临界的

The shear stress of the critical damage plane is determined by the method of multiaxial cycle counting method.

结果表明，临界面法更符合纤绳节点板多轴非比例加载的实际情况，因而可以给出更加合理的结果。

Test evaluation method of threshold stress of environmental cracking usually adopts NACE method A, refers to the NACE Standard Tensile Test. This test and its relevant data handling are introduced in this paper.

环境断裂临界应力的试验评价方法通常采用NACE方法A即NACE标准恒载荷延伸试验方法，对该方法及相关的数据处理作了介绍。

The ductile-brittle transitions due to both temperature and torsional prestrain were discussed by means of the micoscopic parameter ln.

利用扫描电镜测量了BHW60钢、20钢和45钢拉伸试样断口心部的临界空穴扩张比Rc／Ro，并据此分析了由于环境温度和扭转预应变等因素引起的韧脆转变过程及其细观形态。

Fault prognose is considered as the reasoning how long can a machine or its component work when the critical condition has been affirmed.

故障预后是指当一个机器或者构件的临界故障条件确定以后，一个带有故障的机器或者构件还能运转多久。

It is also found that the temperatures at which the CO2 density, thermal conductivity and viscosity possesses the maximum change are very closer to the pseudocritical temperature.

CO2的密度、导热系数以及粘度变化最大时的温度与准临界温度相当接近。

The criterion of stability and formula of the criti-cal rotative velocity obtained just is the same as that of the linear theory ofContensour-Magnus complately.

所得的稳定性判据及临界转速的表达式与Contensou-Magnus线性理论完全相同。

However, the critical value of those versions cannot be fully realized until we have a more comprehensive study of them, based on critical editions as we already have for the New Testament in Boharic and for the Gospels in Sahidic by Horner.

然而，临界值的那些旧版本不能得到充分实现，直到我们有一个更全面的研究，基於关键版本，因为我们已经为新约全书在boharic并为福音在sahidic由霍纳。

The preparation of avermyctin emulsions in water was achieved by mixing the surfactants polyoxyethylene (10) octylphenyl ether (OP10), polyoxyethylene styrenated phenol ether (602), and polyoxyethylene (40) castor oil ether (EL-40) with polyoxyethylene (20) castor oil ether (EL-20), separatively. Emulsion stability was investigated by analyzing the hydrophile-lipophile balance, critical micelle concentration, and surface tension. Then, the surfactants of polyoxyethylene polyoxypropylene styrenated phenol ether (1601), block copolymer (L64), and octyl phenyl polyoxyethylene phosphonate were added to the emulsion made by blending EL-40 and EL-20, separatively. The stability of the emulsions was investigated further and discussed in terms of droplet size, surface tension, and zeta potential.

首先将辛基酚聚氧乙烯醚(OP10)、苯乙烯基酚聚氧乙烯醚(602)和蓖麻油聚氧乙烯(40)醚(EL-40)分别与蓖麻油聚氧乙烯(20)醚(EL-20)复配制备阿维菌素水乳剂，从亲水亲油平衡值、临界胶束浓度、表面张力等方面分析了二元表面活性剂复配对乳液稳定性的影响；其次，在EL-40与EL-20复配基础上，将苯乙烯基酚聚氧乙烯聚氧丙烯醚(1601)，嵌段共聚物(L64)和辛基酚聚氧乙烯醚磷酸酯分别添加到乳液中，从粒径、表面张力和zeta电势等方面考察三元表面活性剂复配对乳液稳定性的影响。

It is revealed that both the roasting and cooling air flow run radially at inlets and then run slantingly upwards or downwards into roasting-preheating zone inside IVAC. And the gas flow in the whole soaking zone is weakened. There are possibly three gas flow patterns in PSF, which are mainly dependent on the ratio of inflow, i.e., the greater the ratio is, the higher the downward roasting air flowrate and the lower the upward air flowrate will be. The critical ratio of inflow mainly depends on the constructional parameters and packed bed conditions of PSF.

结果表明：焙烧风和冷却风在进口处呈放射状，之后斜向上或斜向下分别流入焙烧-预热带和导风墙内；整个均热带内气流较为薄弱；炉内存在三种气流分流的可能，流入风量比是决定气流分流的最主要因素，其中，流入风量比增加，焙烧风下行趋势增大，而冷却风上行趋势减小；临界流入风量比主要取决于结构参数和料层情况。

A reasonable explanation was given to this phenomenon in terms of the mechanism of anodic dissolution and characteristics of CO〓 corrosion. The corrosion behavior of P110 steel at lower temperature and pressure showed that, the corrosion product film initially was thin and discontinuous, then with the increase of temperature and exposure time it became thicker and sludgy, at last a new crystalline film formed on the sludgy film.

阳极极化和自然腐蚀电位下的EIS谱随温度变化规律表明，在两种电位下，室温到90℃的温度范围内，都存在一个临界温度，低于CT，电化学阻抗谱表现为三个时间常数，高于CT，谱图为双容抗弧，从阳极反应机理和CO〓腐蚀特征出发对试验结果进行了解释。

By the time of its fall, most of the prisoners were writers who had written against the corruptions of the government.

到它被攻陷的时候，里面多数的犯人是写了反对政府贪污文章的作家。

The most obvious variation to ovum morphological character was that the color was changed from light green to sepiaceous in embryonic development, and all the ovums were almost hatched after 96h.

在胚胎发育过程中卵的形态特征最明显的变化是颜色从淡绿到深褐色，卵在发育96h后卵基本全部孵化。