丙烯酸

Xvii 6 and 12 volt armatures shall not be interchanged.

6v和12v的电枢不可以丙烯酸乳液。

To solve defects of high luster and bad appearance of matt acrylic coatings, a new process was adopted with addition of delustrant and leveler as auxiliary agents, and control of operating viscosity.

为解决无光丙烯酸漆涂装漆膜光泽偏高、表观效果差的弊病，采用新的涂装工艺，加入消光剂、流平剂等涂料助剂，控制施工粘度，所得漆膜光泽度低、表观效果好。

Objective:To investigate the dynamic changes of immune function indexes of erythrocyte in the dialysis process of patients subject to blood dialysis, and to study the contribution of dialysers with different biocompatibilities to the changes.

目的：了解血液透析病人透析过程中红细胞免疫功能指标的动态改变及不同生物相容性的透析膜对其变化的影响。方法：分别采用铜仿膜、聚砜膜、聚甲基丙烯酸甲酯膜，观察了透析过程中不同时相的红细胞免疫功能指标RBC－C3b和RBC－IC的变化。

The effects of curing property of coatings such as diff-erent kinds of photoinitiator,diluents and additives were discussed.

不同光引发剂、稀释剂和助剂等对UV固化环氧丙烯酸酯涂料固化性能均有影响。

An indium phthalocyanine dye dopped PMMA and PC thin film were obtained by a optical glass modul, which maybe used as a laser protective dye.

对一种可望应用于694 nm激光防护的铟酞菁染料，利用玻璃模具制备了铟酞菁掺杂高分子聚甲基丙烯酸甲酯和聚碳酸酯薄膜。

The preparation of 5 tri compound driers and their properties in alkyd varnish are introduced.

介绍了碳酸二甲酯在热塑性丙烯酸清漆、硝基清漆、醇酸清漆和聚氨酯清漆中的应用。

The thermo electrets of PMMA with surface potentials between about 50 and 〓 were fabricated.

采用热电极化的方法制得驻极电压在50～〓V正负电位的圆片状驻极体型聚合物聚甲基丙烯酸甲酯。

The recent studies on the preparation methods of PDA composite emulsions have been summarized and compared in this review.

本文综述了水性聚氨酯／丙烯酸酯复合乳液主要合成方法的研究状况，并对各种方法进行比较。

The adhesives and sealants commonly packaged in cartridges are epoxies, polyurethanes, acrylics, polyesters, and silicones.

AB胶筒常见包装的胶水和密封剂有：环氧树脂，聚氨酯，丙烯酸，涤纶和硅树脂。

Especially for the of concrete frame structure building and steel frame structure building without traditional brittle filler wall, using steel-mesh-cement-mortar plastering as inter insulating layer connected with the main structure to forming flexible composite wall can meet the requirement of saving 65% of energy for wall in the cold region and ensure the safety of the device installed on the opening to shield sunshine and facilitate its installation.

聚酯薄膜和聚丙烯酸酯乳液都是耐久性非常好的材料，可达到40年有效防腐期，有希望达到50年的有效防腐期，远远高于现在的钢材防腐蚀涂层十几年的寿命，在粘接强度满足使用要求条件下，及提高混凝土构件的柔性，对社会的可持续发展具有重要意义。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。