传动

Refer to the damage problem to the motor of C41-400 air hammer caused by driving system fault, an acknowledged improvement that is adding a V-belt driving into the system has been promoted with failure situations occasionally because of irrational supporting structures.

针对C41-400型空气锤由于传动系统故障而导致电动机损坏的问题，通常的改进方案是增加一级V带传动，但由于对改造中的支承设计不合理而失败的情况也时有发生。

And linking the principle of choosing computer visual inspection system hardware, the paper constructs hardware structure of visual inspection system, and develops measure software of thread geometry parameter and applies all above research results to quantificationally measure geometry parameters such as half angle of thread, coning and pitch of conical joint screw thread of graphite electrode, at last educes influencing expressions of the shelter of lead angle to half angle of thread change, it establishes theory base for error amendment.

论述了微小零件尺寸及形状误差的常用测量方法，提出了将视觉检测技术应用到微小零件尺寸及形状误差的测量中，构建了视觉检测系统的硬件结构，开发了相应的测量软件，应用第三章介绍的各种边缘检测方法对传动用滚子链链板进行了边缘检测对比实验，找出适合的边缘检测方法，并应用上述各章的研究结果对传动用滚子链链板节距以及圆形零件的圆度误差进行了测量。

The cooling system is an important part of the electric transmission of armored vehicles.

电传动冷却系统是装甲车辆电传动系统的重要组成部分之一。

The paper introduces the SPM auxiliary drives in CCM line, and the control methods and parameters set of 6SE70 Inverter, with many networks, actualized accurate control of drives and safety.

摘 要：介绍了冷轧生产线平整机辅传动系统以及6SE70变频器的控制方式和参数设置，运用多种网络实现了传动系统的高精度控制和安全运行。

And then it design and compulate for the strip transmission of the transmission system. And it also design for the gears, axis, bond and the axletree of the retarder. And then it proofreads their intension.

然后对传动系中带传动进行设计计算，另外还对减速器中的齿轮，轴，键以及轴承进行设计以及强度的校核计算。

Driving components are installed on backboard of equipment to gurantee high driving accuracy and low mechanical consumption.

传动构件安装在设备底板上，传动精度高，机械损耗低。

A simulation model base vector control was built for the electric-wheel of the self-developed electical drive truck.

针对自行设计的交流电动轮驱动重型卡车电传动系统，建立基于矢量控制的传动系统仿真模型。

A new air seal equipment, that is the high minus pressure contact airproof technology for wind box of the head and tail of sinter machine, without riveting twin sheet iron are proposed.

针对这一问题提出了新的密封结构——高负接触头尾密封装置、无铆接双板簧和新的传动方式——星轮传动的变齿距设计以及增设尾部液压阻尼装置。

V belt driving device developed is superior to flexible plate coupling and roller chain driving in VNH behavior, working endurance and axial and lateral offset tolerance.

所开发的三角带传动装置在振动噪声性能、作寿命和对轴向以及径向偏心的容忍度等方面都优于常用的柔性板式联轴器和高速滚子链传动装置。

A transmission project combining differential gear with axis-fixed gear train s is put forward.

介绍和分析常用齿轮增速箱传动方案，提出一种差动轮系与定轴传动相结合的传动方案，可实现多重变速，扩展系统的测试范围。

It seems likely that Kraft will return with a better offer.

看起来卡夫要重新考虑一个更好的出价了。

But he'd rather burn off my feelers and watch me squirm.

可他却放任那个家伙对我为所欲为！