中轴

To improve accuracy of detection of current direction, components of magnetizing current and torque current are transformed into two-phase stationary frame. Therefore compensating voltage vector can be decided according to the sector the current vector is locating.

为了提高电流极性检测的准确性，利用旋转轴系中的励磁电流和转矩电流分量经过坐标反变换，判断电流在两相静止轴系所处的扇区来决定需要施加的补偿电压。

The aftershock distribution was relatively centered and the major axis of the aftershock area was not clear.

余震分布较集中，极震区长轴方向与震源机制解中节面Ⅰ走向基本一致，因此，节面Ⅰ可能是这次地震的主破裂面。

This will eliminate the problem of placing or removing a coil from the mandrel.

也取消了从轴中取出或安放线圈的难题，可用于不同的线圈直径。

Based on the vehicle ride comfort performances, analyzes the relationship between suspension system and vehicle ride comfort performances. Carrying on dynamics simulation to the different entire vehicle model under the different operating mode, analyzes each axial acceleration change curve in the post-processing module, the use curve processing function, the computation always weighting acceleration mean square value, analysis the influence of suspension system to ride comfort performances, and obtains the suspension system optimization plan.

基于整车行驶平顺性，从理论上分析悬架系统与整车平顺性的关系，然后对不同整车模型在不同的工况下进行动力学仿真，在后处理模块中分析各轴向的加速度变化曲线，利用曲线处理功能，计算总的加权加速度均方值，分析悬架系统对平顺性的影响，并在此基础上得出悬架系统选型的优化方案。

This is a painting axis paragraph about the procedures, mainly used in mechanical drawing.

详细说明：这是个画左右轴段的程序，主要应用在机械制图中。

Voronoi models developed in this paper can be applied with the periodic boundary conditions, which is the key for the micromechanics analysis.

结合有限元分析的细观多孔模型被应用到泡沫材料力学行为的研究中，主要包括：弹性开孔泡沫材料的本构行为；弹塑性开孔泡沫材料的多轴行为和唯象模型；开孔泡沫材料率相关行为。

Base of vegetative axis usually slender; leaves and calyx lobes without white cartilaginous margin and midrib keel.

营养体的轴的基部通常纤细；叶和萼裂片没有龙骨状白色的软骨质的边缘和中脉。

The coupling of linear antennas parallel to the minor axis in a elliptic waveguide are discussed by means of dyadic Green s function and reaction principle.

采用并矢格林函数和反应原理，讨论了椭圆波导中平行于短轴的线天线的互耦合。

But in the practical engineering problems, the lubricant entrainment sometimes corresponds with the major axis of the ellipse, and is sometimes at an angle to the minor axis.

但在实际工程问题中，有时卷吸速度方向与接触椭圆长轴相重合，有时卷吸速度方向与接触椭圆的对称轴成一夹角。

In preferred embodiments, a reaction chamber (92) is used that has a cross section perpendicular to the flow of reactant having a dimension along a major axis greater than a dimension along a minor axis.

在最佳的实施例中，使用了一个反应室，它有一个横截面垂直于反应物的流动，它沿着主轴方向的尺寸比沿着辅轴方向的尺寸大。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。