中轴

To improve the design and analysis of axial-flow pumps, the Computer Aided Design system and the basic methods of flow field simulation and performance prediction base on the Computational Fluid Dynamics are developed in the paper.

本文针对目前轴流泵设计和分析过程中存在的主要问题，建立了完整的计算机辅助设计系统，并通过计算流体动力学手段，建立了分析和预测轴流泵内部流场及外特性的基本方法。

The part of a machine shaft or axle supported by a bearing.

轴颈机械的转动轴或轮轴中由轴承所支撑的部分

Three-axle motor vehicle differential gear damage, such as, the rear axle differential damage to any one, can be the bridge and axle shaft removed, continue to operate.

三轴汽车差速器齿轮损坏，如中、后桥差速器损坏任何一只，都可将该桥传动轴和半轴拆下，继续行驶。

The assembly of journal and plain bearing liner space is too little, force of organic still oil pressure is small it is the crucial index that affects lubricant result, make lubricate because of lacking engine oil between crankshaft and plain bearing liner and bite dead invalidation, include to be pulled badly, lack lube, layer of alloy of dry attrition generation is fused, grind sliding surface to did not maintain the oily film of certain ply, and all sorts of local overload exhaustion are destroyed, cavitation erosion and V form are destroyed etc, through technology of him director diesel locomotive old experience reachs the analysis of pair of its breakdown reasons, put forward precautionary measures especially. As a result of,the burns caustic mechanism plain bearing liner to burn caustic mechanism of 1 plain bearing liner is the lube film burst between journal and plain bearing liner, cause plain bearing liner and crankshaft generation clash, below high temperature, high pressure and high rotate speed, the wear-resisting alloy layer of plain bearing liner wears away prematurely or fuse, cause plain bearing liner and crankshaft to stick thereby bite, can make the steel back of plain bearing liner and Kong Zhong produces whirligig, inlet port is jammed, carry on the back by steel again with the friction of aperture causes high temperature to make plain bearing liner burned-out further, can cause bolt to break off, happen swing a malign accident that pounds cylinder body of bad internal-combustion engine.

轴颈和轴瓦的装配间隙太小，还有机油压力低是影响润滑效果的关键指标，使得曲轴和轴瓦之间因缺少机油润滑而咬死失效，包括严重拉伤，缺少润滑油，干摩擦产生合金层熔化，磨滑面没有保持一定厚度的油膜，以及各种局部过载疲惫破坏，气蚀和V形破坏等，通过本人主管内燃机车技术多年经验及对其故障原因的分析，特提出预防办法。1轴瓦的烧损机理轴瓦烧损的机理是由于轴颈和轴瓦之间的润滑油膜破裂，导致轴瓦和曲轴产生摩擦，在高温、高压和高转速下，轴瓦的耐磨合金层过早地磨损或熔化，从而引起轴瓦和曲轴粘咬，会使轴瓦的钢背和座孔中产生旋转运动，进油孔被堵塞，再由钢背和座孔的磨擦进一步引起高温使轴瓦烧坏，并会造成螺栓折断，发生甩出捣坏内燃机缸体的恶性事故。

The relation among the bevel drive pinion bearing preloads, axial displacement and locknut screwing moment and the relation between the frictional moments were analyzed in this article.

该文分析了汽车主锥中圆锥滚子轴承的预紧力与轴向位移、压紧轴承的锁紧螺母拧紧力矩之间的关系，以及轴向位移量与启动摩擦力矩之间的内在联系，并研制出具有锁紧螺母预紧力矩和轴承启动摩擦力矩自动测量功能的主锥自动装配设备的控制系统。

T35-11 Axial Flow- Blast Fan is a new generation product which was designed out after analyzing and comparing to the similar products abroad as well as experimenting and with model. This T35-11 Axial Flow-Blast Fan is remarkable of its high efficiency and low noise, and can be used in Industrial and Mining Enterprises, storehouses, offices and civil buildings for ventilating or facilitating heating system. The axial fan can be used as a fan when removing its housing and also can be installed in series connection inside the long exhaust pipeline to enhance wind pressure.

T35-11轴流式通风机是对国外同类产品进行分析对比，通过模型试验研究后设计的新一代轴流式通风机，具有效率高、噪声低的显著特点，可用作一般工矿企业、仓库、办公室、民用建筑内通风换气或加强暖气散热之用，若将机壳去掉，则可作自由风扇用，也可在较长的排气管道内隔串联安装以提高管道中的风压。

I design two axis which taper is 1:12 to install bearing and fix bearing of cylindrical roller, I used locking nut to fix the direction of bearing owing to the reason of boring head's high precision.

主轴中设计了两个锥度为1：12的的轴段用于安装支承和固定圆柱滚子轴承，由于镗削头的精度要求很高，在轴承处使用了锁紧螺母进行轴向固定。

First, systematic study on propagation, reflection and interaction of axial stress wave is made to deduce the calculation equation for axial elastic and plastic stress wave, which fit for analysis of impact buckling of axial compression member.

本文首先对轴向应力波在构件中的传播、反射及相互作用进行系统分析，推导出适合轴心受压构件冲击屈曲分析的轴向弹、塑性应力波计算公式。

In these devices, one of the shafts is typically driven by a motor or pulley, and the other shaft is driving another device.

在这些装置中，典型的情况是，一根轴由发动机或皮带轮转动，另一根轴将动力传递给其他部件。

In the 1:250000 regional geological mapping of Yumenzhen, the authors studied deformation feldspar by long-short axis measurement method, compared with the deformation gravel, deformation amygdale, deformation relict long-short axis measurement, then found the both measurements were similar to deformation axis. It has been proved that deformation feldspar can be studied as to an area deformation characteristic of Yumenzhen.

在《1：25万玉门镇幅》调研的过程中，试以长石颗粒为研究对象，进行长短轴法变形测量，将其结果与相邻变形砾石、杏仁体和包体测量结果进行对比，发现它们具有相似的应变椭圆轴率，证实在变形花岗岩区可以用变形长石颗粒研究区域变形的特点。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新