中板的

The results are as follows: 1The collagenous fibers are arranged in a crass-crossed network of three dimentions. The network in an area of less than 500 μm is like a small board called a microboard. All microboards anastomose each other, forming a microboard network; 2The so-callcd collagenous fibers or lamellae about 4—9 μm thick under the LM are really th...

结果表明：①胶原纤维排列成三维交叉网状結构，后者在约500μm范围内呈板状，称微板，微板相互吻合成微板网；②在LM下所见的厚约4—9μm的"胶原纤維"或"板层"，实际是微板网的垂直切面，⑧文献中的板层结构TEM照片实为其网状结构的一部分，④在胶原纤维之间有少量分支交错的细小纤维，可能是弹性纤维。

In the simulation, the flow rule of melt metal in mold of horizontal continuous casting with electromagnetic stirring is measured using ultrasonic Doppler velometer, and the result is inter confirmed with the solidification characteristics is tics of zinc cupronickel thin slab in industrial product, some advantageous results are obtained that, when the current is 400 A the inner micro-pores disappear, when the current is 500 A the center equiaxed crystal layers occur and when the current is to 800 A the inner-segregation decreases to zero.

在模拟实验中，用超声波多普勒测速仪测量该电磁搅拌下水平连铸结晶器内金属液的流动规律，并与生产实验中锌白铜板带的凝固特征相互印证，发现搅拌电流达到400 A时，板带内部气孔消失，电流达到500 A时板带出现等轴晶带，电流达到800 A时板带坯偏析率趋于零。

A preparation method of nickel oxide-base cathode of fused carbonate fuel cell is to select alkali earth metal oxide, transition metal oxide and rare-earth metal oxide, mix with carbonyl nickel powder in the proportion of 0.01-15.00 mol%, add assistant and mix even into a slurry; after the slurry is formed into a biscuit by doctor-blade casting, sinter it into a multi-porous nickel plate; dissolve lithium nitrate and cobaltous nitrate with mole ratio of Li:Co-1:1 and citric acid or PVA in the distilled water to make a solution with Li of 0.00-0.5 mol/L; immerse the multi-porous nickel plate or nickel oxide plate in the solution, keep for 10-60 minutes under vacuum below 200 millibar, then dry in an oven at 75 degrees centigrade further transfer to a crucible electric furnace preheated 650 degrees centigrade for keeping the temp.

要約 熔融碳酸盐燃料电池氧化镍基阴极的制备方法属于燃料电池领域。选取碱土金属氧化物、过渡金属氧化物和稀土金属氧化物，按0.01－15.00mol％的比例与羰基镍粉混合，加入助剂，混合均匀成浆料；混合浆料流延成型为素坯后烧结为多孔金属镍板；将摩尔比为Li∶Co＝1∶1的硝酸锂和硝酸钴以及柠檬酸或聚乙烯醇溶于蒸馏水中，制成为0.005－0.5mol/L的溶液；将多孔金属镍板或氧化镍板浸入溶液中，在真空度低于200毫巴下保持10－60分钟；置于75℃的烘箱中烘干，转移至预热到650℃坩埚电炉中保温1－10小时；将此过程重复一次或多次即可。

The restoring Casimir force, which is the force that changes from repulsion to attraction with the increasing slab separation, may be found to exist between perfectly conducting material and metamaterial slabs. This restoring force is a natural power for the system oscillation in vacuum and also can be used for system stabilization

而若将其中一个材料板取为理想导体板，Casimir效应则可表现为随板间距的增大从排斥力转变为吸引力即平衡回复力，这种力可用来产生板间振荡或稳定真空中的力学系统。

Methods A retrospective analysis of paranasal coronal computedtomography scans of 200 sides from 100 patients were performed. The junction point between vertical line of orbital plate and anterior cranial fossa, the angle from the line between the above point and attachment point of cribriform plate to horizontal line, the distance from vertical line of orbital plate to attachment point of cribriform plate, were measure respectively.

回顾性分析100例患者200侧的鼻窦CT，在冠状位上测量眶板垂直切线与前颅底交点，此点与中鼻甲骨质筛板附着点的连线与水平线的夹角、眶板垂直切线与中鼻甲骨质筛板附着点之间的水平距离。

Regulation by the side of the block-pressed support, so that the supporting block to maintain good contact with the workpiece: by regulating the extension units in the handle, change or reduce the concentration of cutting lathe and extension units in the large gap between the extension units: in order to break them down.

可通过调节上侧支承块的压紧力，使支承块与工件保持良好接触：通过调节中拖板手柄，改变切削浓度或减少车床大拖板和中拖板间的间隙：从而加以消除。

The apparatus for assembling a door and a main body in a microwave oven includes a hinge plate mounted in a main body of a microwave oven, a hinge shaft mounted in a cut-open portion of a choke cover fixed to a door, for being rotatably fixed to the hinge plate, and a detachment prevention portion elastically deformed to allow the hinge plate to be fixed to the hinge shaft and restored to the original state if the hinge plate is completed to be fixed to the hinge shaft to prevent the hinge plate from being detached from the hinge shaft.

包括一个安装在微波炉主体上的铰链板，一个安装在阻波盖的切开部分的铰链轴，其阻波盖固定在门上，该铰链轴可旋转地固定在铰链板上，和一个可拆防护件，它可进行弹性变形以允许将铰链板固定在铰链轴上并且在铰链板完全被固定在铰链轴上后，恢复到原始状态，以防止铰链板从铰链轴中脱开。

A relational expression between column plate number and peak plate number was deduced.

在计算色谱柱塔板数时，应区分色谱柱塔板数和色谱峰塔板数(是由实际色谱峰形得到的，在色谱过程中实际发生的)，因色谱柱塔板数与色谱峰塔板数是不同的概念。

The chain conveyor uses models the steel link joint or the stainless steel link joint connection manufactures, thus may achieve certain lengths according to the request the transportation, in the rack installs loses/the curve nylon guide rail straight, causes the link joint when the transportation maintains parallel, steady.

链板输送机采用塑钢链板或不锈钢链板连接而制作，从而可根据要求达到若干长度的输送，机架中安装直输/转弯尼龙导轨，使链板在输送时保持平行，平稳。

Uses models the steel link joint or the stainless steel link joint connection manufactures, thus may achieve certain lengths according to the request the transportation, in the rack installs loses/the curve nylon guide rail straight, causes the link joint when the transportation maintains parallel, steady.

链板输送机采用塑钢链板或不锈钢链板连接而制作，从而可根据要求达到若干长度的输送，机架中安装直输/转弯尼龙导轨，使链板在输送时保持平行，平稳。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐