位置参数

The effect of the feed seawater temperature, the heating steam temperature of NO.1 evaporator, the concentration ration, the steam extraction, the quantity and location of preheat flow, the form of TVC on performance of a distiller is discussed. Not only serial flow and parallel flow, but also system with and without TVC was compared.

利用求解结果，针对进口海水温度、第一效加热蒸汽温度、系统浓缩比、电厂抽汽参数、外界热源预热量以及预热位置、热压缩布置形式等参数对系统性能的影响进行了分析与比较，同时分别针对串联和并联流程、有热压缩和无热压缩的低温多效海水淡化系统方案进行分析。

A series of experiments were conducted to measure the variation of alignment during wheel jouncing; meanwhile, the influence of ...

通过试验综合考察了车轮跳动过程中车轮定位参数的变化，以及转向梯形断开点的垂直位置对车轮定位参数的影响。

A series of experiments were conducted to measure the variation of alignment during wheel jouncing; meanwhile, the influence of breaking point of steering trapezoid on alignment was also investigated.

通过试验综合考察了车轮跳动过程中车轮定位参数的变化，以及转向梯形断开点的垂直位置对车轮定位参数的影响。

Based on the meaning of object state in tracking theory, a novel representation for object state is proposed, which differs from traditional one with only locomotors state. In this thesis, model parameters may also represent the object state in according to different situations. Thus, the localization and characters of object are filtered synchronously, which accelerates the matching and tracking speed in real-time tracking system, especially for complicated object. In summary, this thesis studies the methods of template obtaining, updating and matching, etc.

从跟踪理论的目标状态所表示的意义出发，提出了将目标模型参数与运动参数同时作为目标状态进行滤波的方法，改变了传统方法中只利用目标运动状态的情况，在确定目标位置的同时能够匹配目标轮廓或其他特征，对于复杂的目标，可以快速鲁棒的完成视频帧中的模板匹配和跟踪。

The mid-position of a plant xj can be given as a fixed parameter or may be altered randomly each time step using the parameter xx to initialise the randomiser see switch "SpatialDistribution" random vs.

植被的中间位置 xj 可作为固定参数给出，或者用参数 xx 初始化随机值，在每个时段随意改变它见开关&空间分布&随机

This parameter canaccurately describe the degree of concentration of vibratory energy of the systemmodal shape in quantity. Using this parameter, the effects of mistuning on thelocalization of system modal shapes for various orders are studied. The reasons of themodal localization phenomenon are analyzed by the perturbation method.

利用所提出的模态局部化参数，研究了失谐对叶盘系统各阶模态局部化程度的影响规律，并利用摄动法对失谐所导致的模态局部化现象进行了分析；同时还发现，失谐叶盘系统的某些中间阶模态的局部化参数值在弱耦合区域的特定位置会产生奇异的突变现象，而这种突变现象是用摄动法难以解释的，并且可能会对失谐叶盘系统的振动稳定性产生重要影响。

Through analysis to the pumping unit's load characteristic, the relationship between the position of the suspension point load's peak value and the oil well's parameters has been obtained and a new method about the transforming of the pumping unit with downward beam balance weight is proposed.

分析常规游梁式抽油机的载荷特性，得出悬点载荷的峰值出现的位置与井况参数的关系，提出一种下偏杠铃抽油机改造方法，依据油井抽汲参数调节下偏杠铃的角度，使其最大力臂与悬点最大载荷对应，提高抽油机的平衡效果。

The joint has great effect on the strength and stability of rock mass, the effect degree directly relates to joint's geometry and mechanics parameters, including the joint's strike, dip angle, location, thickness, stiffness, strength et al.

节理对岩体强度和稳定性有重要的影响，其影响程度直接与节理的几何参数和力学参数相关，包括节理的走向、倾角、位置、厚度、刚度、强度等。

The tree diameter at breast height and crown length can be used to predict the size and location of mean knot diameter in a whorl.A linear mixed model expressed as function of tree and knot variables such as HK、RKD、KD and DBH was used to predict sound knot length,and a log-linear mixed model using RKD and DBH as variables was used to describe loose knot length.4.A knot has four development phases:from the birth of a branch to its growth cessation,from growth cessation to death,form death to occlusion and form birth to occlusion.The numbers of annual rings in four periods,as well as the stem width of respective zones were used as dependent variables predicted by models expressed as function of tree variables and knot attributes.5.Using the data of diameter out side bark of 15 relative heights along the step,the best taper equation for Larix olgensis was established.

节子平均直径可以用以胸径，冠幅和节子高度为参数的舒马克生长方程来预测，用树木胸径和冠长可对每轮节子平均直径的最大值及位置进行预测；健全节长度可用以节子着生高度、相对直径、节子直径以及树木胸径为参数的线性混合模型来预测，疏松节长度采用节子相对直径和胸径为自变量的可转化为线性模型的自然对数模型来预测；4、节子有四个生长发育时期：从枝条形成到生长停止BC从生长停止到死亡(CD从死亡到包藏DO从形成到包藏

The flow parameters, which controlled the heat transfer phenomena in the coolant channel of the piston, are identified; the experimental facilities and program will be established in accordance with the parametric conditions experienced by a real marine diesel engine. The experimental result for the flow within smooth-walled duct under the reciprocating motion will be used as the reference datum to assess the results for the study of heat transfer augmentation. As an attempt to enhance the cooling performance, the ribs will be installed in the coolant channels which flow was orthogonal mode for the piston moving direction. Finally, the results obtained for the tests with heat transfer augmentation devices will be compared with the smooth-walled test results.

本研究计画利用座标转换理论，对受到与往复运动正交方向之流场进行参数分析，建立控制此流场热传性能之参数后，模拟实际船舶主机运转时活塞之冷却情形并进行实验量测，作为评估活塞冷却之基准，然后应用现行已实用於工业界的技术，在与往复运动正交方向之圆形冷却通道中加装凸起物以增加热传效能并予以测量其热传系数及其相关之物理现象，据以讨论此流场受往复力之影响，在周向不同位置之热传情形以及其与平行於往复运动方向之流场的差异。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。