中板

To the problem of the head down bending of plate, the influence laws of process parameters, such as the thickness of piece, rolling temperature, ratio of upper and lower roll rotate speed and reduction, on the head -bending direction and degree are found out by test and artificial neural network analysis.

针对中厚板轧制中头部弯曲问题，通过试验模拟及人工神经网络分析，找出了轧件厚度、轧制温度、上下辊速比、变形率等生产因素与钢板头部弯曲方向和弯曲程度的关系，从而可有效地控制钢板头部弯曲。

Abundant of VST, CPT, DMT tests data and the finite element analysis result are applied to get the distribution and increasing rule of strength of silt in consolidation process. The relation between the strength and depth is linear before and after consolidation. The strength-increasing rates are different in different horizontal places.

通过大量的十字板剪切试验、静力触探试验和扁铲侧胀试验，并结合有限元分析结果，研究了淤泥抗剪强度的分布规律和排水固结过程中抗剪强度的增长规律，发现排水固结前后淤泥路基强度基本随深度增加线性增长，排水固结过程中水平方向的抗剪强度增长速度不同。

The shielded rectangular cross section slab line with cylindrical inner conductors is of great importance to microwave engineering and design.

在具有圆柱内导体的叉指滤波器和梳状滤波器工程设计中，对屏蔽矩形板线特性阻抗的计算至关重要，只有通过计算，才能确定滤波器中各导体的自电容和耦合电容值。

With many-year working experience in bridge construction,it discusses the control method of the extending degree of prestressed steel strand in prestressed construction of bridge beam slab with post-tensioning method,which is a reference for similar projects.

根据多年来桥梁梁体施工的实践经验，针对高强钢绞线在桥梁工程结构中的应用，就桥梁梁板工程预应力后张法施工中预应力钢绞线伸长量的控制技术进行探讨，以供类似工程参考。

The three-dimension solid and finite element model of the greatness pulsation bag style dust catcher structure,including middle case ,sieve pore,lower column,beam and ash bucket was built based general finite analytic software ANSYS.

基于有限元软件ANSYS建立了包括中箱体、花板、下立柱、横梁和灰斗等在内的某大型袋式除尘器结构的三维有限元模型，对除尘器结构强度进行了热力场仿真计算，给出了中箱体和灰斗的应力、应变等云图。

In order to reduce the plate loss of side and end cutting, to increase the finishing product rate, the test research of the plan view control of the MAS(Mizushima automatic plan view pattern control system) method was completed.

为减少轧制中钢板的切边、切头尾量，提高钢板的成材率，利用厚板展宽轧制法对轧制过程中钢板的平面形状控制进行了试验研究。

These inferior shaving board, which Miduban low intensity, plate grip screws to poor easy scraping, coupled with disorderly stack in the production chain, resulting boards face bending deformation is also reflected in focus.

其中劣质刨花板、中密度板强度低，板材握螺钉力差，容易离层，加之在生产环节中无序码放，造成板面弯曲变形也是反映的重点。

Form board pole setting Fang Mu by the fact that superheavy basement roof form board props up system's to in the project bears the weight of the checking calculation being in progress strenuously , the form board construction scheme satisfies call for in reaching this project.

表板极设置方牧的是，超重地下室屋顶形式局道具系统的项目中承担的重量验算正在进展中发奋的形式局施工方案符合要求达成这一项目。

To deal with the deficiency of the self-learn method of heat transfer coefficient during plate laminar cooling process,a BP neural network was put forward to improve the self adapting system.

针对中厚板在轧后层流冷却过程中采用传统自学习方法修正计算对流换热系数存在的不足，提出利用BP神经网络对自适应系统进行改进。

Three new types vibrating screens with high screening efficiency were proposed based on the principle of screening process with constant bed thickness.

更多可行性进行了分析，大型振动筛设计中，在香蕉筛基础上，采用了由管群通过跨中的静定板与两根激振器梁的耦联构成的超静定网梁结构。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。