丙烯酸

In order to enhance the compatibility of ABS/PP/CaCO3 composites, the effects of reactive blends of the composites were studied by using Haake rheometer. The effects of various assistant cross-linkingers, such as castor oil, triallyl isocyanurate, turpentine (JS-1) and glycol dimethacrylate, and the used amount of cross-linkinger-dicumyl peroxide on the torques of the melting composites were investigated.

为提高ABS/PP/CaCO3复合材料相容性，采用转矩流变仪观察了ABS/PP/CaCO3三元复合物反应性共混后的扭矩，考察了不同的助交联剂蓖麻油、异氰脲酸三烯丙酯、松香酯(JS-1)、二甲基丙烯酸乙二醇酯以及交联剂过氧化二异丙苯的用量对共混物的影响。

Polyethylene glycol monomethylether, isophorone diisocyanate and hydroxyl ethyl methacrylate were used as raw materials, the mixmonomer was synthesized.

采用聚乙二醇单甲醚、异氟尔酮二异氰酸酯和甲基丙烯酸β-羟乙酯合成混合单体。

The ATRPof MMA and MA were carried out in DMF and catalyzed by 〓/isophthalic acid at 90℃for 24 hours.

而在同样的聚合条件下，得到的聚丙烯酸甲酯的最大数均分子量只有234216。

Acrylic acid was isothermally polymerized by precipitation polymerization in toluene at various monomer and initiator concentrations over the temperature range of 40C–50C.

丙烯酸是恒温聚合的沉淀聚合在甲苯在不同的单体和引发剂浓度，温度范围-40 ℃， 50欧分。

A series of experiments on Bayer red mud generated from Chinese diaspore bauxite were performed using experimentally-synthesized new flocculants ASAM (obtained from acryamide, sodium acrylate and β-methylhydrogen itaconate) and commercial flocculants PAS-3, 0228 and Alclar665, respectively.

摘 要：针对河南某一水硬铝石型氧化铝拜耳法溶出赤泥，采用自制丙烯酰胺-丙烯酸钠-β-衣康酸单甲酯共聚物新型絮凝剂对其进行沉降实验。

The synthetic process and the scale inhibition function of the copolymer of itaconic acid-acrylic acid to synthetic water containing CaCO3 have been studied.

作者研究了衣康酸—丙烯酸二元共聚物水溶液的合成工艺及对合成水碳酸钙的阻垢效果。

The itaconic acid carboxylated ACM has better cure characteristics and mechanical properties than the acrylic acid carboxylated ACM.

以衣康酸为交联单体的ACM的硫化特性和机械性能好于以丙烯酸为交联单体的ACM。

Liu Yakang Lu Jianmin He Jianyun Jin Guantai College of Materials Science and Engineering, Beijing University of Chemical Technology, Beijing, 100029

引言 环氧基型丙烯酸粉末涂料，通常所采用的固化剂主要有：壬二酸、癸二酸、十二二酸及二十二酸等［1］。

The first synthetic route uses 1,2,4-trimethoxybenzene and chloroacetonitrile in forming 2,4,5-trimethoxy-a-chlor-acetophenone under the anhydrous condition, then the intermediate condensates with papaverine forming the core pyrro[2,l-a]isoquinoline, followed by formation and lactonization to form the lactone ring. The second synthetic route uses prepared aldehyde with prepared ethyl nitroacetate by Knoevenagel condensation to obtain 2-Nitro-3-(2,4,5-tris-methoxy-phenyl)-acrylic acid ethyl ester and 2-Nitro-3-(2,4,5-tris-benzyloxy -phenyl)-acrylic acid ethyl ester etal intermediates. The lamellarin skeleton could arise from condensation of the papaverine and these intermediates by Michael reaction, the ester group is provided for subsequent lactonization. The third synthetic route uses coumarin or indan-l,3-dione derivatives and papaverine to form lamellarin under basic conditions.

第一条路线首先从1，2，4-三甲氧基苯出发与卤乙腈作用合成卤代芳酮中间体，然后与罂粟碱反应合成开链片螺素，最后经乙酰化、去保护、成内酯环得到片螺素；第二条路线由制备的芳醛和制备的硝基乙酸乙酯经缩合得到2-硝基-3-芳基丙烯酸乙酯，然后由该中间体与罂粟碱反应，在完成关环的同时也引入酯基，最后去保护、成内酯环得到片螺素；第三条路线是由香豆素或茚二酮出发，经溴代后的中间体与罂粟碱反应，得到片螺素的基本框架。

Pure inorganic ladderlike polyhydrosilsequioxane was prepared by the way of subsection hydrolysis.

第二部分超常价态过渡金属Ni引发接枝聚合的研究本论文第四章主要研究了利用二过碘酸合镍Ni为引发剂于碱性条件下在纤维素上接枝丙烯酸甲酯，接枝以后的共聚物显示了很好的热稳定性和抗潮性。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。