中轴的

The axonometric projection has been applied extensively in engineering because of its three-dimensional effect and better measurement and because of its drawing unsophisticatedly.

从图形直观性和作图简便程度出发，阐述了在实际工程中怎样选择合适的轴测投影图表达实体，以及不同的专业领域选用不同种类的轴测投影图

An improvement has been carried out on the generation method of 2D engineering drawing from 3D model in AutoCAD, and formed an intact methodology and skill of generating axonometric drawing and multi-planed orthogonal projection drawing from 3D model.

对AutoCAD中由三维模型生成二维工程图的方法进行了改进，形成由三维模型生成轴测图和多面正投影图的完整方法和技巧，这种方法所得到的轴测图和正投影图，可以对其更加方便地进行各种编辑，是一种适用的方

In rotational process, the rotor of journal bearing relies on the oily wedge that slippery oily oily film forms to poise, bearing gets power but the bedspring damp system that described as rotates.

转动过程中，轴颈轴承的转子依靠滑油油膜形成的油楔保持平衡，轴承受力可描述为旋转的弹簧阻尼系统。

Chinese cable reel to the door wide application of the plane, with the big cable in the road so that the process is to avoid being hurt. must maintain an appropriate tension here at present, the cable reel drives used in three main ways : namely (1) the torque-motor (2) use of cage-plus motor hysteresis coupling;(3) The torque motor controller to increase frequency hysteresis couplings.

中文摘要：电缆卷筒在门机上被广泛应用，在使电缆随大车的行进过程中要避免受到伤害，必须保持一个合适的张力，这里介绍了目前门机电缆卷筒驱动装置主要采用的三种方式：即（1）采用力矩式电机；（2）采用笼型电机加磁滞式联轴器；（3）采用力矩控制器加变频电机加磁滞式联轴节。

First, the angular velocity function and maneuver load for certain maneuver flight (including hover, dive-hike and these two combined) are set up. The simulation results of the vibration of double-disk rotor system with cantilever supported on rigid bearings show that rotor would be apparently deformed under maneuver load. Second, the performance of oil force of SFD in maneuver flight is analyzed. The results show that in maneuver flight, the SFD with centering spring will become eccentric and its oil force will be time-related and offset-related. Then, SFDs are introduced into typical Jeffcott rotor system. The whole system will be statically displaced in maneuver flight and the nonsynchronous components of oil force appear in the response of rotor system.

首先，建立了水平盘旋、俯冲拉起及盘旋+俯冲拉起复合机动三种机动飞行条件下的机动角速度函数，并确定了对应机动飞行条件下的机动附加载荷(附加离心力和附加陀螺力矩)，分析了带刚支的双盘悬臂转子系统在机动飞行条件下的振动特性，发现发动机转子在机动飞行时会发生明显变形；随后，分析了非定心挤压油膜阻尼器的油膜力特性，机动飞行时，油膜轴颈在机动附加载荷的作用下偏离外环中心，使得带定心弹支的挤压油膜阻尼器也变成了非定心挤压油膜阻尼器，其非定心挤压油膜力是瞬态时变的，并且与SFD油膜轴颈偏移量和进动形态有关；然后，在经典的Jeffcott转子系统中引入带定心弹支的挤压油膜阻尼器，分析了机动飞行时非线性转子系统的振动特性，发现挤压油膜阻尼器油膜力的非协调特性也反映到转子系统的振动响应中；之后，对机动飞行条件下带挤压油膜阻尼器的双盘悬臂转子系统的振动特性进行了分析，并重点分析、总结了俯冲拉起机动飞行时，系统结构参数和工作状态参数(转速比、机动飞行半径、机动角速度等)对该系统振动特性的影响。

The article analyses the existing calculation method of pin shaft joint partial strength, study the finite element modeling problem of pin shaft joint in girder structure and specific calculation procedure.

分析销轴联接局部强度现有计算方法，探讨梁杆结构中销轴接头的有限元建模问题及具体的计算过程。

Our study rules out the effect of strain and composition alloying as the main factor of peak splitting. We attributed it to the existence of large amount of non-stoichiometry part in GaN/Si grown by MBE. A direct proof has been observed by HRTEM, which shows that the propagation of dislocations in the underlying layers could be blocked by using periodic AlN/GaN structure.

用三轴晶高分辨X射线衍射研究了Si(111)上生长的GaN中的应变组分问题，我们发现GaN的对称（0002）及非对称（10-12）峰在三轴晶配置下的ω-2θ扫描曲线都会发生劈裂，我们排除了应力和合金化的因素，认为在MBE方法生长的Si（111）上GaN外延层中存在一个占较大比例的稍微偏离化学配比的部分。

The meso-epithermal uranium deposit described in this paper is closely related to the"multiple-staged"composite quartz-syenite body, It is a new of uranium type deposit in our country.

本文介绍的中-低温热液轴矿庆与一个多阶段复式石英正长岩体密切有关。它是我国新的一种轴矿床类型。

Because of special geometry structure of three-cone bit, the top of formation will form a tri-spine well bottom while drilling with three-cone bit the drill string. It is the tri-spine well bottom that leads to the axial harmonic of vibration when the bit revolves a round and the three concavo-convex heave of bit and formation result in one time (1×rpm),two time (2×rpm), three time (3×rpm) turning table speed.

高岩由于三牙轮钻头的特殊几何结构，钻进过程中在岩层顶部容易形成一个三脊状井底，正是这一三脊状井底，当钻头旋转一周时钻柱轴向三次凸凹变化，由此在轴向产生1倍、2倍和3倍及其更高次倍于转盘转速rpm的谐波振动。

Because of special geometry structure of three-cone bit, the top of formation will form a tri-spine well bottom while drilling with three-cone bit the drill string. It is the tri-spine well bottom that leads to the axial harmonic of vibration when the bit revolves a round and the three concavo-convex heave of bit and formation result in one time (1×rpm),two time (2×rpm), three time (3×rpm) turning table speed.

高岩摘要：由于三牙轮钻头的特殊几何结构，钻进过程中在岩层顶部容易形成一个三脊状井底，正是这一三脊状井底，当钻头旋转一周时钻柱轴向三次凸凹变化，由此在轴向产生1倍、2倍和3倍及其更高次倍于转盘转速rpm的谐波振动。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新