相凝聚在一起，处于凝聚态。

This design is low stretch of 30,000 tons of high-strength type polyester production workshop after preliminary design, high low stretch of polyester staple fiber dosage is in the biggest species, it is PTA or dimethyl terephthalic acid and glycol as raw materials via esterification or the ester exchange reaction and condensation of terephthalic acid polymer fibre - together into glycol, this design USES Germany JiMa process, high scientific and technological content, is a kind of high strength, good elasticity, and heat resistance, good abrasion resistance, corrosion resistant polyester.

帮忙把涤纶论文绪论翻译成英语，要求不用翻译软件，可以用软件查单词本设计是"年产30000吨高强低伸型涤纶短纤维后加工生产车间初步工艺设计"，高强低伸型涤纶短纤维是涤纶短纤维中用量最大的品种，它是以精对苯二甲酸或对苯二甲酸二甲酯和乙二醇为原料经酯化或酯交换和缩聚反应而制得的成纤高聚物——聚对苯二甲酸乙二醇酯，本设计采用德国吉玛工艺，科技含量较高，是一种强度高、弹性好、耐热性好、耐磨性好、耐腐蚀的涤纶短纤维。

A dimeric catalyst is formed from titanium main catalyst and alkylauminium cocatalyst and the copolymerization catalyst is formed from metallocene catalyst and corespondent cocatalyst, and the above-mentioned both catalysts are formed into the invented double-function catalytic system which can directly make ethylene implement dimerization in same polymerization system, and at the same time, produce copolymerization reaction to form linear low-density polyethylene.

一种用于由乙烯合成线性低密度聚乙烯的双功能催化体系，二聚催化剂由钛系主催化剂和烷基铝助催化剂组成，共聚催化剂由茂金属催化剂和相应的助催化剂组成，这两种催化剂组成的双功能催化体系，可在同一聚合体系中，直接使乙烯二聚的同时就地发生共聚反应，生成线性低密度聚乙烯。

In this experiment, the depolymerization of chitosan by hydrogen peroxide was studied.

本实验使用过氧化氢来进行几丁聚醣之去聚合反应以制备低分子量几丁聚醣。

This dissertation aims to: improvement in regularity of ladderlike polysiloxane through strong H-bonding template and"half-water-hydrolysis"methods; synthesis of several functional polysilsequioxane with ethoxyl, hydro and aminopropyl groups respectively; and the preparation of nanoporous film with good mechanic properties from ladderlike functional polysilsesquioxane with intermolecular porogen via micro-phase separation process.

本论文旨在利用强氢键模板作用和"半水水解-脱氯化氢缩聚"的改进方法，提高反应性的梯形聚硅氧烷的规整度；合成乙氧基封端、含氢基和氨丙基的几种功能性梯形聚硅氧烷；以及探索利用含分子内成孔剂的梯形聚倍半硅氧烷通过微相分离制备低介电常数二氧化硅纳米微孔膜。

The experimental results showed that the lower the viscosity of the oligomer, the better the improvement of the powdering; when the content of the oligomer in the phenolic resin was 3%, the powdering of the modified foam was only 40% of that of non-modified foam, with elastic resilience higher than 60%; The mechanism of the ...

结果表明：预聚物的粘度越低，对酚醛泡沫的粉化性的改善效果越好；当预聚物的质量分数为 3 %时，改性泡沫的粉化程度仅为未改性的 40 %，且使泡沫具有一定的弹性，回弹率大于 60 %；聚氨酯预聚物对酚醛泡沫塑料的改性机理不是简单的物理共混，同时伴有共聚反应发生。

With the acid and alkali titrate method,we got the mean molecular weight and discussed the monomer density,the initiator amount used, chain transfer agent factor as well as reaction temperature to molecular weight influence tendency and d.

聚丙烯酸钠在很多领域的广泛应用，我们采用水溶液聚合法中的中和法合成低分子量聚丙烯酸钠，用酸碱滴定的方法测得聚丙烯酸的平均分子量，并探讨了单体浓度、引发剂用量、链转移剂用量以及反应温度等因素对聚丙烯酸钠分子量的影响趋势和程度。

Good thermal stability and self-extinguishing behavior was observed with the cured polybenzoxazine resins. Second, furan-containing benzoxazine monomers, P-FBz, BPA-FBz, and 4FP-FBz were prepared using furfurylamine as a raw material. Formation of furfurylamine Mannich bridge networks in the polymerizations of P-FBz and BPA-FBz increased the cross-linking densities and thermal stability of the resulting polybenzoxazines. P-FBz and BPA-FBz- based polymers also exhibited high glass transition temperatures above 300℃, high char yields, and low flammability with a limited oxygen index value of 31. The dielectric (Dk3.21–3.39) and mechanical properties (high storage modulus of 3.0–3.9 GPa and low coefficient of thermal expansion of 37.7– 45.4 ppm) of the P-FBz and BPA-FBz-based polymers were superior or comparable to other polybenzoxazines. 4FP-FBz used for polybenzo- xazine modification by means of formation of benzoxazine hybridation with P-FBz.

第二部份以2-呋喃甲胺为起始物，制备了P-FBz、4FP-FBz与BPA-FBz 三个含呋喃官能基之氧代氮代苯并环己烷的单体；BPA-FBz与P-FBz於开环聚合中形成之Mannich bridge网状结构有效地提升聚氧代氮代苯并环己烷聚合物之交联密度与热安定性；Poly与Poly具有大於300℃之玻璃转移温度、高的焦炭生成率与具有31之极限氧指数(Limited oxygen index， LOI)的难燃性特质，Poly与Poly之介电常数(Dk=3.21~3.39)与机械性质[3.0~3.9 GPa的储存模数与37.7~45.4ppm之低热膨胀系数( Low coefficient of thermal expansion， Low CTE)]均较其他聚氧代氮代苯并环己烷为优；4FP-FBz具有低之介电常数(Dk=2.7)，以其作为降低介电常数之反应型改质剂，与P-FBz混成，证实可有效地降低Poly的介电常数。

To avoid the low yield in direct hydrosilylation addition of allyamine, 1, 1, 1, 3, 3, 3-hexamethyldisilazane is used to protect the amino groups, and the protective groups are removed easily after hydrosilylation addition, then the high yield of ladderlike copolymethyl-aminpropylsilsesquioxane was obtained.

为了克服将烯丙基胺直接与聚氢基甲基倍半硅氧烷进行硅氢加成反应接枝效率低的缺点，探索用六甲基二硅氮烷对烯丙基胺预保护，硅氢加成反应后再脱保护，从而以较高产率制备了含胺丙基、甲基的反应性梯形共聚倍半硅氧烷。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。