位置

The TLC of them were concordance.They presented the same color fluorescence in the corresponding position at the ultraviolet light(365nm). After the vanillic aldehyde sulphuric acid ethanol solution developed, violet color spots presented at the same place.

生远志正丁醇部位色谱和蜜远志正丁醇部位色谱基本一致：紫外灯（365 nm）下二者在相应位置呈相同颜色荧光，香草醛硫酸乙醇溶液显色后二者在相应位置的几个斑点均呈紫罗兰色，且远志皂苷元对照品斑点呈紫罗兰色，而在与其相应位置生远志供试品和蜜远志供试品均未检视到相应斑点。

This research method is to use the three-dimensional mapping software to draw the cardiovascular stent of different size first , next is it create their cardiovascular stent boundary conditions and simulation their of support after implantation according to finite element method into the human body to go; Receive different residue pressures and pressure of the repeated blood circulation , greatest stress , meets an emergency and the relation between total deformation amount caused; Being imitated the cardiovascular stent , the position with damage of fatigue life in the blood vessel by its greatest stress value at the same time ; But by the simulation result of the above , can understand that use life of Palmaz-schatz cardiovascular stent has been more than 109 up till now ; At the same time , can know the position where the stress two times concentrates , the right angle position joined in the rib and rib of Palmaz-schatz cardiovascular stent too.

本研究的方法乃是先会使用三维绘图软体画出不同尺寸的血管支架，然后在根据有限元素法去设定其血管支架的边界条件和模拟其植入人体后；受到不同的残留压力与反覆血液流动的压力，所造成的最大应力、应变及总变形量之间的关系；同时在由其最大应力值去模拟血管支架，在血管中的疲劳寿命与疲劳损坏位置；然而由以上的模拟结果，可以了解到目前Palmaz-schatz血管支架之使用寿命为109以上；同时也可以知道二次应力集中的位置，在Palmaz-schatz血管支架之肋和肋连接的直角位置。

First, this paper presents three girders model with double cable planes which main girder and side girder is connected by rigid arms, analyzes the dynamic characteristic of Yonghe cable-stayed bridge and obtains its natural vibration modes (i.e., frequency, damping values and the mode shapes ) by ANLSIS structural analysis program and uses these parameters as dynamic dactylogram of the intact case of cable-stayed bridge. Using the passage of random as the ambient vibration ,the dynamic properties of Yonghe Bridge is measured and the modal parameter of its 15 years after is identified and used as dynamic dactylogram of the damaged case. By the finite element analysis and locale vibration test, damaged and undamaged modal parameter is analyzed and curvature mode shape, which is sensitive to damage state, is introduced as possible candidate for identifying and locating damage in the cable-stayed bridge. Selecting the branch of part measured point from modal parameter, this paper deduces the damaged index which can detect the possible damaged location of the cable-stayed bridge deck and identifies the damaged region and degree for Yonghe Bridge. For the purpose of structural condition monitoring in in-situ , from another viewpoint, this paper introduces the method called the best optimization vector to detect damaged location and degree. The accuracy and reliability of the method presented in this paper are demonstrated by static analysis and test and the healthy state of Yonghe Bridge can be evaluated.

建立了双索面通过刚臂与主梁及边梁相连的三梁式力学模型，采用ANSYS结构分析程序对永和斜拉桥进行动力分析，对其振动模态参数进行识别，以此作为斜拉桥完好状态下的动力&指纹&；采用自由交通流作为环境振源，对永和斜拉桥动力特性进行测试，识别出永和斜拉桥使用15年后的模态参数，确立了破损状态下的动力&指纹&；利用有限元分析、现场振动测试，对破损前后的模态参数进行分析，提取对破损状况较敏感的模态曲率作为斜拉桥破损诊断的参数；并从模态参数中选取部分点的分量，导出可以指示斜拉桥桥面大概损伤位置的Index损伤指标，识别出斜拉桥发生破损的区段及破损程度；考虑大型斜拉桥在线监测要求识别破损的具体位置，从另一角度提出采用最优矢量法具体确定破损发生的位置及程度；为验证本文研究成果，对永和斜拉桥进行静力分析及静力测试，对其健康状况提出可靠的评价。

For example, butt welds in plate the highest heat input position is normally PF and the lowest PC. For fixed pipe welds the hardness tests shall be taken from the overhead welding position

例如，板的对焊，其最高热输入位置通常为PF，最低热输入位置通常为PC，对固定的管焊接，硬度试验用试件应取自上面的焊接位置。

A circle shear device for cutting holes in sheet metal as in claim 13 wherein said upper center shaft is vertically reciprocated between a first upward rest position and a second lowered operating position wherein: a said first upward position raises said first upper cutter wheel a sufficient distance to permit the unobstructed exchange of additional provided metal sheet through said cutting jaw; and b said vertical reciprocation means includes an pneumatic air cylinder.

削减的孔一个圆盘剪设备在金属板在要求13，说的上部中轴垂直被交换在第一个向上静止位置和第二个被降下的工作位置之间，： a首先说的向上位置培养说的第一个上部切削刀轮子一个充足的距离通过说的切开的下颌允许另外的提供的金属板通畅的交换；并且 b说的垂直的往复手段包括一个气动力学的空气圆筒。

This allows the user to control a Sigma-5 amplifier with an EtherCAT master in a variety of different modes (cyclic synchronous position, cyclic synchronous velocity, cyclic synchronous torque, interpolated position, profile position, profile velocity, or profile torque) and system architectures (line, star, tree, or daisy chain).

用户可以利用EtherCAT设备以多种不同的模式（同步循环位置，同步循环速率，同步循环转矩，替换位置，剖面位置，速度分布剖面图，扭矩剖面图）和系统结构（直线状，星状，网状以及链状）控制Sigma-5伺服放大器。

A dance position where the leader's left side and the follower's right side are in contact or almost in contact, and the opposite sides of their bodies are open in a V-Shaped position, leader looking right and follower looking left.

Counter Promenade Position 反行进位置：男士的左侧与女士的右侧接触或几乎接触，两人身体另一侧打开呈V字形位置，引导者在右，跟随者在左，是PP的反向位置。

When entering the diaphragm pressure on the top of the control room to the atmosphere or water by the downstream area of low pressure, the role of the bottom plate in the valve and the pressure below the diaphragm on the pressure value is greater than the top, so the main valve disc to the fully open position; when entering the diaphragm pressure above the control room can not water the lower reaches of the atmosphere or area of low pressure, the role of the diaphragm on the top of the pressure value is greater than the pressure below the value, so will the main valve pressure valve set to fully closed position; when the diaphragm pressure above the value of the control room at the entrance of the middle pressure and outlet pressure, the main valve in the regulator valve on the disk, and its regulation depends on the location of the needle-catheter system and adjustable valve guide of the role of joint control.

当阀门进入隔膜上方控制室内的压力水被排到大气或下游低压区时，作用在阀盘底部和隔膜下方的压力值就大于上方的压力值，所以将主阀阀盘推到完全开启的位置；当进入隔膜上方控制室内的压力水不能排到大气或下游低压区时，作用在隔膜上方的压力值就大于下方的压力值，所以就会把主阀阀盘压到完全关闭的位置；当隔膜上方控制室内的压力值处于入口压力与出口压力中间时，主阀阀盘就处于调节状态，其调节位置取决于导管系统中的针阀和可调导阀的联合控制作用。

When entering the diaphragm pressure on the top of the control room to the atmosphere or water by the downstream area of low pressure, the role of the bottom plate in the valve and the pressure below the diaphragm on the pressure value is greater than the top, so the main valve disc to the fully open position; when entering the diaphragm pressure above the control room can not water the lower reaches of the atmosphere or area of low pressure, the role of the diaphragm on the top of the pressure value is greater than the pressure below the value, so will the main valve pressure valve set to fully closed position; when the diaphragm pressure above the value of the control room at the entrance of the middle pressure and outlet pressure, the main valve in the regulator valve on the disk, and its regulation depends on the location of the needle-catheter system and adjustable valve guide of the role of joint control.

当进入隔膜上方控制室内的压力水被排到大气或下游低压区时，作用在阀盘底部和隔膜下方的压力值就大于上方的压力值，所以将主阀阀盘推到完全开启的位置；当进入隔膜上方控制室内的压力水不能排到大气或下游低压区时，作用在隔膜上方的压力值就大于下方的压力值，所以就会把主阀阀盘压到完全关闭的位置；当隔膜上方控制室内的压力值处于入口压力与出口压力中间时，主阀阀盘就处于调节状态，其调节位置取决于导管系统中的针阀和可调导阀的联合控制作用。

Mark the fix position of the hinge on the door pocket.

把门扇临时固定在对应的安装位置上，并调整至准确位置，在门套上标出铰链固定位置

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷