临界区

The coexistence curves and light scattering data for a critical solution of benzonitrile + octane have been reported. The critical exponents relating to the difference in the density variables between two coexisting phasesβ, the osmotic compressibilityγ, and the correlation length v have been deduced and the values were consistent with the 3D-Ising value in the range close to the critical point. The experimental results of the coexistence curves have also been analyzed to examine the Wegner correction terms and the behavior of the diameter of the coexistence curves.

用折射率法和不同角度的光散射法测量了苯甲腈+正辛烷二元体系在临界温度附近的液-液共存曲线和一相区不同温度下的渗透压缩系数及关联长度，得到与共存曲线相关的临界指数β，与渗透压缩系数相关的的临界指数γ和与关联长度相关的的临界指数γ，发现在近临界点体系符合3D-Ising模型，讨论了共存曲线直径和Wagner校正项。

The results show: the most sensitive Chinese area to acid deposition is Podzolic soil area, then follow Latosol, Dark brown forest soil and Black soil areas; Ferraisol and Yellow-brown earth area in southern China can buffer about 0.8-1. 6 g Sm〓yr〓 sulfur deposition; the least sensitive areas to acid deposition are mainly Xerosol area in northwest China, Alpine soil area in the Qingzang Plateau, and Dark loessial soil and Chernozem areas; the main reason for lower critical load in northeastern areas and higher critical load in Ferralsol and Yellow-brown earth areas in China can be attributed to the obvious difference in temperature, humidity and soil properties.

研究表明：我国土壤对酸沉降最敏感的区域是漂灰土带，其次是砖红壤土区、暗棕壤带和黑土区，南部富铝土区域大致可接受O.8-1.6 g Sm〓yr〓的硫沉降，对酸沉降最不敏感的区域主要集中在西北干旱土和青藏高原的高山土区域以及黑垆土和黑钙土带；导致我国东北地区酸沉降临界负荷偏低和富铝土区域酸沉降临界负荷偏高的重要原因，是这些地区的气温、湿度和土壤质地存在显著差异。

Isotropy s-wave model is adopted and the critical superconducting temperature is determined by chemical potential and Thouless condition.

从我们的计算结果可以看出，电子比热系数在临界温度以上区域已随温度的减小而减小，这表明在临界温度以上的温区有赝隙存在。

It was shown that winter-time natural convection in the fractured-rock embankment began to occur in the side slope portions and developed from two side slope portions to the middle portion of embankment with lowering of surface temperatu...

通过引入自然对流指数，分析了自然对流降温效应随路堤碎石层填筑厚度的变化规律，其可分为恒零区、急增区和缓变区3个阶段，急增区的起点和终点对应于路堤碎石层填筑的最小厚度和最大厚度。最后，利用自然对流指数具体计算了不同粒径碎石层填筑的临界厚度。

heological properties at a low shear rate range(10-2-10s-1) and the glass transition temperatures for PEK-C with different moleCular weithts have been studied by using a cone/plate rheometer and DSC' The activation energy for melt flow increases with Mw The dependence of Tg on molecular weight exhibits two linear range and the value of nitersect agrees with the critical molecular weight , Mc' which is first reported for PEK-C' Mc value obtained according to η0 is about 8× 104 g/mol and the relation between Mc and temperature was dis-cussed.

用锥权流变仪及DSC的方法研究了5种不同分子量的酞侧基聚芳醚酮在低剪切速率区（10－2－10s－1）的流变行为及其分子量与玻璃化转变温度的关系。结果表明，样品的粘流活化能随分子量的增加而增大，Tg随分子量的变化是二个线性区，其交点值与所求的样品的临界分子量值相对应。利用测得的零剪切粘度值（η0）首次求得了PEK—C的临界分子量值。同时也讨论了Mc与温度及η0和Tg与分子量的关系。

A Kernel object used to serialise access to a resource which may only be shared between the threads within a process.

critical section 临界区一个内核对象用来串行的访问某个在同一进程内的线程间共享的资源。

Not all critical sections are the same, so the kernel provides different primitives for different needs.

并不是所有的临界区都是相同的，因此内核针对不同的需求提供了不同的原语。

This Article explains how we can extend the custom critical section architecture to make it re-entrant.

本文介绍如何，我们可以扩展自定义临界区的架构，使之重入的。&/页&

In addition, the blank holding force that is required to avoid wrinkle and rupture during conical part deep drawing is researched. The necessity of reasonable blank holding force in pressing is expounded. From the view of mechanical analysis, the wrinkle critical condition of side-wall is derived for the first time by the stress state of side-wall, the main deformation region on blank. According to the critical condition of plastic instability for flange, side--wall, corner of punch on blank, The blank holding force in conical part deep drawing is divided into four different regions within its forming figure. The basic principle of reasonable blank holding force during stamping is summarized and provided. The mathematical model of reasonable blank holding force that avoids the wrinkle and rupture is established and verified by the finite element numerical simulation and the grid experiment method. The result shows that it is accurate and reliable.

此外，本文还研究了圆锥形件拉深成形过程中，随着拉深变形过程的进行，毛坯为避免产生起皱、破坏缺陷而对压边力的需求情况，阐明了圆锥形件拉深成形过程中压边力合理变化的必要性；由毛坯主要变形区悬空锥壁部分的受力变形情况，从力学分析的角度，首次推导得出了圆锥形零件悬空锥壁起皱失稳的临界条件；并根据主要变形区法兰、悬空锥壁及凸模圆角部分的塑性失稳临界条件，在其成形范围图中，将圆锥形件成形过程中的压边力划分为四个区域；总结并提出了圆锥形件成形过程中压边力合理变化的基本原则；建立了防止起皱、破坏缺陷产生的压边力合理变化的数学模式，并得到了有限元数值模拟及网格实验法的验证，证实了理论分析结果的正确性和可靠性。

A process wishing to enter a critical section will call P on the relevant semaphore; if the semaphore's value is greater than zero, that value is decremented by one and the process continues.

一个想进入临界区的进程会调用信号量的P函数；如果信号量的数值大于0，这个值就会递减同时进程继续运行。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了