低

The establishment of MICable Inc. exhibits the ideal cooperation between US technology experience and China's low manufacturing cost. Micable will provide high performance andlow cost microwave co-axial cable assemblies for Chinese and global customers.

迈可博电子科技有限公司的成立是美国的高技术与中国的低制造成本完美的结合，通过美国SSI CABLE CORPORATION公司在中国完善的市场营销网络，可以为全球的微波射频同轴电缆组件用户提供高性能、低成本的产品解决方案。

When the sodium lauryl sulfate and p-octyl polyethylene glycol phenyl ether is used and its level in 3% and 6: 4 ratio, the polymerization process has the lowest coagulum and the highest monomer conversion. Higher reaction temperature and more level hydroxyl value lead to more coagulum, the latter also lead to larger particle size. The acid value has larger influence on viscosity and coagulum, there exist a best range. The emulsion particle size is larger for its hydrophilicity, most of its particles are connected together.

在含较高亲水单体的乳液聚合体系中，难以制得稳定的预乳化液，不能采用工业生产中常用的预乳化工艺，而只能采用混合单体直接滴加的方法；由于单体混合物的亲水亲油值较高，用阴离子型乳化剂十二烷基硫酸钠和非离子型乳化剂聚乙二醇辛基苯基醚混合，用量为单体总量的3％，且比例在6：4时，乳液聚合时具有最低的凝聚物含量和最高的单体转化率；乳液聚合反应温度升高，可以提高单体转化率，增加反应速度，但凝聚率相应提高；随着羟基单体含量的增加，聚合过程中凝聚率增加，聚合物乳胶粒平均直径增加；羧基单体有一个最佳的用量（2.6％），过高或过低凝聚率均提高；羧基含量对乳液的粘度有较大的影响，当羧基含量较低时，羧基含量增加，乳液粘度增加明显；含羟基乳液粒子由于含亲水基团较多，使得乳胶粒径增大，乳胶粒子大多数互相凝聚在一起，处于凝聚态。

The friction performances of carbon face were investigated with an inertia friction tester. The torque curve of carbon face was ideal, the coefficient of static friction was lower than that of dynamic in 0.28 MPa, the friction coefficient of static and dynamic decreased with the braking pressure increasing. To the fiber face, the coefficient of dynamic friction of carbon face was more stable in cycle braking process, the wear rate was lower, and it was efficient to protect the couple plate not to be worn.

结果表明：碳质层的摩擦力矩在制动初期上升较快，中间过渡区平稳，尾部翘起较小；在制动压力小于0.28 MPa时静摩擦系数小于动摩擦系数，且动、静摩擦系数均随制动压力增加而减小；相对纤维层而言，采用碳质层摩擦时摩擦力矩曲线形态更好，连续制动时摩擦系数波动较小，磨损率低且能够有效保护偶件，是1种静/动摩擦系数比较低且适用于高载荷工况条件下使用的摩擦材料。

The friction performances of carbon face were investigated with an inertia friction tester.The torque curve of carbon face was ideal,the coefficient of static friction was lower than that of dynamic in 0.28 MPa,the friction coefficient of static and dynamic decreased with the braking pressure increasing.To the fiber face,the coefficient of dynamic fric...

结果表明：碳质层的摩擦力矩在制动初期上升较快，中间过渡区平稳，尾部翘起较小；在制动压力小于0.28 MPa时静摩擦系数小于动摩擦系数，且动、静摩擦系数均随制动压力增加而减小；相对纤维层而言，采用碳质层摩擦时摩擦力矩曲线形态更好，连续制动时摩擦系数波动较小，磨损率低且能够有效保护偶件，是1种静/动摩擦系数比较低且适用于高载荷工况条件下使用的摩擦材料。

When the density of sample is low, the samples coefficient of thermal expansion is low, which may mainly because of the effect of porosity.

而在较低致密度情况下，孔隙率对材料热膨胀系数的影响占据了主要作用，因此试样的热膨胀系数较低。

In the case of keeping enough energy product, to improve the coercively and reduce the temperature coefficients of the magnets reelects as so as possible. It will be truth to produce high coactivity. Low temperature, heat-resistant magnets; use the low cost composition materials.

采用合适的热处理工艺，控制组织结构，保证足够磁能积的基础上，尽可能得到高的矫顽力和低的温度系数，使低成本配比的原料生产出高矫顽力、高使用温度的耐热烧结NdFeB永磁体。

High permeability, low coercivity and low loss can improve the efficiency of power supply.

高磁导率、低矫顽力、低损耗能提高电源效率。

Fe-6.5wt%Si steel is one kind of soft magnetic materials with high permeability, low coercivity and iron loss.

高硅钢（6.5%Si）是一种具有高磁导率、低矫顽力和低铁损等优异软磁性能的合金。

In the choice of the external retaining wall system materials, the project selected舒布洛克system walls, lateral tiling or stone can be effectively reduced "cold bridges" and other adverse effects; form of aluminum material selection alloy bridge frame off the cold feed and double Low-E Low-e insulating glass, energy-saving effect; Roofing Shop increases by 50 mm thick rigid polyurethane foam.

在选择外部挡土墙系统材料，该项目选定舒布洛克系统墙壁，横向分块或石头，可以有效地减少了"冷桥"和其他不利影响；形式的铝材料选用合金框架桥从冷喂料和双低辐射低辐射中空玻璃，节能效果；屋面铺增加了50毫米厚的硬质聚氨酯泡沫塑料。

In addition, the company兼营pin barrel cold feed rubber extruder, this product is the new generation of rubber extruder, can replace imported products, and old-fashioned extruder compared to pin barrel cold Feeding rubber extruder with an high degree of automation, out of capacity, low energy consumption units, plastic ranked lower temperatures, dense products with good quality high.

除此之外，公司兼营销钉机筒冷喂料橡胶挤出机，本产品是新一代橡胶挤出机，完全可以替代进口产品，和老式挤出机相比，销钉机筒冷喂料橡胶挤出机具有适自动化程度高、挤出能力大、单位能耗低、排胶温度低、制品致密性好、质量高等特点。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。