丙烯酸

With the increase in CO(NH2)2 concentration,the molecular weight significantly increased,and the best concentration scope of DMAEMA was 0.06%-0.10%.Inaddition,the agents for preventing cross-linking were used to prevent the cross-linking reaction and it content was not allowed too high,and the best concentration scope of sodium acetate(the regulator of molecula weight)was

在此中和度下，AMPS的适宜用量范围为AM的75%～16.25%；AA的适宜用量范围44%～55%；(NH4)2S2O8的适宜用量范围为AM/AA/AMPS总量的0.07%～0.12%；分子量随CO(NH2)2的增加而明显升高；甲基丙烯酸N，N-二甲氨基乙酯的适宜用量范围为0.06 %～0.10%；使用抗交联剂可以解决产品交联造成的难溶问题，但加入量不宜过多，否则分子量会下降；分子量调节剂醋酸钠的用量在1.24 %～1.54%范围内可以使产品的分子量达最佳值。

Under Multislice helical CT guidance, 2.5-5 mL of polymethylmethacrylate mixture （ratio of polymer, moner, ultrafluid iodinated oil was 20 g : 10 mL : 3 mL） had been injected into pathologic pedicles step by step after successful puncture using 13G needle.

在CT引导下，用13G针穿刺到椎弓根，将聚甲基丙烯酸甲酯粉剂、液态单体及超液态碘化油按20g：10mL：3mL的比例配制，当骨水泥呈膏状时，分步注入骨水泥约2.5～5mL。

Business card printing and membership card making Ink viscosity in business card printing and membership card making faster, rollers and plates after the ink friction heats gets smaller, on the rising of the ambient temperature, the viscosity of ink will drift away, this time using the innovativeink, with the temperature increase, decrease viscosity is referred to as a viscosity index of added value, that is, the viscosity index is a viscosity index of temperature-dependent, for example, at a low temperature solvent oil sludge formation, if you join methylmetacrylate and transfromer monosomic of multi-fault copolymer exclude this.

制卡和会员卡制作油墨的粘度在随制卡和会员卡制作速度的加快时，因墨辊与印版摩擦后油墨温度升高而变小外，当环境温度的上升后，油墨的粘度也会逐渐变小，这种在使用油墨时，随着温度的上升，其粘度下降的行为被称为粘度指数增加值，即粘度指数是表示粘度随温度变化的指标，例如，溶剂油在低温下形成淤浆时，如果加入甲基丙烯酸酯和极性单体的共聚物排除此类故障的发生。

Then, the multidentate amine immobilized on silica gel was used as ligand for CuCl in ATRA of CCl_4 with MMA and methyl trichloroacetate with St repeatly. The conversion and purity of the product were determined through the gas chromatography and ~1H NMR respectively. Finally, the multidentate amine immobilized on silica gel was used as ligand for CuCl in ATRP of St initiated by TCPP and MMA initiated by MMTCB. The number average molecular weights of the polymers were determined through GPC.

此多齿胺改性硅胶配体被分别多次重复用于四氯化碳与甲基丙烯酸甲酯，三氯乙酸甲酯与苯乙烯的ATRA反应中，通过气相色谱测定了原料的转化率随时间的变化，且通过核磁~1H NMR测定了产物的纯度，我们还进一步将此种多齿胺改性硅胶配体用于TCPP引发St的ATRP和MMTCB引发MMA的ATRP反应中，通过GPC测定所得聚合物的分子量。

Employing HP-8-8 polyacrylic resins as a porous multimolecular carrier for fixed cultivation of sludge,experimental investigation of wastewater treating was carried out by means of fluidization with biofilm sequencing batch reactor.

采用HP88型聚丙烯酸酯类多孔高分子载体对污泥实行固定化培养，以流态化方式进行生物膜SBR 废水处理试验研究。

Synthesized polymerizable photosensitive monomer diazo naphthoquinone sulfonate hydroxyethyl methacrylate ether was characterized by infrared spectroscopy and 1H NMR.

田丰，于媛媛，汪长春*摘要：利用红外光谱和核磁共振(1H NMR)对所制备的光敏可聚合单体重氮萘醌苯磺酸甲基丙烯酸羟乙酯进行了表征。

The results indicate that the imprinted polymers synthesized by methacrylic acid as functional monomer exhibite the best regioselectivity, yielding up to 49.6% pare and 44.1% ortho isomer of nitrotoluene.

结果显示分子印迹聚合物提高了甲苯的对位选择性硝化能力，并且以甲基丙烯酸为功能单体的分子印迹聚合物的对位选择性最好，邻对比为0.89。

The possible mechanism was discussed. These bowl-shaped aggregates are promising candidates for nano reactor or drug carrier.4 2,7-dimethylene-1,4,6-trioxaspiro[4, 4]nonane with two vinyls was prepared to be used as electron-donor and crosslinker. The ATRP of this crosslinker and excess methylacrylate (used as electron-accpetor) was proved to mainly form homopolymers. With the chain-transfer agent S-1-Dodecyl-S\'-(α,α\'-dimethyl-α-acetic acid)trithiocarbonate, the copolymerization of the spiro hydrocarbon, maleic anhydride and MA by RAFT method produced star PMA.

这些由聚电解质复合物自组装形成的聚集体，在微反应器和药物释放等领域具有潜在的应用前景。4合成了双乙烯基的2，7-二亚甲基-1，4，6-三氧杂螺环烷，作为给电子单体和交联剂，与吸电子单体马来酸酐或过量的丙烯酸甲酯形成电荷转移络合物共同聚合，尝试了用ATRP和RAFT方法一步法合成星形聚合物。

DSC determination of PSA hydrogel revealed that content of the noncrystallizable water was 2. 13g/g dry resin.

对水凝胶的DSC测试得出聚丙烯酸钠水凝胶中每克干树脂中含2.13克非冻结水。

Most of the substances in the deposit were the nonsticky calcium carbonate and fines that could adhere to the sticky contaminants and deposit together, resulting in a great deal of the deposit.

对福建南平纸厂网前压力筛处的胶粘物进行分离和分析发现，以聚醋酸乙烯酯和聚丙烯酸酯为代表的人工合成聚合物以及机械浆中的木材树脂是产生胶粘物的根本来源，但它们在胶粘物沉积中的含量只有5%左右。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。