丙烯酸树脂

The results are listed as following :㏕he best anti-erosion proportion of resin present is 25wt% in the condition of silicon carbide reinforced SMCC, while the alumina reinforced SMCC is 40wt%.(2) The better anti-erosion results was achieved with the ratio of silicone resin to acrylic resin containing hydroxy being 3: 1.㏕he composites coating tends to be more brittle when added in alundum particles. It also means that the maximum erosion peak of alundum reinforced SMCC tends to normal angle.甌he change of erosion rate of SMCC can be divided into two stages with the increment erodent velocity: the slow erosion stage of the beginning and the stable erosion stage.

首次发现：①SiC增强的复合涂料涂层，树脂含量为25wt％时，具有最佳耐冲蚀性能：Al_2O_3增强的复合涂料涂层，树脂含量为40wt％时，具有最佳耐冲蚀性能；②SiC增强的涂料，有机硅树脂与丙烯酸树脂的比例为3：1时的耐冲蚀性能好于1：1的复合涂料涂层；③Al_2O_3增强体使涂层变脆的倾向大于以SiC为增强体的涂层，即SiC增强的复合涂料涂层的最大冲蚀率出现在30°，Al_2O_3增强的复合涂料涂层的最大冲蚀率出现在75°～90°之间；④低速冲蚀磨损机理主要是弹性变形与疲劳；高速冲蚀磨损机理主要是显微切削和显微犁耕。

The effect of the amount of organfluorine on the rate of water absorption as well as water contact angle of latex film was also studied.

通过热分解引发体系，用有机氟单体对丙烯酸树脂进行改性，合成了性能优异的氟改性丙烯酸乳液，并研究了有机氟单体对乳胶膜吸水率及对水的接触角的影响。

But it is very difficult to have good mechanics function and antifouling capability if we use organic polymer resin simply.

因此本文通过有机硅单体与丙烯酸酯类单体进行共聚制得具有低表面能特性的有机硅改性丙烯酸树脂。

The effect of the content of dimethylaminoethyl methacrylate on the properties of the electrophoretic paint was studied.

研究了甲基丙烯酸二甲胺乙酯用量对改性丙烯酸树脂水分散体和漆膜性能的影响规律。

Acrylic Resins are derived from methacrylic acid, acrylic acid or other related compounds, these substances are related to thermosetting plastic or thermoplastic.

丙烯酸树脂是来自甲基丙烯酸，丙烯酸或其他相关的化合物，这些物质都与热固性或热塑性塑料。

Specifically, it is applicable to the production of dissolvent type of coating materials such as formaldehyde phenol resin, alkide resin, epoxy resin, epoxy polyester and acrylic resin as well as water-soluble resin coating materials such as highly adaptable water-soluble epoxy ester dipping paint.

适用于酚醛树脂、醇酸树脂、环氧树脂、环氧聚酯以及丙烯酸树脂等溶剂型涂料以及各种水溶性树脂涂料（如：高适应性水性环氧酯浸涂漆等）；还可应用于厚浆型涂料、粉末涂料、有机钛防腐蚀涂料、带锈涂料和沥清漆、富锌底漆、防火涂料、耐热涂料等。

An acrylic resin was synthesized by the radical copolymerization with methyl methacrylate, butyl acrylate and methacrylic acid monomers in solution using benzoperoxide as initiator. Appropriate parameters of monomer ratio, monomer concentration, solvent, and reaction temperature were found by experiment.

以过氧化二苯甲酰为引发剂，采用溶液聚合合成了甲基丙烯酸甲酯-丙烯酸丁酯-甲基丙烯酸树脂，通过实验确定了自由基共聚合适宜的单体配比、单体浓度、引发剂浓度、溶剂以及反应的升温速度。

The coated gloss right from the start of the resin natural resins, to nitrocellulose, styryl, chloroethylene, polyamic, sour, polyurethane, acrylic resin, a wide variety of resin application ever.

涂布光油所用的树脂从一开始的天然树脂，到硝化棉、苯乙烯、氯乙烯、聚酰胺、酸、聚氨酯、丙烯酸树脂等，各种各样的树脂都得到了应用。

The mixture of amino resin and acrylic resin has been selected based on the comparison of the charring layer characteristics from different resin systems.

通过比较不同树脂体系形成炭化层的优劣，确定选用氨基树脂和丙烯酸树脂共混体系作防火涂料的基料。

The basic concepts of coatings function, composition, classification. Various coatings: drying oil, rosin and lacquer, alkyd resin and polyester coating, amino resin coating, acrylic acid resin coating, epoxy resin coating, polyurethane coating, elementary organic resin coating. Several new coatings: high solid-constituent coating, water soluble coating, powder coating, light-sensitive coating, anti-corrosion coating, flame-retarded coating, anti-contamination coating, color changing coating, conductive coating and magnetic coating, aeroplane and aerospace dope.

涂料的基本概念：涂料的功能、基本组成、分类；各种涂料的制造及应用：干性油、松香与大漆，醇酸树脂与聚酯涂料，氨基树脂涂料，丙烯酸树脂涂料，环氧树脂涂料，聚氨酯涂料，元素有机树脂涂料；几种新型涂料简介：高固体分涂料，水性涂料，粉末涂料，光敏涂料，防腐蚀涂料，防火涂料，防污涂料，变色涂料，导电涂料和磁性涂料，航空航天特种涂料。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。