产生胶原的

It is embodied concretely:(1) With the adoption of grouting bolts, the cranny in wall rocks can be blocked up, the air can be isolated, the wall rocks can be prevented to be weatherized and make water, the strength of wall rocks can also be avoided to be lowered;(2) The lax broken wall rocks are commentated to a whole by liquid after they were grouted and the rock"s strength is increased, so the wall rocks become a part of the support structure by using itself and become a whole with the original rock, and the roadway is made to keep stable but not easy to be broken;(3) The spray layer wall are filled with liquid after grouting, the stress is avoided to be concentrated because the load could be evenly acted on the spray layer and the support;(4) The pressure acted on the plank can be delivered to the two sidepieces and then to the bottom by reinforcing the sidepiece; At the same time, the concentration degree of loads acted on the motherboard can be weaken because of the enlargement of the combination arch"s thickness, as result, the rock"s stress is lowered and the heaving is alleviated;(5) The common bolt is made to be fixed the whole length after grouting, the layers are connected to a integral whole and bear the weight of loads, so the support structure"s unity is increased.

具体体现在：(1)采用注浆锚杆注浆，可以利用浆液封堵围岩裂隙，隔绝空气，防止围岩风化，且能防止淋水和渗水，避免围岩被水浸湿而降低围岩的本身强度及造成的巷道变形。(2)注浆后浆液将松散破碎的围岩胶结成整体，提高了岩体强度，实现利用围岩本身作为支护结构的一部分，且与原岩形成一个整体，使巷道保持稳定而不易产生破坏；(3)注浆后使得喷层壁后充填密实，保证荷载能均匀地作用在喷层和支护上，避免出现应力集中点而首先破坏；(4)注浆后使作用在顶板上的压力能有效地传递到两帮，通过对帮的加固，又能把荷载传递到底板；同时由于组合拱厚度的加大，这样又能减小作用在底板上的荷载集中度，从而减小底板岩石中的应力，减轻底臌；(5)注浆加固后能使普通端锚锚杆实现全长锚固，它们共同将多层组合拱连成一体，共同承载，提高了支护结构的整体性。

The sludge in SBMBR1 presented granular characteristics and settled very well. The sludge in SBMBR1was brown and the sludge flocs was smashed by the shear force due to high intensity of aeration. The sludge size decreased and the sludge flocs blended with water forming ropy solutions, and there was no distinguish interface between water and sludge. Low sludge age and high loading operation enabled the sludge in SBMBR1 keeping higher sludge activity and the MLVSS/MLSS ratio and SOUR values of SBMBR1 were higher than SBMBR2. Both in SBMBR1 and SBMBR2, there were large amount of zoogloea, bacillus, coryneform of bacteria, and pediococcus. However, in SBMBR1 there were also a lot of Protozoa like epistylis and etc. A certain amount of filamentous bacteria can also be found in SBMBR1. The biological species in SBMBR1 were much more abundant than that in SBMBR2.3. Membrane fouling on flat-sheets membrane was observed and analyzed with AFM, SEM and TEM. After the measurement of membrane surface EPS and membrane surface ETX analysis, the pollutants composition on the surface of flat-sheets membrane was calculated.

从外观观察SBMBR1反应器中的活性污泥呈浅黄色，随着运行时间的增加，污泥粒径逐步增加，SV、SVI值逐步下降，呈现出较强的颗粒特征，沉降性能良好；SBMBR2污泥呈土黄色，污泥絮体被高强度的曝气所产生的切应力所打碎，污泥粒径迅速降低，絮体较为细碎，和水相混合成均一粘稠的溶液，看不到泥水分界面；低泥龄、高负荷运行，使得SBMBR1可以保持较高的微生物活性，MLVSS/MLSS值、SOUR值均高于SBMBR2；两级反应器活性污泥中均有大量的菌胶团，长杆菌、短杆菌和球菌是构成主体，但SBMBR1活性污泥中含有大量固着型原生动物如累枝虫等，还存在着一定数量的丝状菌，生物相要比SBMBR2丰富。3、借助原子力显微镜、扫描电镜、透射电镜等手段对平板膜污染现象进行观测和分析，并通过膜表面污染物EPS测定、污染膜表面能谱分析，得出平板膜表面污染物的组成。

In contrast, 11/15 primary glioblastomas contained a significant CD133 subpopulation that displayed neurosphere-like, nonadherent growth and asymmetrical cell divisions yielding cells expressing markers characteristic for all three neural lineages.

相反，15个原代胶质母细胞瘤中有11个含有明显的CD133阳性亚群，呈神经球样，非附着性生长和非对称性细胞分裂，后者产生表达所有三种神经细胞系的特征标志物的细胞。15

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。