乙烯

However, poly analogs cannot be obtained through the polymerization of the obvious parent molecule, vinyl amine, because vinyl amine is unstable with respect to its imine tautomer, ethylimine.

然而，聚类似物不能获得通过聚合明显的母公司分子，乙烯胺，因为乙烯胺是不稳定与尊重其亚胺互变异构体， ethylimine 。

The effects of feeding way of phosphorus pentoxide, ratio of C8H174OH to P2O5, reaction temperature and time on the synthesized isooctanol polyethenoxy ether phosphate were investigated. Its optimum synthesis technology conditions were as follows: feeding at batches while stirring tempestuously at 45℃, the ratio of nC8H17(EO4OH:n(P2O5)=2:1, esterifying at 70℃ for 4h, and add given volume of water at 70℃ for hydrolysing 2h.

研究五氧化磷的投料方式、反应物的用量比、反应温度和反应时间等因素对合成的异辛醇聚氧乙烯醚C8H17(EO4OH磷酸酯性能的影响，得到优化的异辛醇聚氧乙烯醚磷酸酯的合成工艺条件：在强烈搅拌下，分批投入P2O5，加料时的温度不超过45℃，nC8：H17(EO4OH：n(P2O5)=2：1，酯化温度为70℃，酯化时间为4h，在温度70℃时加入定量的水再水解2h。

The measurement shows that 310.8 nm is the suitable wavelength for detection of trichloroethylene and 322.5 nm is the suitable wavelength for detection of tetrachloroethylene in this wavelength range.

研究表明，该波长范围内三氯乙烯的最佳检测波长为310.8 nm，四氯乙烯的最佳检测波长为322.5 nm。

The model preferably predicted the photocatalytic degradation of other compounds, such as trichloroethylene, tetrachloroethylene, p -di chlorobeneze and carbon tetrachloride.

模型较好地预测了其他化合物如三氯乙烯(TCE、四氯乙烯、对-二氯苯和四氯化碳的光催化降解。

The objective of this study is to study the kinetic parameters of surfactant-enhanced permanganate oxidation of tetrachloroethylene, and then compared them with the parameters of trichloroethylene studied in other literatures.

本研究主要目的为利用界面活性剂配合过锰酸钾降解水中之四氯乙烯(tetrachloroethylene， PCE)，以求得PCE之相关动力参数，再与文献中三氯乙烯(trichloroethylene， TCE)之动力参数做比较。

Environmental contaminants, such as anthropogenic chlorinated compounds tri-chloroethylene and tetrachloroethylene, can be reductively dehalogenated to less chlorinated ethenes or innocuous compounds by micro-organisms through halorespiration under anaerobic condition.

中文摘要环境中的污染源像是三氯乙烯和四氯乙烯这些含氯碳氢化合物可在厌氧的环境之下，经由微生物的卤化呼吸作用将其进行还原性脱氯使其变成含氯较低的含氯碳氢化合物，或者无毒害性的物质。

The influences of reaction temperature and sulfuric acid concentraction on trichloroethylene conversion and chloroacetic acid recovery have been investigated.

研究了三氯乙烯水解法生产氯乙酸的工艺，并在两种不同的实验方案中考察了反应温度、硫酸浓度对三氯乙烯转化率和氯乙酸收率的影响并确定了适宜的工艺参数，可作为工业化生产研究的基础。

Effect of pretreatment of TiO2 film with trichloroethylene on gas-phase photocatalytic oxidation of volatile organic compounds was investigated by FT-IR and GC-MS techniques, and the surface state of TiO2 film catalyst was studied by XPS.

制备了TiO2薄膜催化剂，并用三氯乙烯对其进行了预处理；采用FT-IR，GC/MS及XPS等技术研究了三氯乙烯预处理的TiO2薄膜上挥发性有机物的光催化反应。

Resin transfer molding mould was manufactured with bisphenol-A epoxide vinylester resin as matrix,poly as low shrinkage additive and glass fiber tricot as reinforcing material,according to the basic requirement of matrix resin of RTM mould.

根据树脂传递模塑模具对基体树脂的基本要求，选用双酚A环氧乙烯基酯树脂为基体，聚乙酸乙烯酯为低收缩添加剂，玻璃纤维经编织物为增强材料，并加入相应的助剂，制备了复合材料RTM模具。

Curwood's Dave Engen, market manager for cheese, describes the Curpolene 7202 film as a 2.6-mil, two-ply, coextruded lamination of oriented polyethylene terephthalate, laminated to a proprietary ethylene vinyl alcohol/nylon coex that offers superior resistance to heat and abuse, as well as superior machinability, and barriers and esthetics for nonrespiring sliced cheeses like Provolone and Cheddar.

curwood的戴夫Engen的，市场经理，奶酪，描述curpolene 7202电影作为一个2.6万桶， 2层，共挤层压面向聚对苯二甲酸乙二醇酯，层压到一个专有的乙烯-乙烯醇/尼龙国际会展中心，提供优越的抗高温和虐待，以及优越的可加工性，和障碍，美学为nonrespiring切片奶酪一样， provolone和干酪。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。