中轴的

In a rectangular shape YBCO singledomain sample, there are many long, smooth and parallel growth stripes on the top surface, which indicates that the ab plane is parallel to the axis of the cylinder sample, the long narrow and smooth stripes are formed by the continues growth along a axis.

在ab面竖直生长的YBCO晶体中，样品表面光滑、平行的长直条纹是晶体沿ab面连续生长的结果，沿c轴方向的平行台阶，则是晶体沿c轴方向以层状方式生长所形成的，十字线夹角约78°。

Firstly, the projects of designation and improvement of prewatering pelletizer are demonstrated, including the structure, the ways of delivering the motivation and drawknife system by referring some improvement experience from production practice; Secondly, based on the analytical results, axial force, the torque and power are computed so that the electromotor, decelerator and other corresponding components could be determined; Thirdly, according to the parameters of the parts which has already been assured, the simple exercise diagram of the transmission device is analyzed and drawn up and the ratios of all levels are assigned.

参考实践生产中的一些改进经验，首先进行了总体方案的论证；然后根据分析的结果来计算各传动轴的轴向力、扭矩以及功率，并校核了轴和螺栓的强度，从而选择电机和减速机型号及设计其他相关零部件。

The results showed that, all the treatments can shorten the time of epicotyl germination of 'Fengdan', the 28 days chilling treatment was the shortest, and the next was 21 days chilling treatment and 300 mg/L GA3 treatment; in a certain range of GA3 concentrations, higher concentrations, higher seed germination index and germination rate in 'Fengdan'; the seed germination index and germination rate of 'Fengdan' after different time chilling treatments were higher than the control, in which, the treatment of 21 days chilling had the highest germination index and germination rate.

研究了不同时间的低温(4℃)处理及不同浓度的GA3处理对凤丹种子上胚轴萌发及幼苗生长的影响，结果表明：所有处理均能缩短凤丹种子上胚轴萌发时间，以低温28天处理初萌期最短，其次是低温21天和300mg/L GA3处理；在一定的GA3浓度范围内，浓度越高，凤丹种子发芽指数与发芽率越高；不同时间低温处理后凤丹种子发芽指数与发芽率均高于时照，其中低温21天处理是所有处理中发芽指数与发芽率最高的。

Secondly, true taixial test by load in three different principal stress direction for study on soil anisotropic deformation characteristic are processed.

另外，由于许多模型是在普通轴对称三轴试验条件下建立的，难以准确反映各向异性，但往往被推广应用到各向异性显著的问题中，难免会出现计算分析结果的不合理，到底存在什么样的不合理，也缺乏有针对性的真三轴试验分析检验。

As a first step to industrialize this focusing coal liquefaction technology, it is essential to study the multiphase transport characteristics of this new type reactor. In this paper, mass transfer and mixing characteristics of a three-phase continuous loop reactor with a concentric draft tube were measured by the dynamic dissolved oxygen and saturated KCl solution pulse trace methods,with glass beads as solid phase, air as gas phase and tap water as liquid phase, respectively.

本文在同心内置Φ 0.14×1.5m导流筒的Φ 0.2×2.5m有机玻璃环流反应器中，以空气和水为气、液相，玻璃珠为固相，分别利用动态溶氧法与饱和KCl脉冲示踪法测量了液相体积传质系数和轴向分散系数，考察了表观气速、进料浆速、固含率、固相颗粒直径、液相表面张力以及操作方式对上述两个传递参数的影响规律，并将实验结果关联为量纲为1关联式；同时，根据环流反应器的结构特点，建立了传质系数分区模型和轴向分散系数分区模型且分别获得了解析解，对床层传质和混合的不均匀性做了理论分析。

In addition, by using appropriate feedforward and poles configuration algorithms in the velocity loop, the stage can reach very high acceleration and positioning accuracy (the maximum accelerations of X and Y axis are 8.00g and 7.34g respectively when the position accuracy is±2μm), and meet the expected design objective.

在速度环中采用极点配置并加入适当的前馈补偿，使平台达到很高的加速度和定位精度(X轴和Y轴最大加速度分别为8.00g和7.34g时，定位精度为±2μm)，达到了平台设计的预期目标。

Because the support position of bearing has great effect to the frequency of coupled vibration of shafting, this paper researches the dynamic alignment problems of shafting at first so as to determine the support position of bearing rationally, especially the position of stern tube bearing.

由于轴承的支承点位置对轴系的耦合振动频率影响很大，所以本文首先研究了轴系的动态校中问题，以合理确定轴承特别是艉管轴承的支承点。

The calculating results of the dynamic alignment of shafting and the lubricating properties of marine stern tube bearing and the coupled vibration of shafting are identical with the results of experiments and practical inspection, which shows the correctness of the models and algorithms researched by this paper.

轴系动态校中计算、艉管轴承润滑特性计算和轴系耦合振动计算结果与实验或实测的结果基本一致，从而说明本文所研究的模型和算法的正确性。

The drained behavior of Hokksund sand under low confining pressure was studied through static triaxial test, and the samples were prepared through the dry sedimentation method. The test results were corrected through the membrane effect which is often neglected under high confining pressure, the correction to axial stress for dense sample under a cell pressure of 10 kPa is equal to 12%.

采用干样沉降法制备样品，选用静三轴仪对松砂和密砂样在10kPa 至100kPa的低围压下的排水行为进行了实验研究，并对实验结果作了橡皮膜校正，在围压为10kPa的密砂实验中，轴向应力的校正值可达到12%。

Mechanical models and differential equations of motion for high speed pantographs;2. By the principle, differential equations of motion for variable-mass nonholonomic systems constrained to the fixed axis rotation are obtained.

建立了变质量力学系统在定轴转动参考系中的Jourdain原理，由此得到了受定轴转动约束的变质量力学系统运动微分方程，给出了准坐标形式，最后举例说明方程的应用。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新