串行通信

This monitor is composed of magnetoelectricity rotating speed sensor, signal plastic circuits, measuring unit, DSP system, data communication unit, LED display unit and keyboard unit.

监测仪的串行通讯接口采用了CAN总线与主控制室的计算机连接，并为其设置了可靠的数据通信协议。

In order to realize the normal data communication between each part of the system, we adopt serial communication and parallel communication technology, and design the communication protocol.

为了实现系统各部分之间正常的数据通信，本课题采用了常用的串行通讯和并行通讯技术，并制定了一套完整的通讯协议。

Electron truck platform balance ; serial data communication ; remote data communication

电子汽车衡；串行数据通信；远程数据采集

We an use this system to control equipment by voice recognize, and it can also be used to play like a record. The voice recognize portion which is accomplished in the computer by software.

语音识别部分在计算机上用软件编程实现，并通过串行口编程进行通信，控制单片机，成功实现了控制发光二极管和语音播放的目的。

The data traffic is accomplished through the SCM and RS232 serial communication interface;the LCD1602 screen is used to display the pH value in real time. The C language is adopted to prepare control procedure in the software design,and the Visual C++ software is used to prepare the computer monitoring interface,so that the teledata monitoring can be finished easily.

硬件设计以AT89S52单片机为控制核心；传感器采用pH复合电极；为了与传感器的高内阻匹配，信号调理采用CA3140、UA741等运放构成三级放大电路；利用ADC0809模数转换器实现A/D转换；通过单片机与RS232串行通信口完成数据通信；使用1602液晶器实时显示pH值。

Interface communication was adopted between each subsystem of monolithic computer and upper computer. The memory with I2C bus interface and serial LED display technique are also adopted in this system.

各单片机子系统与上位机之间采用485接口通信，系统中采用了I~2C总线接口的存储器与串行LED显示技术。

There are of course many ways we can communicate serially without using Mscomm control.

当然有很多方面，我们可以不使用通信MSComm控件串行。

An I /O port through which data is transmitted and received serially, used for communicating with terminals

一种输入输出口，数据通过它进行发送和接收全是串行的，常用于与终端的通信。

Through analyzing characteristics of STAP and system architecture,a system algorithmic model which is local serial and global parallel is presented,and high efficient ways are adopted f...

结合STAP处理特点和系统体系结构，提出了一个局部串行全局并行的系统算法模型，并在模型实现中采用了高效的通信与同步方法。

Based on MCGS software of PLC control system, PLC hardware structure of the typical and superordination machine (ordinary PC or industrial IPC machine) through RS232 serial connection lines or RS485 communication.

基于MCGS 组态软件的PLC 监控系统的典型硬件结构中PLC 与上位机(普通PC 机或工业IPC 机)之间通过RS232 或RS485 串行线路连接进行通信。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。