伺服系统

In this paper, a high performance digital servo-system based on an industrial control computer is studied.

本文研究了一种以工控机作为控制计算机的高性能数字伺服系统。

Finally, the design of the Servo-System for the jet is introduced.

最后，本文对机载伺服系统进行了初步设计。

In the first part, a style of digital Servo-System is developed, which will be applied to the electronic interference device.

第一篇介绍用于某型通用电子干扰设备的数字伺服系统的研究。

The modem closed-loop AC servo-system controlled by PLC and transducer were used in this study.

本文采用先进的由PLC控制、变频器驱动的闭环交流伺服系统。

Based on analyzing the components and control of the servo-system of the NC machine tools, this paper studies the methods for setting parameters in each loop to guarantee the performance of the machine tools.

本文在分析了数控机床交流伺服系统组成、控制的基础上，研究了各环节的参数设定方法，以保证机床达到良好的运行状态。

Hydraulic servo-system Fault detection Dynamic neural network Output recurrent network

液压伺服系统；故障检测；动态神经网络；输出递归网络

In the article, stepper motor controlled by CAN bus is studied; controller of single stepper motor is designed; the motion of step servo-system controlled by CAN bus is researched.

重点研究了通过CAN总线控制的步进电机，设计了模块化步进电机控制器，研究了CAN总线控制步进伺服系统的运动。

For servo-system of permanent magnet linear synchronous motor, the paper gave a new fuzzy controller with self-organizing and self-regulating factor .

就PMLSM伺服系统，应用新型的自组织自整因子模糊控制器。

Experimental results show that the new method is effective in identification and control of servo systems.

在实验室条件下进行了神经网络伺服系统补偿控制的实验研究。

On the base of the simulation, the software and hardware of servo system were designed.

根据仿真结果，本文完成了伺服系统的软、硬件设计。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。