产卵的

Mating affects significantly the behavior and physiology of mated female insect:increases the fecundity of female, degreases the attractiveness of males and theacceptance of mating, affects the longevity of mated femal.

交配影响了雌性昆虫的生殖行为和生理，主要表现在三个方面：1，促进雌虫产卵和卵子成熟；2，降低雌虫性诱惑力，抑制二次交配；3，影响雌虫寿命，以上效应我们称之为交配效应。

The results show that BPBB and its odor can increase the eggs oviposited by CBW.

这一结果清楚地表明，黑杨枝把及叶片气味能使棉铃虫的产卵量增加。

Female adults oviposited on the day of emergence or on the following day, and laid eggs at the rear one-third of the body of host larvae in the last stage of the 2nd or the early stage of the 3rd in-star.

结果表明，该蜂成虫喜欢群集活动，飞翔能力较弱；具有很强的趋光性和向上行为；成虫喜欢清洁身体；多在上午羽化，羽化当天或次日产卵。

The parasitizing behavior of the bathyluid Scleroderma guani on the pupa of the yellow mealworm, Tenebrio molitor Linnaeus was investigated in the laboratory. The parasitism process was divided into six stages, i. e. assembling, recognition, stinging, clearing and feeding, oviposition and protecting protelean bathylid.

在人工扩繁条件下观察管氏肿腿蜂Scleroderma guani对中间寄主黄粉甲Tenebrio molitor的寄生行为，其过程可分为：搜寻－识别－螯刺－清理和取食－产卵－护幼。

But it indicates biological effect to the old larvers were refusing eating, extending the time of larver and pupating, shorteningthe time of pupa, affecting emergence, and causeing doomed of pupa and so on..

分别为16.83±5.18μg／ml、25.2±5.12μg／ml，对于3龄以上的棉铃虫幼虫则表现出拒食、影响生长发育、延长化蛹时间、缩短蛹历期、导致畸形蛹、引起蛹死亡及降低羽化率、产卵率和卵孵化率等生物学作用。

Do you know that when a dragonfly skims over the water it is actually laying eggs?

而你知不知道当蜻蜓擦过水面的时候其实是在产卵呢？

My question spawns from the latter.

我的问题从后者产卵。

Sexual selection and reproductive capacity generally favor large, deep-bodied fish, thus the sizes and shapes of salmon vary among spawning habitats.

选择性和生殖能力通常喜欢大深体鱼，因此大小和形状的鲑鱼有所不同产卵栖息。

That lays its eggs in cotton bolls destroying the cotton.

略带灰色的象鼻虫，在棉铃上产卵以破坏棉花。

Volume and hatching eggs from speaking is the best breeding age fish.

从其产卵量以及孵化率上来讲，都是最佳的繁殖鱼龄。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。