优化程序

With all the above techniques, an optimization ratio of about 90% can be obtained. The result may be as good as attained by manual method, when there is no abuse of GOTO statement in the sequential source programs.

以上一系列优化技术在实际程序中能够达到90%左右的优化率，在用户源程序不滥用GOTO语句的情况下，能够达到手工优化的效果。

The structural optimal design of the intercooler used in vehicles is described based on the genetic algorithm.

基于遗传算法对某车载空—空中冷器进行了结构优化设计，完成了优化设计程序，得到了中冷器芯体结构的优化方案，使优化后的中冷器散热能力在理论上最大提高了19.3%。

The Computer Analysis Technique is used to analyze the structure of surface irrigation simulation model srfr firstly, and then the srfr is connected with the Genetic Algorithm model, to consist of self-contained parameter optimization inverse program.

用计算机解析技术对地面灌溉数值模拟程序srfr进行了解析，然后把经过解析后的模拟程序与遗传算法程序进行连接，形成了一个完整的参数优化反求程序。

To imagine such a situation, when you more than the amount of memory, and run a relatively large-scale process, will inevitably lead to a sharp reduction in the number of physical memory, and in this case the so-called "optimization software," the beginning of smart aleck, the data memory for paging to the hard drive, and the procedures needed for the operation of the data, which may have led to at the same time, the "optimization of software" tried to data paging to the hard disk, and the operating system attempts to read data from the hard disk into memory, a very large increase in hard drive read and write.

想象这种情况，当你内存数量不多，而又运行了比较大型的程序后，必然导致物理内存数急剧减少，而在这种情况下所谓的"优化软件"开始自作聪明，把占用内存的数据往硬盘上进行分页，而程序的运行需要这些数据，这可能导致了在同一时间内，"优化软件"试图将数据分页到硬盘，而操作系统试图将数据从硬盘读取到内存，极大增加了硬盘的读写。

This passage introduces the theory and method of storm sewer design on Gas compute program particularly, compiles storm sewer optimal design program as well.

本文对雨水管网遗传算法优化设计程序设计理论和方法进行了研究，编制了雨水管网优化设计程序。

To overcome the difficulties and drawbacks in modeling the dynamic systems by using traditional methods, a hybrid evolutionary modeling algorithm is proposed to model the dynamic system with a system of ordinary differential equations whose main idea is to embed genetic algorithm in genetic programming where GP is employed to optimize the structure of a model, and GA is employed to optimize the parameters of a model.

针对采用传统方法解决动态系统的微分方程建模问题所遇到的困难和存在的不足，文中设计了将遗传程序设计与遗传算法相嵌套的混合演化建模算法，以遗传程序设计优化模型结构，以遗传算法优化模型参数，成功地实现了动态系统的常微分方程组建模过程自动化。

This paper has done a deeply research on the evaluative method, which focus on maintaining and ensuring the camion. After deeply analyzing the maintain theory of army equipment and the stratagem 's characteristic and combining the current systems engineering evaluating theories and methods, it has analyzed and solved all limitations that coming forth when a single model is used to evaluate the maintain capacity. After analyzing and ameliorating the judgment of AHP's coherence, the calculation of the expert power value and the optimizing of the more-extreme judging model, a new calculation method, the multidimensional complex calculation theory, is presented, which much fits for the evaluative calculation of the camion. The new theory's feasibility and the evaluation's reliability have been proved in theory in this paper. This paper also analyses the principle and the program, which is about building a camion evaluating system. According to the multidimensional complex calculation theory, an evaluative model has been built. Applying the levels analytical method, this paper fixes on the calculation of every target's power, brings the optimization allot precept of macro spatial resource, optimizes the resource of the maintainability of theater of operations' vehicle, which offers a theory foundation for optimizing of the resource space. The research not only brings out a uniform standard for the evaluating of the maintain ability of the camion, but also presents a theory foundation and method for perfecting the camion maintain system.

本文对军用车辆维修保障能力评估的方法论进行了深入研究，在理论上通过对军事装备维修理论及战略特性的深入剖析，结合现有系统工程评估理论、评估方法的特点，分析解决了应用单一模型评估装备维修能力问题的各种缺陷，就AHP法判断矩阵一致性判定，群策专家权重值的确认及多元评判模型的优化进行了研究和改进，形成了适应军事车辆维修保障能力评估应用的新算法--多元复合算法理论，对这一创新评价理论的科学性及评估可靠性进行了理论证明和算法应用；研究分析了建立军用汽车维修保障能力评估指标体系的原则和程序，并按照多元复合算法的理论，建立了车辆维修保障能力评估模型；应用层次分析法的原理，明确了各指标权重的算法，提出了宏观空间维修资源优化分配方案，优化了战区车辆装备维修能力资源空间，为某一具体车辆装备维修能力形成所需维修资源空间的优化提供了理论依据；本文的研究既为军用车辆装备维修保障能力评估提供了统一的衡量标准，也为军事装备维修保障系统的进一步完善提供了理论依据及方法手段。

Firstly this paper explores the main systerm modeling methods in hydraulic grab;then we focus the analysis on the kinematics and bear of the back shovel dig device, the request of the gig ability, the task efficiency , the endure intension; after that we creat a rational maths model and write a program to ananlysis the data acquired; finally, this paper gets the optimize parameter and scheme, and protracts the grab envelope chart.

论文首先对液压挖掘机主要系统建模方式进行探索，然后重点对反铲挖掘装置运动学及受力进行分析，分析反铲挖掘装置的挖掘能力要求、作业性能要求、作业效率要求、受力状态要求，进行运动学和动力学分析，创建合理的数学模型(设计变量、目标函数的确定)，利用合适的优化方法编写计算机程序，调试通过程序应用，最后对优化结果进行分析整理。

Based on Wintech Digitals DAM6416, the transplanting of the H.264 model JM7.3 from PC to DSP is then discussed in detail. The encountered problems and appropriate solutions are listed, and some optimization measures are presented. Then we analyzed and compared the respective results on PC and DSP platform.

Ltd。的DAM6416P图像处理平台为基础，详细讨论了H.264 JM7.3编解码程序向DSP平台移植的过程，列举了移植过程中遇到的问题和解决方法，叙述了程序的优化方法，给出优化结果并对结果进行比较分析。

The usage technique of radar for high-speed ship s to prevent collision in Three Gorges reservoir;2. Research on Modeling and Simulation of High-speed Ship CPP Propulsion System;3. Based on three typical high-speed ship (high-speed monohull ship,planning hydrofoil craft,wave-piercing Catamaran),a mathematic models of high-speed ship ′s propulsion system(common screw propeller,adjustable-pitch propeller, water-jet propeller) and intelligent control system are established the simulation with the help of Matlab/Simulink is realized.

以三种典型的高速船(高速单体船、翼滑艇和穿浪艇)为例，建立了其推进(普通螺旋桨、可调螺距螺旋桨及喷水推进)系统及智能控制的数学模型，并在Matlab/Simulink上实现仿真；建立了推进系统的优化数学模型，编制了优化算法(混沌算法、遗传算法和粒子群算法)程序，实现了智能推进系统的优化设计；最后，运用Matlab/GUIDE进行界面设计，编制了高速船智能推进系统仿真与优化软件，实现了良好的人机互动。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。