丙烯酸的

Then the optimal conditions were decided as follows: the ratio of wall-material to core-material should be 8.0 to 2.0, with ployacrylic sodium as dispersing emulsifier, NH4Cl as acid catalyst, and with the time of pouring catalyst being 2 h, the pH value at end point 2.0, the temperature of condensation reaction under control about 70℃, the reaction time 3 h, the stirring speed 1000 r/min.

研究了壁材与芯材的比例、分散乳化剂、催化剂、反应温度和搅拌速度5因素对微胶囊产品的影响，得出最优化的工艺为：壁材与芯材的比例为m：m=8.0：2.0，以聚丙烯酸钠为分散乳化剂，氯化铵为酸性催化剂，加入速度以2 h加完，终点pH值为2.0，缩聚反应温度控制在70℃左右，反应时间为3 h，搅拌速度为1000 r/min。

It showed that the blend system had much slower Rp than that of hybrid monomer, either of acrylate double bond or propenyl ether double bond, and propenyl ether double bond conversion of hybrid monomer was much higher than that of the blend system at the end.

杂化单体与相同类型的混合体系相比，每种基团的反应动力学性质都得到了促进，丙烯酸酯和丙烯基醚双键的聚合速率都有了很大提高，丙烯基醚双键的转化率较混合体系有很大增加。

Results showed that the hybrid monomer could photopolymerize effectively and both free radical and cationic polymerization processes were improved. When 2-Hydroxy-2-methyl-1-phenyl-1-propanone (1173) was introduced into hybrid system containing UVI-6976, the final conversion of propenyl ether double bond and polymerization rate increased obviously. The comparison of photopolymerization kinetics between hybrid and blend system was investigated as well.

结果表明，以硫鎓盐为光引发剂时，这三种杂化单体均可以有效进行杂化光聚合反应，丙烯基醚和丙烯酸酯双键都显示出较快的反应速度和较高的最终转化率，同时在简单结构的硫鎓盐（UVI-6976）引发体系中加入自由基引发剂2-羟基-2-甲基-1-苯基-1-丙酮（1173）后，丙烯基醚双键的阳离子聚合速率和最终转化率都有了很大提高。

To make the string of hearts, you will need 5 wooden heart cut - outs approximately three inches wide, a drill with an eighth inch bit and a quarter inch bit, a small amount of raffia, two yards of 1 - 1 / 2 inch wide soft ribbon, two large wooden beads, and acrylic paints in the colors you want.

为了使字符串的心，你需要5木心削减-出局大约3英寸宽，演习的第八届英寸位和25英寸位，少量的拉菲草，二码1 - 1 / 2英寸宽软带，两个大木头珠，和丙烯酸涂料中所要的色彩。

Two types of latex particles with similar particle size, similar molecular weight and molecular weight distribution of their constituent polymers labeled by the donor phenanthrene or by the acceptor a polymerizable benzophenone were synthesized by seeded semicontinuous emulsion polymerization.

利用这些乳液粒子，研究了聚甲基丙烯酸丁酯在不同的温度下在其薄膜中的扩散，获得了不同温度时的表观扩散系数以及聚合物扩散的表观活化能。

I have MMA gloves from Canbox.ca, and they make my fists feel like a couple of rocks…and definately not good for your sparring partner's face!

我有甲基丙烯酸甲酯手套从canbox.ca ，他们让我的拳头觉得像一对夫妇的岩石……而且，绝对不是良好的为您掀起合作伙伴的脸！

We use Poly vinyl alcohol, acrylic acid and acrylonitrile as the materials, through the aldolisation of PVA and copolymerization of AA and AN, we prepared the composite membrane with balance theory of hydrophilic and hydrophobic water.

本文以聚乙烯醇和丙烯酸、丙烯腈为主要原料，通过PVA缩醛中醛的选择及膜制备方法的选择，根据亲憎水平衡理论设计出PVA缩甲醛膜上下两层包覆AA和AN共聚膜的复合膜，用此膜进行甲醇／水溶液的渗透汽化分离。

During the low temperature plasma polymerization, different factors (reaction power, pulse duty factor, reaction time, bias voltage and pressure) were investigated to get the best film. The results of X-ray photoelectron spectroscopy and Fourier transformed infrared spectoscopy implied that polymer nano-film containing carboxyl or amido were deposited successfully by using allylamine or acrylic acid as a reagent, respectively.

低温等离子聚合过程中，研究了反应的功率、脉冲占空比、反应时间、偏压、反应室压强这五个因素对薄膜性质的影响，确定了最佳的工艺参数。X光电子能谱和傅立叶转换红外光谱分析结果表明，以丙烯胺和丙烯酸为反应物可以在样品表面分别得到含有羧基或氨基的有机薄膜。

The influence of microwave radiation on Ullmann reaction has been investigated by three Ullmann reactions, including triphenylamine formed by treating the diphenylamine with bromobenzene or Chlorobenzene which substitutes Iodobenzene; 4,4\'-dimethyltriphenylamine formed by treating 4,4\'-dimethyldiphenylamine with bromobenzene which substitutes Iodobenzene; 4,4\',4-trinitrotriphenylamine formed by treating 4-chloronitrobenzene with p-nitroaniline in this paper.

实验表明，在微波辐射条件下，顺式比反式迈克尔反应活性高；若在丁烯二酸的双键上引入甲基后，降低了进行迈克尔加成反应的活性；引入酯基对双键的影响比腈基有利于进行迈克尔反应，丙烯酸甲酯较丙烯腈的迈克尔反应活性高。

This paper made a research in comparing the influence of the resin classes and their consumpted quantity,the filler classes and their consumpted quantity and the solidification agent classes and their consumpted quantity on the sanded fuction of polishing putty ,and found an ideal technics condition.

利用丙烯酸树脂、无机填料、固化剂等特性，研究了它们的类型和用量对抛光腻子打磨性能的影响，确定了它们的类型和用量以及理想的工艺条件。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新