低功率

The results show that signal in FEL amplifier with a coaxial hybrid wiggler can get an efficient amplification even at a low voltage of 205 kV.

粒子模拟结果表明，这种同轴摇摆器结构FEL在工作电压较低(205 kV)的情况下仍可以得到较好的放大输出，效率达到27.3％，饱和功率达到兆瓦级；等离子体填充对器件的性能有一定的影响，改善了束流传输特性。

Firstly, it is difficult to densify CeO2 based solid electrolyte materials and a sintering temperature above 1600℃is required to prepare dense CeO2 based solid electrolyte materials by the conventional solid-state reaction method;Secondly, doped ceria are brittle materials and have weak mechanical strength, which would be susceptible to fracture due to thermal stresses and mechanical stresses during cell fabrication and operation; Thirdly, electronic conduction will be introduced because of the reduction of Ce4+ under low oxygen partial pressure, which would reduce the output voltage and output power of the cells.

其一，CeO_2基电解质材料难以致密化，用常规的固态反应法制备的CeO_2基电解质粉体需要在1600℃以上烧结才能达到致密化；其二，CeO_2基电解质为脆性材料，机械强度低，使其容易在电池的制造及运行过程中由于热应力及机械应力而破裂；其三，CeO_2基电解质在燃料极一侧由于Ce4+还原为Ce3+出现电子导电，降低电池的输出电压和输出功率，影响电池的性能。

Firstly, it is difficult to densify CeO2 based solid electrolyte materials and a sintering temperature above 1600℃is required to prepare dense CeO2 based solid electrolyte materials by the conventional solid-state reaction method;Secondly, doped ceria are brittle materials and have weak mechanica...

其一，CeO_2基电解质材料难以致密化，用常规的固态反应法制备的CeO_2基电解质粉体需要在1600℃以上烧结才能达到致密化；其二，CeO_2基电解质为脆性材料，机械强度低，使其容易在电池的制造及运行过程中由于热应力及机械应力而破裂；其三，CeO_2基电解质在燃料极一侧由于Ce4+还原为Ce3+出现电子导电，降低电池的输出电压和输出功率，影响电池的性能。

The furnace body is made ф2200×1500 the outer covering main body by the 12mm steel plate, lower part the furnace body 45° the installment has the sensor, the sensor orientation silicon steel plate is made the weight 2 ton induction iron cores by Wuhan Steel Corporation Silicon steel plate Factory production top gear's W-151 the cold rolling 0.35m/m, primary is made the water cooling coil by 10×10×2 the copper pipe, and installs the stainless steel water cooling restricting, the power frequency has the core smelting furnace's metal melt fluid namely for the sensor sencondary coil, the entire electric stove is a transformer actually, the necessary 6 grades from the pair regulating transformer, shift gears by the electricity cabinet control, the voltage may from low to high, divide 6 promotions to arrive at 380V, each grade of voltages are different, the output is also different, the furnace temperature along with the files position is also different, but the height is different, adapts smelts colored or the black and so on melting point different metals, and may make the new furnace lining to smelt diamantine drying furnace fireproof.

炉体由12mm钢板制成Ф2200×1500外壳主体，炉体下部45°安装有感应器，感应器由武钢硅钢片厂生产的最高档的W-151冷轧0.35m/m取向硅钢片制成重2吨感应铁心，初级由10×10×2铜管制成水冷线圈，并安装不锈钢水冷保护套，工频有芯熔炼炉的金属熔液即为感应器的次级线圈，整个电炉实际就是一个变压器，配套一台6档的自耦调压变压器，由电柜控制换档，电压可由低到高，分6级升到380V，每档电压不同，输出功率也不同，炉温也随档位不同而高低不同，以适应熔炼有色或黑色等熔点不同的金属，并可作新炉衬耐火冶金砂烘炉之用。

The furnace body is made ф2200×1500 theouter covering main body by the 12mm steel plate, lower part the furnace body 45° the installment has the sensor, the sensor orientation silicon steel plate is made the weight 2 ton induction iron cores by Wuhan Steel Corporation Silicon steel plate Factory production top gear's W-151 the cold rolling0.35m/m, primary is made the water cooling coil by 10×10×2 the copper pipe, and installs the stainless steel water cooling restricting, the power frequency has the core smelting furnace's metal melt fluid namely for the sensor sencondary coil, the entire electric stove is a transformer actually, thenecessary 6 grades from the pair regulating transformer, shift gears by the electricity cabinet control, the voltage may from low to high, divide 6 promotions to arrive at 380V, each grade of voltages are different, the output is also different, the furnace temperature along with the files position isalso different, but the height is different, adapts smelts colored or the black and so on melting point different metals, and may make the new furnace lining to smelt diamantine drying furnace fireproof.

炉体由12mm钢板制成Ф2200×1500外壳主体，炉体下部45°安装有感应器，感应器由武钢硅钢片厂生产的最高档的W-151冷轧0.35m/m取向硅钢片制成重2吨感应铁心，初级由10×10×2铜管制成水冷线圈，并安装不锈钢水冷保护套，工频有芯熔炼炉的金属熔液即为感应器的次级线圈，整个电炉实际就是一个变压器，配套一台6档的自耦调压变压器，由电柜控制换档，电压可由低到高，分6级升到380V，每档电压不同，输出功率也不同，炉温也随档位不同而高低不同，以适应熔炼有色或黑色等熔点不同的金属，并可作新炉衬耐火冶金砂烘炉之用。

LED light source is characterized by long service life which can be 80,000 to 100,000 hours, over five times that of traditional light source, and low energy consumption. With an over 90% electrooptic power, it can save over 80% energy when compared to traditional lighting.

LED光源使用寿命长：可达到8万~10万小时，是传统光源寿命的5倍以上；低耗能：电光功率达90%以上，比传统照明效率节能80%以上。

Thus, good machinability good surface finish and integrity, long tool life, and low force And power requirements.

以这种方式，好的可机加工性指的是好的表面光洁性和完整性，长的刀具寿命，低的切削力和功率需求。

Firstly analyzed the operation principle of BDFM;then used the method of parameters calculation based on magnetomotive force and magnetic conductance,and calculated the inductance parameters.

针对目前无刷双馈电机两套不同极数定子绕组之间，耦合能力弱而导致该类型电机功率密度低及性能指标差的问题，以结构简单易于制造的普通凸极磁阻转子BDFM为例，研究了转子极数对电机耦合能力的影响。

Application of SA866AE Three-phase PWM Signal Generator in AC/AC FC;2. By existing control question of mineral air compressor and power supply particularity in mine,using Mitsubishi corporation's IPM power module as main circuit component,METEL corporation's SPWM generator SA866AE as wave profile generator,a kind of transducer was designed.

针对矿用空压机控制存在的问题和矿山供电的特殊性，利用三菱公司IPM功率模块作为主电路器件，METEL公司的SPWM发生器 SA866AE 作为波形发生器，设计了一种宽输入电压范围、低成本、高可靠性的变频器，实现了矿用空压机的自动调节功能，节约了能源，提高了供气质量。

A18430 Maximum Ratings: A18430 Pinout: DC input range: 180 - 375V Input surge withstand: 400V for 100ms DC output: 3.3V Programmable output: 10 to 110% Regulation: 0.2% Efficiency: 77.5% Maximum operating temperature: 100C at full load Power density: 60W/cubic inch Height above board: 0.43 in.(10,9 mm) Parallelable, with N+M fault tolerance Low noise ZCS/ZVS architecture

A18430最大额定值： A18430引脚说明：直流输入范围：180 - 375V输入浪涌承受：为100ms的400V的直流输出：3.3V的可编程输出：10至110％调节：0.2％的效率：77.5％最大工作温度：100C读写器在满负荷功率密度：60W/cubic英寸高光明正大：0.43英寸（10.9毫米）可并行与N +男容错低噪音零电流/零电压架构

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。