串行通信

The main content of this article are the theories of fuzzy control system and data acquisition system for micro aerial vehicle . we can let a aeroplane model aviate with some sensors and one microcontroller , at the same time , the remote control is used .. when the model make a landing , we could get some useful data from the model

在信号采集系统的基础上，对微型飞行器模糊控制系统的具体实现进行了探讨，并分析了单片机与pc机串行通信的方法，进一步强调信号采集系统与模糊控制系统之间综合设计的合理性和必要性。

Under this assumption, all aspect of jitter, from phenomena to inbeing, have been discussed in this paper.

在这种假设下，论文系统研究了高速数字串行通信中时间抖动现象及本质的各个方面。

The data transmission adoption nonsynchronous serial communication, carry out the telecommunication of the singlechip system and PC machine.

数据传输采用异步串行通信方式，实现单片机系统与 PC 机的网络通讯。根据系统需要为本系统编制相应的通讯协议。

With the serial communication it realizes the semiduplex wireless transmission,adapts to wireless data acquisitions of low power and short distance, and resists disturbance well. This paper also introduces its application in testing forces of the steely rope in hoist system.

以串行通信方式实现采集数据的半双工无线传输，适合于低功耗短距离无线数据采集，并具有抗干扰能力强等优点；最后介绍了其在提升系统钢丝绳张力实时检测系统中的应用。

Secondly, it specifies the system solution of automatic Gleithretter thickness testing in detail, thickness testing technology using grating, serial communication achievement solution of PLC control system. Achieving data sampling by applying of the PCI200 subdivisional card. And then designs thickness testing system software using Borland C++ Builder 6.0 for the application of automatic control of Gleithretter thickness testing sorting , the experiment.

其次详细叙述了滑片厚度自动检测系统总体设计方案及要求，光栅厚度检测技术，上位机与PLC控制系统串行通信的实现方案，开发应用PCI200细分采集卡实现数据采集，利用Borland C++ Builder 6.0平台设计开发的滑片厚度自动检测系统软件，来实现对滑片检测分选的自动控制，实验。

This system uses the control style of serial communication. The connection control between the ARM embedded system and the CPLD replaces of the control between computer and CPLD, because the utilization of ARM intellectualizes the system and simplifies the program. The utilization of CTLD increases the pin numbers connected with the peripheral device.

系统采用串行通信方式，用ARM嵌入式系统与CPLD相连接取代传统上采用的计算机连接CPLD方式的控制，由于ARM的运用使系统控制阵列天线更具智能化、应用程序更简化，CPLD的使用大大增加了与外设相连接的引脚数，满足了项目中对多条控制线的需求。

The design of hardware include design of RF ReadAVrite module, design of MCU circuit, design of serial communication circuit, design of RF power amplifier, design of RF signal processing circuit and antenna design.

根据项目参数要求，在硬件方面，进行了射频读写模块电路设计、微控制单元电路设计(微控制器选用W78E58B)、串行通信电路设计、射频输出功放电路设计、射频输入信号处理电路设计和天线设计。

What this topic design is a kind of intelligent units which is installed on the door of the high voltage switch cubicle appearance .

摘 要：本课题探讨了串行通信技术、微机保护和状态监测、液晶显示技术在高压开关柜智能单元中的作用，分析了各种新技术的特点，展望了高压开关电器的智能化的发展趋势。

The serial communication control between PCC and multiple invertors is realized by using USS protocol based on the RS485 interface.

采用基于RS485接口的USS协议实现了PCC与多台交流变频器的串行通信控制。

The serial communication control between PCC and multiple invertors is realized by using USS protocol based on the RS485 inte***ce.

采用基于RS485接口的USS协议实现了PCC与多台交流变频器的串行通信控制。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了