二氧化锡

In this paper, the current status of research on conducting mechanism and fabrication methods of ATO is reviewed.

介绍了锑掺杂二氧化锡的导电机理和该材料湿相制备方法的研究现状。

On the basis of investigating the developments of inorganic mesoporous material's syntheses and applications, mesostructured tin oxide, bismuth oxychloride, lead sulfide, bismuth sulfide, titanium phosphate and zinc phosphate were synthesized by Sol-Gel and hydrothermal techniques, employing the neutral surfactant organic amine and anion surfactant alkyl sulfonate as templates.

在对无机介孔材料的合成、应用等方面的发展现状进行了充分调研的基础上，本文运用溶胶一凝胶法、水热法等合成手段，选用中性表面活性剂有机伯胺和阴离子表面活性剂烷基磺酸盐为模板，制备了二氧化锡、氯氧化铋、硫化铅、硫化铋、磷酸钛、磷酸锌等无机介孔材料。

On the basis of investigating the developments of inorganic mesoporous material's syntheses and applications, mesostructured tin oxide, bismuth oxychloride, lead sulfide, bismuth sulfide, titanium phosphate and zinc phosphate were synthesized by Sol-Gel and hydrothermal techniques, employing the neutral surfactant organic amine and anion surfactant alkyl sulfonate as templates.

中文题名非硅基介孔材料的合成与表征副题名外文题名论文作者周书喜导师李健民学科专业物理化学研究领域\研究方向学位级别博士学位授予单位中国科学技术大学学位授予日期2003 论文页码总数92页关键词介孔材料介孔分子筛馆藏号BSLW /2003 /O643.3 /50 在对无机介孔材料的合成、应用等方面的发展现状进行了充分调研的基础上，本文运用溶胶一凝胶法、水热法等合成手段，选用中性表面活性剂有机伯胺和阴离子表面活性剂烷基磺酸盐为模板，制备了二氧化锡、氯氧化铋、硫化铅、硫化铋、磷酸钛、磷酸锌等无机介孔材料。

Keywords titanium dioxide;fluorin-doped tin dioxide;atmospheric pressure chemical vapor deposition;energy-saving;photocatalysis

二氯化钛；掺氟二氧化锡；常压化学气相沉积；节能；光催化性

The formation of tin dioxide nanotubes on tin substrates anodizing in oxalic acid electrolytes and annealing in the air was investigated. Under optimized electrolyte, oxidation and anneal conditions, nanotubes of tin dioxide were fabricated.

单质锡箔片在草酸溶液中利用电化学阳极氧化合成出前聚体，并将前聚体通过加热氧化制备出具有纳米级孔道的二氧化锡材料。

Through XRD analysis, as the temperature of cosolvent and mass transport goes up, the wave peak intensify of tin dioxide becomes more obvious. By means of SEM, tin dioxide particulates are found evenly distributed on the matrix and the quantity of particulates become higher with the increasing cosolvent concentration. The size of particulates is about 30-50nm.

经XRD分析，复合材料中二氧化锡之波峰强度随潜溶剂浓度与质传温度之增加越趋明显；SEM观察则发现，二氧化锡颗粒析出物系均匀分布於基材内，且析出物的含量随潜溶剂浓度增加而增加，析出物的尺寸约30-50nm。

Through visible wavelength and the UV spectrum analysis, the transmittance is found declined as the mass transport and the cosolvent concentration increases and the cut-off wavelength tends to shift to long wavelength.The FTIR spectrum analysis shows that tin dioxide particulates and PMMA has no obvious surface bonding. Therefore, no new absorption peak is found and so do the change shown on the wave shape.

经由可见光及紫外光穿透光谱分析，发现其穿透率随质传温度及氯化锡/甲醇潜溶剂浓度增加而下降，且截止波长有往长波长移动的现象；经红外光光谱分析，析出的二氧化锡颗粒与PMMA并没有明显的界面键结，故并无新的吸收峰出现，波形改变不明显。

Keywords tin dioxide;zinc oxide-diantimony trioxide co-doping;relative density;resistivity

二氧化锡；氧化锌-氧化锑复合掺杂；相对密度；电阻率

Taking titanium as the base metal, a kind of tin dioxide catalytic electrode with an inter-layer containing Mn(Ti/Mn/SnO2) was prepared by pyrolysis.

采用高温热氧化方法制备了含Mn中间层的钛基二氧化锡电催化电极Ti/Mn/SnO2。

The study investigats the mass transport and hydrolysis behavior for poly in various concentrations of methanol/ tin chloride (SnCl2·2H2O) cosolvent between 40℃ to 60℃. Furthermore, by using the successfully manufactured poly/ tin dioxide nano composites, the mechanical, optical and thermal properties are investigated.

中文摘要本研究系探讨在不同质传温度(40℃~60℃)下，聚甲基丙烯酸甲酯於不同浓度之氯化锡/甲醇潜溶剂(0g/100g、3g/100g、5g/100g、7g/100g及9g/100g)中的质传及水解行为，并利用成功制得之聚甲基丙烯酸甲酯/二氧化锡奈米复合材料，进一步探讨奈米复合材料之光学性质、机械性质及热性质。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。