英语人>网络例句>中轴的 相关的搜索结果
网络例句

中轴的

与 中轴的 相关的网络例句 [注:此内容来源于网络,仅供参考]

The rainflow counting method can be used to count the cycles in the multiaxial loading.

多轴随机载荷的寿命预测中,如何计算载荷循环次数是其基础,目前广泛使用的是雨流计数方法,现在已能成功的应用于多轴载荷的情况。

Many developing axons become myelinated by glial cells; this increase the speed of axonal conduction.

许多生长中的轴索变成有髓鞘的神经胶细胞,他能增加轴索传递的速度。

The cyclic variation of integrated backscatter and echo intensity of three different myocardial regions perfused by left anterior descending coronary artery, left circumflex coronary artery and right coronary artery (on the frozen frame of parasternal short-axis image,those position were approximately at the 12, 4 and 8 o'clock direction to the center of the left ventricle, respectively) were measured with HP-5500 ultrasonic system and DFY ultrasonographic quantitative analysis system.

在35例急性心肌梗死患者发病2周内,用HP-5500型超声诊断仪和DFY型超声图像定量分析诊断仪,在胸骨旁左室乳头肌短轴切面,分别测量冠状动脉左前降支、左回旋支和右冠状动脉支配区域心肌组织(分别相当于左室乳头肌短轴切面上12、4、8点的位置)的IB和EI心动周期变化幅度值,以CVIB和CVEI值≤同一切面三个不同部位中最高值的1/2作为诊断心肌梗死的标准,部分病例与冠脉造影结果对比。

The measurement methods of WK include the way of veins and fibers,the rotated porphyroblast approach,the method based on the relation between quartz C axis fabrics and strain ratio,the method based on the relation between oblique grain shape and quartz C axis fabrics,and the method of ultimate Mohr circle.

文章介绍了涡度的具体测量方法,即张裂脉中纤维法、旋转残斑法、石英C轴组构与主应变比值的方法、石英C轴组构与斜列颗粒形态的方法等。

The trancings of condylar movement of Angle class two division one subdivision malocclusion with mandibular retrusion during mandibular movement are smooth and continual curve. There are no differences with condylar movement distances, condylar inclination and the hinge axis rotation between right and left condyle. There are no variance to movement form of the hinge axis comparing with normal occlusion. But the overlapping gender of condylar movement trace decrease than normal occlusion.

在不同的下颌运动中,双侧髁突在矢状面和水平面的运动轨迹均为光滑连续的弧形曲线,髁突位移、矢状面髁突倾斜度、水平面髁突倾斜度及铰链轴旋转度左右两侧无明显差异,铰链轴运动形态与正常牙合无明显差异,但轨迹的重复性低于正常牙合。2。

In the highly undercooled melt, a roughening transition from the lateral to continuous growth mode was found.

在过冷 Al72Ni12Co16十面体准晶合金中发现沿十次轴方向的连续生长和沿二次轴方向的侧向生长的不同生长机制。

Cr13 and Cr18Ni8 series stainless steels would be used for ship parts in the past,the former being poorly resistant to seawater and the latter being insufficient in the strength.In view of this fact,the seriated forrite-austenite dual steels with high strength and good resistance to seawater have been developed.

以前C,r13和Cr18Ni8系列不锈钢被用于制造船体零件,前者在海水中的耐蚀性不良,后者强度性能不够高,于是发展了既具有高强度又耐海水腐蚀的铁素体-奥氏体系列双相不锈钢,用于制造高速船的船体钢板、锻件(舵轴、舵柱、舵梢、尾轴、中间轴等)和铸件(螺旋桨、阀体、耐蚀叶轮等)。

T35-11 Axial Flow- Blast Fan is a new generation product which was designed out after analyzing and comparing to the similar products abroad as well as experimenting and with model. This T35-11 Axial Flow-Blast Fan is remarkable of its high efficiency and low noise, and can be used in Industrial and Mining Enterprises, storehouses, offices and civil buildings for ventilating or facilitating heating system. The axial fan can be used as a fan when removing its housing and also can be installed in series connection inside the long exhaust pipeline to enhance wind pressure.

T35-11轴流式通风机是对国外同类产品进行分析对比,通过模型试验研究后设计的新一代轴流式通风机,具有效率高、噪声低的显著特点,可用作一般工矿企业、仓库、办公室、民用建筑内通风换气或加强暖气散热之用,若将机壳去掉,则可作自由风扇用,也可在较长的排气管道内隔串联安装以提高管道中的风压。

I design two axis which taper is 1:12 to install bearing and fix bearing of cylindrical roller, I used locking nut to fix the direction of bearing owing to the reason of boring head's high precision.

主轴中设计了两个锥度为1:12的的轴段用于安装支承和固定圆柱滚子轴承,由于镗削头的精度要求很高,在轴承处使用了锁紧螺母进行轴向固定。

In the 1:250000 regional geological mapping of Yumenzhen, the authors studied deformation feldspar by long-short axis measurement method, compared with the deformation gravel, deformation amygdale, deformation relict long-short axis measurement, then found the both measurements were similar to deformation axis. It has been proved that deformation feldspar can be studied as to an area deformation characteristic of Yumenzhen.

在《1:25万玉门镇幅》调研的过程中,试以长石颗粒为研究对象,进行长短轴法变形测量,将其结果与相邻变形砾石、杏仁体和包体测量结果进行对比,发现它们具有相似的应变椭圆轴率,证实在变形花岗岩区可以用变形长石颗粒研究区域变形的特点。

第52/100页 首页 < ... 48 49 50 51 52 53 54 55 56 ... > 尾页
推荐网络例句

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降,而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新

Lao Qiu is the Chairman of China Qiuyang Translation Group and the head master of the Confucius School. He has committed himself to the research and promotion of the classics of China.

老秋先生为中国秋阳翻译集团的董事长和孔子商学院的院长,致力于国学的研究和推广。