英语人>网络例句>产生结果 相关的搜索结果
网络例句

产生结果

与 产生结果 相关的网络例句 [注:此内容来源于网络,仅供参考]

It shoewd that nonlinear load injects hormonic power to system, and creates the negative error to energy metering.

实验结果表明,非线性负荷向电力系统注入谐波功率,并对电能计量装置产生负误差影响。

The results indicated that both vaccines could elicit specific humeral immune and cellular immune responses.

结果表明这2种基因工程疫苗均能诱导鸡产生特异性的体液免疫及细胞免疫应答。

These results indicated that a well structured anatase TiO2 was obtained by impregnation method under 500℃. Flow rate, in the activity test, could be neglected for mass transfer effects. As a matter of fact, relative humidity played the most important role in this reaction. The highest removal efficiency was obtained while relative humidify of 56.8%. Water molecules are sources of ; however, excessive water molecules could inhibit reactions by competing activity sites with organic containments. In the regeneration test, photocatalyst could be reactivated through a running water vapor with UV light illumination process.

研究结果指出,以含浸法制备之触媒於500℃锻烧下,具有良好的锐钛矿晶体结构;另外在活性测试的部份,流量的增加,污染物之去除效果不受影响,所以本实验选择以200ml/min之流量可忽略质传影响;湿度扮演重要的角色,当RH=56.8%时去除效率最高,主要因水气是产生氢氧自由基的主要来源,但是过多之水气可能与有机物竞争触媒表面上的活性位置,因而抑制反应的进行;初使浓度对去除率之影响中得知,初使浓度的高低不会影响触媒对有机物的催化能力,实验使用之触媒量适合催化200~250ppm之有机物,可藉由增加触媒量提高对有机物之催化能力;此外再生的测试,触媒可经由连续曝水及紫外光的照射,使触媒恢复原有的活性,可再次利用。

The main results of the investigation are as following:(1) Some important criteria for the design of multi-layer structure are acquired: the ratio of the layer thickness to the contact diameter should be controlled to a value about 0.8; increasing the number of the gradient layers and elasticity modulus of the top layer would benefit to the yield strength and the stress status at the interface.(2)By means of molecular dynamics simulations for a indentation and sliding process, it is discovered that dislocations of 45 direction to the surface occur in the surfaces layer, which is correspond to the direction of the plastic flows observed in the macroscopic continuous medium. The irreversible deformation caused by the dislocation and the atom piles at the surface are responsible for the irreversibility of the force response. They are also the main factors for the friction generation. The temperature and the indentation velocity have significant effects on the deformation behaviors of the material of the surface layer. The yield strength would increase obviously if the indentation velocity is greater than 10 m/s.(3)A method to evaluate the fracture toughness of coating by estimating the crack-density functionβof a Wicker''s indentation was proposed. Meanwhile a new surface treatment technology was developed using non-equilibrium plasma.(4)A MD-FE hybrid method and corresponding software was developed to analysis the tribological behaviors for multiplayer system.

研究主要内容和结果有:(1)得到指导梯度膜设计的几个准则:控制膜层厚度与接触半径比在0.8左右为宜;适当增加梯度层层数和顶层弹性模量,有利于提高抗屈服能力和改善界面处的应力状态;(2)通过对嵌入和滑动摩擦过程的分子动力学模拟,发现表层产生一个与宏观连续介质的塑性流动方向观测一致的45 方向位错;位错造成的不可逆变形和表面的原子堆积,是力的响应不可逆性的原因,也是构成摩擦力的主要因素;温度和嵌入速度对材料变形特性有显著的影响,当嵌入速度大于10 m/s时,屈服强度明显增加;(3)提出压痕裂纹密度系数β半定量判定膜层断裂韧性的方法;并开发出表面强化新工艺;(4)开发出分析表面摩擦学特性的MD-FE复合模拟方法和相应模拟软件。

But the bacteria can also damage the immune cell, such as cell hydrops, membrane structure destruction and cell necrosis.

研究结果还表明,病菌也会对免疫器官产生损害,可造成细胞水肿,膜性结构破坏及细胞坏死。

The results indicate that its dynamic stress-strain curve is hyperbolic type. The dynamic strain of LCES decreases with increasing confining pressure, cement content, curing ages and cyclic loading frequency when it is subjected to the same dynamic stress. At the same dynamic strain, the dynamic secant elastic modulus E_(sec of LCES increases and the damping ratio decreases with increasing confining pressure, cement content, curing ages and cyclic loading frequency. The curves ofσ_d~ε_d,E_~ε_d and D~ε_d with different EPS content intersect respectively, the trend of LCES deformation characteristic is inversely proportional to EPS content near the intersection. The value of dynamic strain at the intersection is about 0.5%~3.0%, the magnitude of which is related to the mixing proportions and confining pressure.

试验结果表明,LCES的动应力应变骨干曲线形态符合双曲线;在相同的动应力作用下,LCES产生的动应变随着固结压力、水泥掺量、试样养护龄期和振动频率的增大而减小;在动应变相同的情况下,随着固结压力、水泥掺量、试样养护龄期和振动频率的增大,LCES的动模量增大而阻尼比减小;随着加载次数的增大,LCES的动模量在开始阶段显著降低,然后趋于稳定,但当加载次数达到几百次时,动模量又有增大的趋势;不同EPS掺入比的LCES的动应力应变骨干曲线、动模量随应变变化曲线和阻尼比随应变变化曲线都发生了相交,交点前后EPS掺入比的大小对LCES动力变形特性的影响趋势是截然相反的,交点处的动应变值一般在0.5%~3.0%范围内变化,其大小与LCES的配比以及固结压力有关。

Respiratory rhythmical discharge activity of I-neurons in mNRF and activities of the hypoglossal nerve were simultaneously recorded by using extracellular microelectrodes and suction electrode,respectively.

目的甘氨酸(glycine;Gly)是中枢神经系统内重要的抑制性神经递质,它在呼吸节律的产生和调节中起着重要的作用,而所有这些调节作用都是Gly与其特异性受体相互作用的结果。

Aspirin produced a 25 percent reduction, and ibuprofen has produced inconsistent results.

阿司匹林制作了25 %的削减和布洛芬产生不一致的结果。

In the first layer,namely ice crystal layer,the main water substance is ice crystal.

结果表明,这个模型基本反映了降水性层状云的结构和降水产生的物理过程。

No doubt their physical, mental, and moral ill-health is partly due to other causes than poverty: but this is the chief cause.

毋庸置疑,他们的身体的,精神的,道德的败坏在某种程度上是其他原因产生的结果,但贫穷是主要的原因。

第83/100页 首页 < ... 79 80 81 82 83 84 85 86 87 ... > 尾页
推荐网络例句

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应,而且减少跟风的可能性。

The new PS20 solar power tower collected sunlight through mirrors known as "heliostats" to produce steam that is converted into electricity by a turbine in Sanlucar la Mayor, Spain, Wednesday.

聚光:照片上是建在西班牙桑路卡拉马尤城的一座新型PS20塔式太阳能电站。被称为&日光反射装置&的镜子将太阳光反射到主塔,然后用聚集的热量产生蒸汽进而通过涡轮机转化为电力