乘法

This process needs to be done is to factor the function (-1) ^ multiplied by the input image to achieve the center of filter change, and also requires a real matrix multiplied by a complex matrix by calling the two images of the multiplication process to achieve multiplication of the corresponding elements, calculating the anti-Fourier transform at the same time, the result multiplied by (-1) ^ and check the final calculation of the Department of the spectrum in fact.

这个程序需要完成的功能是用因子（-1）^乘以输入图像以实现滤波的中心变换，并还要求用一个实矩阵乘以一个复数矩阵通过调用两个图像的乘法程序来实现对应元素的相乘，同时计算反傅立叶变换，得到的结果乘以（-1）^并取其实部最后计算频谱。

The alternate iterative method in the nonlinear minimizing process has been presented, on the base of finite element method and the least square method.

摘 要：对混凝土框架结构的局部刚度缺损反问题进行了动力学方法研究，在采用有限元最小二乘法的基础上，提出并利用了非线性最小化过程的交错迭代法。

In chapter four, the multiplication algorithms over finite extension fields are investigated.

第四章研究有限扩域的乘法运算算法。

The performance of finite field multiplication is of utmost important which will influence the performance of the whole system.

有限域乘法的运算效率在很大程度上决定了整个系统的性能。

Introduce a format of the statistical curve fitted by multi-dimensions least square.

本文给出了多维最小二乘法拟合经验曲线的格式。

Based on the mathematical model, the measurement result is fitted with the least square method and the fitted curve tallies with the practical curve quite well.

用该数学模型对测量结果进行了最小二乘法拟合，所得拟合曲线和实际曲线非常吻合。

Efficient algorithm about multiplication operation a·b·r in GF are put forward, wherer is a special fixed element of the field.

提出了实现GF上乘法a·b·rr为GF(p~k中特定元的有效算法。

This paper describes the least one-power method of estimating the parameters in linear regression model of two variables,which is used in the solving method by fixed point, general solving method,two points method and simplex method.

论述了用最小一乘法估计两变数线性回归模型中的参数。计算方法为：通过定点的解法，一般解法，两点法和单纯形法。

Change the "floorboards" layer's blending mode to Multiply and its opacity to 30%.

更改"地板"图层的混合模式的乘法和不透明度为30％。

First, mathematic description of FOG's modulation signal was analyzed, and then three methods for producing modulation signal with adjustable amplitude were discussed, which are direct wave table method, multiplicative amplitude adjusting method and two-level wave table method. Their advantage and disadvantage were analyzed.

首先对光纤陀螺调制信号的数学描述进行了分析，在此基础上提出了三种幅度可调调制信号的产生方法，即直接波表法、乘法调幅法、两级波表法，并分析了三种方法各自的优缺点。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。