中将

Happy endings never interested me, she wails on Swallow the Nights.

专辑中将她的性格完完全全的展现在听众面前。

He liked social democracy, thought it a good promoter of liberty, urged on its expansion of higher education, but found that this too weltered in bureaucracy in the end.

他喜欢社会民主，认为它是促进自由的良好助推器，因而力主在高等教育中将它发扬光大，但又悲哀地发现这终究难免陷入衙门味十足的混乱。

And he wrestled the great god Zeus himself to a draw.

并在摔跤中将他父亲伟大的神宙斯打败。

The use of these sensors is discussed in the following switching configurations.

在以下的切换配置中将讨论这些传感器的使用。

In the conclusion, we will change the latitude, oblique angle of sun board and number of days of the formulas to observe the variation of radiation quantity, absorption ratio, current, voltage, resistance and power, and the compare of the three calculation modes.

在结论中将利用程式可改变纬度、太阳板倾斜角和天数来观察辐射量、吸收比、电流、电压、电阻和功率的的变化、三种模式算法之相互比较。

If this loan had called for the accrued interest to be paid on the last day of each month, SW's balance sheets would include no liability for accrued interest payable.

如果该项贷款要求在每月的最后一天支付利息，太阳风公司的资产负债表中将不包括应计利息的负债。

It is produced by passing a paper web through a sulfuric acid bath that fuses its fibers into a homogeneous mass.

中义一种抗油纸，在生产过程中将纸浸到硫酸池中使纤维融为一体，增加强度。

Therefore, the investigate will combine the fuzzy logic theory and the approach of the sliding mode control to design three fuzzy-hierarchical controllers for the inverted pendulum-cart system with the nonlinearity friction and the limitations on the control action,, and the rail length,. Furthermore, it also adopts the adaptive mechanism to enter into three controllers above to design three adaptive-fuzzy-hierarchical controllers.

因此，研究中将在轨道长度与控制命令受限制之情况下，利用模糊逻辑控制理论结合顺滑模式控制之方式，针对具有非线性摩擦力之360°倒单摆-滑车系统设计出三组模糊阶层化倒单摆-滑车控制系统；最后又引入适应性学习机制针对输出模糊集合单值参数进行设计，另外建立出三组适应性模糊阶层化倒单摆-滑车控制系统。

Compared to nearest neighbor , it shows better effects of the correct association rate and association time.

它以一个目标为中心的近似聚为构造关联事件的起点，并在计算中将DC 和AC 结合得到的一种全邻的点迹2航迹关联算法，在杂波下目标密集、航迹复杂的数据融合系统中进行实验，对关联正确率、关联时耗等与最近邻法进行了比较，效果较好。

In this paper Ⅰ successfully applied these methods to fault diagnosis, and presenting some new innovative machinery fault diagnosis method; First Ⅰ present a new gear wornout fault diagnosis method, this method use the vibration signal's time-frequency attribute and instantaneous phase undulation to accurately detect gear's fault, and by comparing with the traditional frequency domain analysis method, this method reveals that many nonlinear and nonstationary characteristic exist in gear's vibration, this tell us that if we use frequency domain analysis method without pay attention to the signal's characteristic, we could get wrong diagnostic result; Then Ⅰ present a new bearing fault diagnosis method, this method use ATVFD and Hilbert transform to do envelop demodulation,Ⅰ analyze the envelop with time-frequency method and find out that this method is more accurate then traditional method.Ⅰ also explain that the modulation of the fault to the carrier wave may also be non-stationary and nonlinear; Finally Ⅰ present a cylinder pressure measurement method of diesel engine by means of vibration, cylinder pressure is an important parameter of diesel engine fault diagnosis, the pressure measuring is simplified a lot by this method,Ⅰ also use the ATVFD and time-frequency analysis to realize it.

本文中将上述理论方法成功地应用到故障诊断中去，提出了几点创新性的诊断方法；提出了一种齿轮磨损故障诊断的新方法，该方法利用振动信号能量的时频域分布特征与瞬时相位波动特征可以进行精确的齿轮故障诊断，并通过与传统的频域诊断方法的比较，揭示出齿轮振动中存在的明显的非线性与非平稳特征，说明了不加选择地利用频域分析方法进行齿轮故障诊断很可能会得到错误的诊断结果；提出了一种轴承故障诊断的新方法，该方法利用ATVFD分解与Hilbert变换进行包络解调，并对解调得到的包络信号进行时频域分析，可以实现更加准确轴承故障诊断，说明了故障对载波信号的调制往往也是非平稳与非线性的；提出了一种利用振动信号进行柴油机汽缸内压力检测的新方法，柴油机汽缸压力的变化是柴油机故障诊断的重要参数，利用振动方法可大大简化汽缸压力的检测过程，该方法也是综合利用ATVFD分解与时频域分析方法实现的。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。