中轴的

Energy exchange efficiency of clustering electron beams passing through a cylindrical coaxial TM812 mode cavity resonator is studied,as well as the extraction method of microwave energy from the cavity resonator.

研究了群聚电子注穿越同轴TM812模谐振腔的换能效率和同轴TM812模谐振腔中微波能量的提取方法，论证了其作为毫米波多注速调管的输出腔的可行性。

The results are as follow:(1) In static status, the velocity of jet flow shows a symmetry distribution through central axis of enclosure.

结果表明，腔体静止时，射流速度沿腔体中心轴对称分布，腔体中心轴上的速度最大，两侧流速逐渐减小，近壁处为零；腔体转动时，在哥氏力的作用下，射流中心发生偏转，流场相对于腔体中心轴不再对称分布，腔体中各点处的流速分布随角速度而变化，压电射流角速度传感器利用这一特性敏感角速度。

Based on Chen's model about axial flow induced vibration of a rod bundle in an unbounded domain, a mathematical model concemed with circular domain is presented, and the expressions for fluid forces are given in detail.

三、基于Chen关于无界域轴向流动中棒束流致振动的模型，推导了有界域棒束轴向流致振动的数学模型，得到了关于流体力的表达式。

The simulation floating zone modelwith zero temperature gradient in the middle of the hot rod is proposed to simulate thehalf part of the full floating zone convection,since the temperature gradient in the middleof a full floating zone approaches zero.

根据加热方式的不同，可以将半浮区液桥分为通常半浮区液桥模型、模拟半浮区模型以及改型半浮区模型。通常半浮区液桥模型，液桥热端材料一般选择为金属材料，使得热端温度分布均匀。液桥产生热毛细对流时，在液桥热端内侧存在较大的轴向温度梯度。而在全浮区热毛细对流中，浮区中间的轴向温度梯度在对称条件下应该接近于零。

To show this issue, can imagine a coordinate, the x-axis of coordinate states economy increases rate, cross axle represents the economic scale of one country, in coordinate.

为了说明这个问题，可以设想一个坐标，坐标的纵轴表示经济增长速度，横轴表示一国的经济规模，坐标中的。。。

High density stacking faults are induced into Al-Co-Ni decagonal quasicrystal by using high temperature deformation. It is found that their fault planes are perpendicular to the ten-fold axis and their displacement vectors R are lying in the fault planes and parallel to a two-fold axis A2D.

通过高温形变的手段在Al-Co-Ni十次准晶中引入了高密度的层错，并发现这些层错的层错面与十次轴垂直，层错的滑移矢量R在层错面内并与二次轴A2D平行。

It is clearly shown that the Al-Ni-Rh decagonal quasicrystal with 1.6 nm periodicity contains a kind of atom columnar cluster with about 1.6 nm periodicity as the most fundamental structural building block.

主要的研究结果可以总结如下：1利用高分辨电子显微技术在Al_(75)Ni_(15)Rh_(10)合金中发现了1.6 nm周期的十次准晶，报道了这种准晶在二次轴方向及在十次轴方向的高分辨结构，阐述了其周期及其准周期的排列方式。

Because of the particularity of claw pole structure, the axial magnetic field produced by the stator winding is transformed into the diametric one along the circle of air gap.

当定子绕组通电时，电机中产生轴向磁通，爪极的作用就是将定子绕组产生的轴向磁场转化为沿气隙圆周径向排列的磁场，同时将 1对极转化为 P对极[1] 。

Multiple linear regression analysis of the data showed that vitreous length was the main factor to affected the formation and development of myopia diopter.

眼轴增长是近视眼发生、发展的重要因素，尤其对中、高度近视眼作用更为显著；眼轴长度的增长基本为玻璃体腔的延长。

A person can place a drill in the drill chuck that is secured in the spindle of the drill press. They can then select the desired speed for rotation (commonly by switching belt pulleys), and activate the spindle. Then they manually pull on the quill lever to drive the drill into the workpiece being machined.

操作者可以将钻钻头装在钻夹中，钻夹固定在台钻的轴里；接着可以选择所需的转速（通常通过切换皮带改变主轴转速），并且启动主轴旋转，然后操作钻轴手柄，将钻头钻入被加工的工件。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新